22 L kerosene tank is filled with 2 cm diameter hose equipped with a 1.5 cm nozzle meter If it takes 20 s to fill the tank, determine the pressure differnce indicated by the nozzle if Cd= 0.96. The specific gravity of kerosene is 0.82. CH

Q: Q1/ For fig shown if water flow rate is 60 lit/s , Find (h) Note that Density: Pwater = 1 kg/m³ Pair…

A:

Q: A closed vessel contains water up to a height of 2 m and over the water surface there is air having…

A:

Q: Q5. A pipe of diameter 20 cm and length 2000 m connects two reservoirs, having difference of water…

A:

Q: Determine the available suction head of a pump that is taking gasoline at 204 deg. C, from a closed…

A: We have given, Determine the available suction head of a pump that is taking gasoline at 204 deg. C,…

Q: m3 and 1000 kg/m³, respectively. The pressure difference between pipes A and Bis kPa.

A: Given data, Specific gravity of oil (Soil) =0.8ρoil=0.8×1000=800 kg/m3Density of air (ρair)=1.16…

Q: d) The pressure of water flowing through a pipe is measured by the anangement shown below. For the…

A:

Q: The water level in a tank is 34 ft above the ground. A hose is connected to the bottom of the tank…

A: Govind

Q: Given a system as shown in the following figure. Calculate the water level difference between two…

A:

Q: 1. Compute the pressure @ point n ( Pn ) as shown by the differential manometer in KPa if pressure @…

A:

Q: The velocity of a fluid flowing in a pipe is to be measured by two different Pitot-type mercury…

A: we have to evaluate which pitot tube will be more accurate

Q: A 1.5 m high tank is filled with water. A hole is punched at the side of the tank 0.25 m from the…

A: Given   Total height, H = 1.5 m   Hole height, h = 0.25 m           Gravity, g = 9.81 m/s2 Find…

Q: ) In a 80 mm diameter pipeline an oil of specific gravity 0-8 is flowing at the rate of O-0125…

A:

Q: A pipe with unequal ends is used to transport a fluid. The pipe diameter at the larger end is 0.81…

A:

Q: A 22 L kerosene tank is filled with 2 cm diameter hose equipped with a 1.5 cm nozzle meter If it…

A:

Q: A pump is to deliver 80 GPM of water at a density of 61. 83lb/ft3 with a discharge pressure of 150…

A:

Q: Question 4.12 A venturi meter with throat diameter of 100 mm is fitted in a vertical pipeline of 200…

A: Given:d=100 mm =0.1 mD=200 mm =0.2 ms=0.88Q=0.06 m3/s∆z=320 mm =0.32 m NOTE: According to…

Q: 4. Given system, find the pressure difference betweenm and n in head of water and KPa. Figure WATER…

A:

Q: An orifice having an area of 0.0003 m² is located on the vertical side of a tank. The tank has a…

A: Write the given data with suitable variables. Ao=0.0003 m2At=0.4 m2h=1.2 mh1=0.6 mt1=312 st2=240 s

Q: An orifice of 2.58 cm diameter is placed in a pipe of 5.1 cm diameter. The pipe delivers oil of…

A:

Q: If the velocity varies linearly with distance through this water nozzle, what is the pressure…

A: Let velocity equation is  V=C1+C2X at x=0 V=30ft/s C1=30 at x=1ft V=80ft/s 80=30+C2(1) C2=50…

Q: 2. Compute the pressure difference between 'm' and 'n' as shown by the differential manometer in KPa…

A:

Q: 2 120 m 100 m 28 m Datum

A: Given Data L1=2000 mL1=2300 mL3=2500 mD1=1 mD2=0.6 mD3=1.20 mf1=0.013f2=0.02f3=0.023…

Q: Q2) Water flowing through a jet with velocity of 45 m,/s. Caleulate the value of (O) to be the water…

A:

Q: n a hole in the side of a tank. -ing 0.2 m, rplug = 0.25 m. O-ring 0.2 m

A: Given: D = 0.25 m y ¯ = 2m

Q: Find the gage pressure in the water pipe shown in fig. Not's: the density of water =1000kg/m', S =…

A: As per given question Find the gage pressure in the water pipe shown in fig.

Q: In the pump test shown, the rate of flow is 0.16 m3/s of oil (S = 0.88) Calculate the horsepower…

A: For solution refer below images.

Q: If the oil (specific gravity 0.91) rises to 0.1 m in a piezometer attached at a point to the…

A:

Q: B4. An orifice meter with orifice area 1039 mm2 is inserted in a pipe of area 2078 mm2 .The pressure…

A:

Q: A liquid (SG = 0.562) is being pumped from a reservoir as shown. The pressures at points 1 and 2 are…

A:

Q: A sluice gate is a device that is fitted in a sluice or  fluid canal to operate and control the…

A:

Q: Water is supplied in a 2-in. dia. pipe at the rate of 2 cfs to a 10-hp, SO-percent efficient pump.…

A: The Answer is below

Q: 4. Using the figure below, find the time it takes for tank 2 to increase water level by 2m. (C =…

A: Given data: Area of tank 1 = π a b = π x 2 x 3 = 6πArea of tank 2 = π4 x 42 = 4πInitial height…

Q: P = Patm 1 V = 7.3 m/ Flow h = 0.96 ft water 2 3 Density of water = 1000 kg/m³ Determine the…

A: P1=Patm=101.325 kPa v1=7.3 msech=.96 ft since 1 ft=.3048 mSo h=.96×.3048h=.2926 mρ=1000 kgm3

Q: For the piping system of Fig. , all pipes are concretewith a roughness of 0.04 in. Neglecting minor…

A: For water at 20°C, take ρ=1.94 slug/ft3 and μ= 2.09E−5 slug/ft⋅s. Since the pipes are all different…

Q: Water is delivered through a horizontal 20-cm-diameter pipe at a flow rate of 0.5 m3/s. If a…

A: Given data:

Q: Along a galvanized iron pipe (ε=0.15 mm) of 30 cm in diameter, pump 60 lps of oil; µ = 0.016 N s/m2…

A: Surface roughness of galvanized iron pipe, ε=0.15 mm=0.15*10-3 mPipe diameter, d=30 cm=0.3 mOil flow…

Q: Water at 20°C flows through the orifice in Fig. ,which is monitored by a mercury manometer. If d = 3…

A: Given Data Area of the pipe, A=πD24=π0.0524 Rate of the discharge, Q=20m3/h  To find out the…

Q: A pitot-static tube is used to measure the velocity of air flowing through a duct. The manometer…

A: A pitot tube is a mechanical device that is used to measure the velocity of flow at any point in the…

Q: It is required to pump water at 100 gal/min from a large reservoir to the surface of another…

A: Water flow rate, Q=100 gal/min=100448.83ft3/s=0.2228 ft3/sElevation difference between the two…

Q: The water level in a tank is 34 ft above the ground. A hose is connected to the bottom of the tank…

A:

Q: 11. Suppose that a gasoline tank is an upright cylinder with a radius of m and a depth of 4m is…

A: Density of a fluid is defined as the mass of the fluid per unit volume. Weight is mass times the…

Q: Flow in- de Given at inlet Given at throat section Given at exhaust To = 340K MT МЕх 3 2.2 AEX =…

A: Given:

Q: A pump is to deliver 80 GPM of water at a density of 61. 83lb/ft3 with a discharge pressure of 150…

A: Given Data Q=80 GPM =80×013368460= 0.1782 ft3/s ω=60.38 lb/ft3 Vs=QA=0.1782π4512=1.304 ft/s…

Q: -6-cm-dia. 12 cm dia. 12 cm Hg

A:

Q: A conical vessel 12m across the top and 15m deep. If it contains water to a depth of 10m, find the…

A: Given data as per the question Total depth of cone =15 m  water depth in cone = 10 m

Q: 4 5 6 Editing 13 14 1S A Sluice gate is a device that is fitted in a sluice or fluid canal to…

A: The above question is based on hydrostatic force acting on a sluice gate.

Q: Q: Find the time required to empty a tank with water height (h=18) 8 ft A 20 ft circular hole

A: Given: Height of the tank (H)=20ftHeight of water (h)=18ftRadius of the tank (R)=8ft

Q: B4. An orifice meter with orifice area 1072 mm2 is inserted in a pipe of area 2144 mm2 .The pressure…

A:

Q: Water flows through a pipe at 15 L/s as shown. If the gage pressure of 12.5 kPa, 11.5 kPa and 10.3…

A: