2. A sculptor has asked you to help electroplate gold onto a brass statue. You know that the charge carriers in the ionic solution are gold ions (singly ionized charge: 1.6×1019C), and you've calculated that you must deposit 0.490 g of gold to reach the necessary thickness. How much current do you need to plate the statue in 9.0 hours? Gold is 197g/mol and 1 mol = 6.022x1023 ions. %3D 3. a. Find the equivalent resistance of the 5.0 N 5.0 N 5.0 0 resistor network in the figure. b. What is the power output of the 10 V 100 10 N 5.0 0 battery? C. What is the power dissipated by the top-left 50 resistor? ww ww

2. A sculptor has asked you to help electroplate gold onto a brass statue. You know that the charge carriers in the ionic solution are gold ions (singly ionized charge: 1.6×1019C), and you've calculated that you must deposit 0.490 g of gold to reach the necessary thickness. How much current do you need to plate the statue in 9.0 hours? Gold is 197g/mol and 1 mol = 6.022x1023 ions. %3D 3. a. Find the equivalent resistance of the 5.0 N 5.0 N 5.0 0 resistor network in the figure. b. What is the power output of the 10 V 100 10 N 5.0 0 battery? C. What is the power dissipated by the top-left 50 resistor? ww ww

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter17: Current And Resistance

Section: Chapter Questions

Problem 58AP

See similar textbooks

Similar questions

If electrical energy costs 0.12 per kilowatt-hour, how much does it cost to (a) burn a 100-W lightbulb for 24 h? (b) Operate an electric oven for 5.0 h if it carries a current of 20.0 A at 220 V?
What is the current in milliamperes produced by the solar cells of a pocket calculator through which 4.00 C of charge passes in 4.00 h?
An aluminum wire 1.628 mm in diameter (14-gauge) carries a current of 3.00 amps, (a) What is the absolute value of the charge density in the wire? (b) What is the drift velocity of the electrons? (c) What would be the drift velocity if the same gauge copper were used instead of aluminum? The density of copper is 8.96 g/cm3 and thedensity of aluminum is 2.70 g/cm3. The molar mass ofaluminum is 26.98 g/mol and the molar mass of copper is 63.5 g/mol. Assume each atom of metal contributes one free electron.
What current flows through a 2.54-cm-diameter rod of Pure silicon that is 20.0 cm long, when 1.00103 V is applied to it? (Such a rod may be used to make nuclear- particle detectors, for example.)
If electrical energy costs 0.12 per kilowatt-hour, how much does it cost to (a) burn a 100-W lightbulb for 24 h? (b) Operate an electric oven for 5.0 h if it carries a current of 20.0 A at 220 V?
A close analogy exists between the flow of energy by heat because of a temperature difference (see Section 19.6) and the flow of electric charge because of a potential difference. In a metal, energy dQ and electrical charge dq are both transported by free electrons. Consequently, a good electrical conductor is usually a good thermal conductor as well. Consider a thin conducting slab of thickness dx, area A, and electrical conductivity , with a potential difference dV between opposite faces. (a) Show that the current I = dq/dt is given by the equation on the left: ChargeconductionThermalconductiondqdt=A|dVdx|dQdt=kA|dTdx| In the analogous thermal conduction equation on the right (Eq. 19.17), the rate dQ/dt of energy flow by heat (in SI units of joules per second) is due to a temperature gradient dT/dx in a material of thermal conductivity k. (b) State analogous rules relating the direction of the electric current to the change in potential and relating the direction of energy flow to the change in temperature.
Check Your Understanding Handheld calculators often use small solar cells to supply the energy required to complete the calculations needed to complete your next physics exam. The current needed to run your calculator can be as small as 0.30 mA. How long would it take for 1.00 C of charge to flow from the solar cells? Can solar cells be used, instead of batteries, to stall traditional internal combustion engines presently used in most cars and trucks?
Taking R = 1.00 k and = 250 V in Figure P21.49, determine the direction and magnitude of the current in the horizontal wire between a and e. Figure P21.49
A typical cell phone consumes an average of about 1.00 W of electrical power and operates on 3.80 V. (a) What average current does the phone draw from its battery? (b) Calculate the energy stored in a fully charged battery if the phone requires charging after 5.00 hours of use.