2. Suppose your phone's battery has a capacity of 2500 mAh and a potential difference of 3.7 V. What is the amount of charge, in C (coulombs), that is stored in your smartphone battery when it's fully charged? Charge - 9000 3. Smartphone chargers are usually labeled with their current output in A (amps). Suppose your charger delivers a current of 1.1 A. If your phone's battery is completely drained, how long will it take to fully charge the battery using your charger? Charging time - 2.27 v hours 4. Smartphones are advertised with a certain amount of "talk time", i.e., how long the phone's battery will last if you are making a call. If your phone is advertised with 24 hours of talk time, what is the average current coming from your phone's battery while making t Average current - A 5. What is the average power output of your phone's battery while you're making a call? Average power - w

2. Suppose your phone's battery has a capacity of 2500 mAh and a potential difference of 3.7 V. What is the amount of charge, in C (coulombs), that is stored in your smartphone battery when it's fully charged? Charge - 9000 3. Smartphone chargers are usually labeled with their current output in A (amps). Suppose your charger delivers a current of 1.1 A. If your phone's battery is completely drained, how long will it take to fully charge the battery using your charger? Charging time - 2.27 v hours 4. Smartphones are advertised with a certain amount of "talk time", i.e., how long the phone's battery will last if you are making a call. If your phone is advertised with 24 hours of talk time, what is the average current coming from your phone's battery while making t Average current - A 5. What is the average power output of your phone's battery while you're making a call? Average power - w

Physics for Scientists and Engineers

10th Edition

ISBN:9781337553278

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter27: Direct-current Circuits

Section: Chapter Questions

Problem 14P: For the purpose of measuring the electric resistance of shoes through the body of the wearer...

See similar textbooks

Similar questions

Three 100- resistors are connected as shown in Figure P21.41 The maximum power that can safely be delivered to any one resistor is 25.0 W. (a) What is the maximum potential difference that can be applied to the terminals a and b? (b) For the voltage determined in part (a), what is the power delivered to each resistor? (c) What is the total power delivered to the combination of resistors?
The- pair of capacitors in Figure P28.63 are fully charged by a 12.0-V battery. The battery is disconnected, and the switch is then closed. Alter 1.00 ms has elapsed, (a) how much charge remains 011 the 3.00-F capacitor? (b) How much charge remains on the 2.00-F capacitor? (c) What is the current in the resistor at this time?
Four resistors are connected to a battery as shown in Figure P27.15. (a) Determine the potential difference across each resistor in terms of . (b) Determine the current in each resistor in terms of I. (c) What If? If R3 is increased, explain what happens to the current in each of the resistors. (d) In the limit that R3 , what are the new values of the current in each resistor in terms of I, the original current in the battery? Figure P27.15
The circuit in Figure P27.35 has been connected for several seconds. Find the current (a) in the 4.00-V battery, (b) in the 3.00- resistor, (c) in the 8.00-V battery, and (d) in the 3.00-V battery. (e) Find the charge on the capacitor. Figure P27.35
The circuit in Figure P21.59 has been connected for a long time. (a) What is the potential difference across the capacitor? (b) If the battery is disconnected from the circuit, over what time interval does the capacitor discharge to one-tenth its initial voltage?
(a) A defibrillator sends a 6.00-A current through the chest of a patient by applying a 10,000-V potential as in the figure below. What is the resistance of the path? (b) The defibrillator paddles make contact with the patient through a conducting gel that greatly reduces the path resistance. Discuss the difficulties that would ensue if a larger voltage were used to produce the same current through the patient, but with the path having perhaps 50 times the resistance. (Hint: The current must be about the same, so a higher voltage would imply greater power. Use this equation for power: P=I2 RP = .)
A homemade capacitor is constructed of 2 sheets of aluminum foil with an area of 2.00 square meters, separated by paper, 0.05 mm thick, of the same area and a dielectric constant of 3.7. The homemade capacitor is connected in series with a 100,00- resistor, a switch, and a 6.00-V voltage source, (a) What is the RC time constant of the circuit? (b) What is the initial current through the circuit, when the switch is closed? (c) How long does it take the current to reach one third of its initial value?
(a) Determine the equilibrium charge on the capacitor in the circuit of Figure P27.46 as a function of R. (b) Evaluate the charge when R = 10.0 . (c) Can the charge on the capacitor be zero? If so, for what value of R? (d) What is the maximum possible magnitude of the charge on the capacitor? For what value of R is it achieved? (c) Is it experimentally meaningful to take R = ? Explain your answer. If so, what charge magnitude does it imply? Figure P27.46
The current-versus-voltage behavior of a certain electrical device is shown in Figure OQ27.9. When the potential difference across the device is 2 V, what is its resistance? (a) 1 (b) 34 (c) (d) undefined (e) none of those answers
Suppose a single electron moves through an electric potential difference of 1.5 V (the potential difference between the terminals of an AAA battery). What is the change in the systems electric potential energy? Give your answer in eV and in J.
Consider the two circuits shown in Figure P27.5 in which the batteries are identical. The resistance of each lightbulb is R. Neglect the internal resistances of the batteries. (a) Find expressions for the currents in each lightbulb. (b) How does the brightness of B compare with that of C? Explain. (c) How does the brightness of A compare with that of B and of C? Explain. Figure P27.5
For the purpose of measuring the electric resistance of shoes through the body of the wearer standing on a metal ground plate, the American National Standards Institute (ANSI) specifies the circuit shown in Figure P27.14. The potential difference V across the 1.00-M resistor is measured with an ideal voltmeter. (a) Show that the resistance of the footwear is Rshoes=50.0VVV (b) In a medical test, a current through the human body should not exceed 150 A. Can the current delivered by the ANSI-specified circuit exceed 150 A? To decide, consider a person standing barefoot on the ground plate. Figure P27.14