2. Block A weighs 100N and block B weighs 300N both rests on an inclined plane downward to the right at a slope of 3 vertical to 4 horizontal. The blocks are connected by a cable parallel to the plane, passing through the pulley then connected to another block C weighing 400N. The coefficient of friction under A is 0.30 and under B is 0.20. Compute the tensions in the cable.

2. Block A weighs 100N and block B weighs 300N both rests on an inclined plane downward to the right at a slope of 3 vertical to 4 horizontal. The blocks are connected by a cable parallel to the plane, passing through the pulley then connected to another block C weighing 400N. The coefficient of friction under A is 0.30 and under B is 0.20. Compute the tensions in the cable.

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter7: Dry Friction

Section: Chapter Questions

Problem 7.50P: The block of weight W is pulled by the force P inclined at the angle to the horizontal. Find the...

See similar textbooks

Similar questions

The block of weight W is pulled by the force P inclined at the angle to the horizontal. Find the smallest force P and the corresponding angle that would cause impending sliding of the block. The angle of static friction between the block and the ground is s.
Find the tension T in the cable when the 180-N force is applied to the pedal at E. Neglect friction and the weights of the parts.
Determine the tension TB in Sample Problem 5.6 using one scalar equilibrium equation.
The 40-lb spool is suspended from the hanger GA and rests against a vertical wall. The center of gravity of the spool is at G and the weight of the hanger is negligible. The wire wound around the hub of the spool is extracted by pulling its end with the force P. If the coefficient of static friction between the spool and the wall is 0.25, determine the smallest P that will extract the wire.
Compute the tension TAE in Sample Problem 5.7 using one scalar equilibrium equation.
A wedge is used to prop up the 6000-lb block of marble. The wedge angle is =30, and the angle of static friction is s=12 between all contact surfaces. Determine the smallest force P that would prevent the wedge from sliding out.
The coeffient of static friction between the uniform bar AB of weight W and the ground is 0.45. Find the smallest angle and the corresponding force P that would initiate simultaneous tipping and sliding of the bar.
In Sample Problem 5.4, determine the tension TAC using the equation MDB=0.
Calculate the force P that is required to hold the 120-lb roller at rest on the rough incline.
Find the force P required to (a) push; and (b) pull the 80-lb homogeneous roller over the 3-in. curb.
The woman is trying to move the crate of weight W by pulling on the rope at the angle to the horizontal. Find the smallest possible tension that would cause the crate to slide and the corresponding angle .
Find the largest value of b/h at which the folding table is in equilibrium. The coefficients of static friction are 0.5 at A and 0.3 at C. Neglect the weight of the table.