2] The device shown is used to straighten the frames of wrecked autos. Determine the tension of each segment of the chain, i.e., AB and BC, if the force which the hydraulic cylinder DB exerts on point B is 3.50 kN, as shown. B 3.50 kN 450 mm D 400 mm 250 mm

2] The device shown is used to straighten the frames of wrecked autos. Determine the tension of each segment of the chain, i.e., AB and BC, if the force which the hydraulic cylinder DB exerts on point B is 3.50 kN, as shown. B 3.50 kN 450 mm D 400 mm 250 mm

Inquiry into Physics

8th Edition

ISBN:9781337515863

Author:Ostdiek

Publisher:Ostdiek

Chapter4: Physics Of Matter

Section: Chapter Questions

Problem 1PIP

See similar textbooks

Related questions

Q: Example 2 :- A water pipe tapers from 300mm to 150mm. The pressure at the inlet is 750 kpa. The mean…

A: Given: Water pipe tapers from section di=300 mm=300×10-3 m to section do=150 mm=150×10-3 m Inlet…

Q: The hydraulic car lift of a service station uses a small piston of radius 2.0 cm. If a 500 N force…

A: Given Data Radius of the small piston is r=2.0cm=2.0×1100m=0.02m Radius of the large piston is…

Q: 3. A barrel will rupture when the gauge pressure within it reaches 350 kPa. It is attached to the…

A: A barrel will rupture when the gauge pressure within it reaches 350 kPa. It is attached to the lower…

Q: 1 - 2. A hydraulic press has pistons of area .0060m? and 0.350m² respectively. A force of 25N is…

A: Based on the principal of hydraulic press we have, F1A1 = F2A2 , substituting the values of F1 = 25N…

Q: Q4) If the open cylindrical container as shown in Fig.3 rotates at = 8 rad/s. determine the maximum…

A: Given data:- The given angular velocity, ω=8 rad/s The radius of the cylinder, r=1 m

Q: A drinking fountain shoots water about 12 cm up in the air from a nozzle of diameter 0.60 cm (Fig.…

Q: 7. When floating in freshwater a vessel displaces 4288 tonnes. What is its new displacement when it…

A: when an object enter in to water it displace water as it's mass and volume. so we can find density…

Q: 7. (II) A house at the bottom of a hill is fed by a full tank of water 6.0 m deep and connected to…

A: Given,height of the tank, h = 6.0 mlength of the pipe, l = 75 minclination of the hill, θ = 60°

Q: A large man sits on a four-legged chair with his feet off the floor. The combined mass of the man…

Q: 35. mmh Multiple-Concept Example 8 presents an approach to problems of this kind. The hydraulic oil…

A: a) To determine the input force required to support weight of the car and the output plunger,…

Q: 51. . The blood flow speed through an aorta with a radius of 1.00 cm is 0.265 m/s. If hardening of…

A: The answer is below

Q: A horizontal syringe is used to make an injection into a vein (Fig. 3). The barrel of the syringe…

A: (a)A force applied to the circular piston,

Q: •50 Figure 14-46 shows two sections of an old pipe system that runs through a hill, with distances…

Q: (II) Determine the minimum gauge pressure needed in the water pipe leading into a building if water…

Q: A hydraulic cylinder lifts a car (F2) delivering a force of 15000 N. The diameter of the small…

Q: Q3. As shown in Fig. (3), the length of a cubical material edge "A" is 16 cm; the mass of the liquid…

A: Given Length of the edge (a) = 16 cm Mass of liquid (mC) =1.8 kg Mass of beaker (mB) = 1 kg Reading…

Q: (II) A 6.0-cm-diameter horizontal pipe gradually narrows to 4.5 cm. When water flows through this…

Q: 5. A container of solution for an intravenous drip is open to the atmosphere and supported above the…

Q: <HW4 - CH7 and CH8 Problem 7.46 In order to keep a leaking ship from sinking, it is necessary to…

Q: 1. What is the relation do you find between the weights of the floating body and the weight of water…

A: A floating body is in equilibrium which means that the total upward force (buoyant force) is equal…

Q: Problem 10.50 A 5.5 cm diameter horizontal pipe gradually narrows to 4.1 cm . When water flows…

Q: If the hydraulic system is using for break system in the Cars as shown in the figure A, if the force…

A: Given: Force coming from the foot, F1 = 100N Diameter of first cylinder, d1 = 0.5 cm = 0.005 m…

Q: 3. If a barbers chair weighs 1.34 kN, rests on a large piston with an area of 34.0 cm2 that connects…

A: The weight of the chair is 1.34 kN area of large piston A1 = 34.0cm2 area of the small piston is A2…

Q: Please help me with this, double check your answers previous tutors got it wrong.

A: From the continuity equation for the both end of a pipe,

Q: Example 5.2 Water enters the basement through a pipe 2 cm in radius at an absolute pressure of 3…

A: Given : r1=2cm =0.02m P1=3atm = 3.039 x 105Pa r2=0.5cm=0.005m h1=0m h2=10m P2=1.013 x 105Pa

Q: (III) A patient is to be given a blood transfusion. The blood is to flow through a tube from a…

Q: A cube of unknown material is 0.200 m on each side and has a mass of 17.6 kg. It is suspended in a…

Q: (50%) Problem 2: Suppose the maximum blood pressure for a specific person is 155 mm Hg. P A…

Q: (III) Estimate the diameter of a steel needle that can just barely remain on top of water due to…

Q: 14. A force of 500 N is applied to a hydraulic jack piston that is 1 cm in diameter. If the piston…

Q: 93. As background for this problem, review Conceptual Example 6. Asubmersible pump is put under the…

A: Given: The height of the ground from the pump is 71 m. Introduction: The hydrostatic pressure is…

Q: (II) A house at the bottom of a hill is fed by a full tank of water 6.0 m deep and connected to the…

A: The height of water level of full tank,WL = 6.0 m. Assume the vertical height between the base of…

Q: 3. A dam is used to hold back a river. The dam has a height H = 12 m and a width W = 10 m. Assume…

A: a) As given , density of water at 40C is 1000 kg/m3 Consider a small strip of dam length dy at a…

Q: 2. A barge 120 ft long and 20ft wide weighs 200 tons. What is the depth of sea water required to…

A: 1 ton = 2000 lb The weight of barge of 200 tons, is W=200×2000=400000 lb

Q: Archimedes supposedly was asked to determine whether a crown made for the king consisted of pure…

A: Given :weight of the crown when it is in air = 7.84 Nweight when it was in water=6.84 N

Q: 90. GO An underground pump initially forces water through a horizontal pipe at a flow rate of 740…

Q: (III) A 3.65-kg block of wood (SG=0.50) floats on water. What minimum mass of lead, hung from the…

A: mw=Mass of wood=3.65 kgSGw=Specific gravity of wood=ρwρwa=0.5SGl=Specific gravity of…

Q: (I) Estimate the pressure needed to raise a column of water to the same height as a 46-m-tall pine…

Q: Canal effect. Figure 14-45 shows an anchored barge that ex- tends across a canal by distance d = 30…

Q: Method of work: - Prosegare 1- Weigh the solid body with air (let it be a cylinder of known size) w1…

Q: 7. In a car lift used in a service station, compressed air exerts a force on a small piston of…

Q: Ice cubes float in water because its density is lower than that of water (910 kg/m^3). If you have…

A: Given: The density of the ice is 910 kg/m3. The side of the cube of the ice is 5 cm.

Q: 7. In the determination of the surface tension of a liquid by the ring method, the value of weight…

A: Weight, m = 0.250 gram = 0.00025 kg Circumference, C = 5 cm = 5×10-2 m = 0.05 m Surface tension, T =…

Q: 4. The smaller and larger pistons of a hydraulic press have radii of 0.5 m and 1.00 m, respectively.…

A: Given data: The radius of the smaller hydraulic press is, r1=0.5 m. The radius of the larger…

Q: (II) What is the lift (in newtons) due to Bernoulli’s principle on a wing of area 88 m2 if the air…

A: According to the Bernoulli's theorem, The pressure difference is given by P' - P = 0.5d(v2 - v'2)…

Question

2] The device shown is used to straighten the frames of
wrecked autos. Determine the tension of each segment of
the chain, i.e., AB and BC, if the force which the hydraulic
cylinder DB exerts on point B is 3.50 kN, as shown.
B
3.50 kN
450 mm
400 mm 250 mm

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

What is the ratio of heights to which ethyl alcohol and water are raised by capillary action in the same glass tube?
Because atmospheric pressure is about 105 N/m2 and the area of a persons chest is about 0.13 m2, the force of the atmosphere on ones chest is around 13 000 N. In view this enormous force, why dont our bodies collapse?
Calculate the maximum force in newtons exerted by the blood on an aneurysm, or ballooning, in a major artery, given the maximum blood pressure for this person is 150 mm Hg and the effective area of the aneurysm is 20.0 cm2. Note that this force is great enough to cause further enlargement and subsequently greater force on the ever-thinner vessel wall.
The density of oil is less than that of water, yet a loaded oil tanker sits lower in the water than an empty one. Why?
How much pressure is transmitted in the hydraulic system considered in Example 11.6? Express your answer in pascals and in atmospheres.
Is there a limit to the height to which an entrainment device can raise a fluid? Explain your answer.
As a first approximation. Earth's continents may be thought of as granitr blocks floating in a denser rock (called peridotitc) in the same way that ice floats in water. (a) Show that a formula describing this phenomenon is gt = pd where g is the density of granite (2.8 103 kg/m3), p is the density of peridotite (3.3 103 kg/m3), t is the thickness of a continent, and d is the depth to which a continent floats in the peridotite. (b) If a continent sinks 5.0 km into the peridotite layer (this surface may be thought of as the ocean floor), what is the thickness of the continent?
Two thin-walled drinking glasses having equal base areas bin different shapes, with very different cross-sectional areas above the base, are filled to the same level with water. According to the expression P = P0 + gh, the pressure is the same at the bottom of both glasses. In view of this equality, why does one weigh more than the other?
You can squirt water a considerably greater distance by placing your thumb over the end of a garden hose and then releasing, than by leaving it completely uncovered. Explain how this works.
A boat develops a leak and, after its passengers are rescued, eventually sinks to the bottom of a lake. When the boat is at the bottom, what is the force of the lake bottom on the boat? (a) greater than the weight of the boat (b) equal to the weight of the boat (c) less than the weight of the boat (d) equal 10 the weight of the displaced water (e) equal to the buoyant force on the boat
During heavy lifting, a disk between spinal vertebrae is subjected to a 5000-N compressional force. (a) What pressure is created, assuming that the disk has a uniform circular cross section 2.00 cm in radius? (b) What deformation is produced if the disk is 0.800 cm thick and has a Young's modulus of 1.5109N/m2 ?
Calculate the pressure due to the ocean at the bottom of the Marianas Trench near the Philippines, given its depth is 11.0 km and assuming the density of sea water is constant all the way down. (b) Calculate the percent decrease in volume of sea water due to such a pressure, assuming its bulk modulus is the same as water and is constant. (c) What would be the percent increase in its density? Is the assumption of constant density valid? Will the actual pressure be greater or smaller than that calculated under this assumption?