2. Consider the pressure of a height of 10 km in a volume of air, M = 0.0289 kg/mol. If the pressure at ground level remains at 1 atm but the temperature changes from 300K to 320K, what will be the change in pressure at 10 km altitude?

Q: a. The reaction shown takes place in four steps. Complete the mechanism by adding curved arrows for ...

A:

Q: O Other Boc (EOC) [References] Consider 45.0 mL of a solution of weak acid HA (K water must be added...

A: Here 45 ml of weak acid HA (ka= 1.4×10^--6) has pH 4.25 is diluted and the pH becomes 5.25 . We have...

Q: in an experiment, a sample of 3 was 90% decomposed in 48 min. Approximately how long would this deco...

A:

Q: 1. A Chemist collected a 0.4891-g sample of an ore for Fe determination by a redox titration with K:...

A:

Q: a. Calculate the theoretical yield of methanol. b. If 3.57 x 104 g of CH3OH is actually produced wh...

A:

Q: You have a neutral, 4-coordinate macrocyclic ligand that binds to Ni(II). When a weakly-coordinating...

A: Square-planar Ni(II) complexes are diamagnetic and their colour is usually red, yellow or brown.Henc...

Q: Why is it recommended to fight fire only in the INCIPIENT Stage?

A: FIRE SUPRESSION

Q: the rate constant for this second-order reaction is 8.0x 10-8 L mol-1s-! what is the half-life for t...

A:

Q: Acetylene (C,H,) gas and oxygen (0,) gas react to form carbon dioxide (CO,) gas and water (H,O) vapo...

A:

Q: The Russian Space Agency uses potassium superoxide (KO2) for the chemical oxygen generators in their...

A: Given reaction is : 4KO2 + 2H2O + 4CO2 → 4KHCO3 + 3O2  Mass of O2 produced = 380.0 g  Determine the ...

Q: Thiatriazoles, when heated de-compose vigorously. Why is this?

A: On heating thiatriazoles decomposes to form nitogen gas and isothiocyanate. Because nitrogen is a ga...

Q: STAT 1. Bisphenol A is prepared from: a) Benzene and Acetone b) Benzene and Phenol c) Acctone and ph...

A: Bisphenol A is prepared from the acid-catalyzed condensation of phenol and acetone.

Q: The normal boiling point of water is 100 Celcius and the molar enthalpy of vaporization of water is ...

A: Given, The normal boiling point of water (T1) = 100°C = (273.15 + 100) K = 373.15 K Note: pressure a...

Q: 5g of sugar at 10g of water. What is the volume?

A: Given :-  mass of sugar = 5 g  mass of water = 10 g  To calculate :-  total volume of solution 

Q: Consider the following reaction and its stoichiometry: 3 A+1B----> 2 C. See the below data, given 24...

A:

Q: OH но

A:   1.  Ether bond cleavage with HI , then reacts with NaCN give cyanide via nucleophilic substitution...

Q: 12. Show how the following compounds could be prepared from pyridine NB: More than one step may be n...

A: The above reaction is various reaction of pyridine.

Q: The chemical structure of oxamide is shown below. Highlight each atom that is in an amino group. :0:...

A:

Q: Problem 8 C8H14 18- 40 20 4000 3500 3000 25b0 20be 1500 1000 3H 2H 2H 2841.51- 484.16 - 1278.97 1072...

A:

Q: 3. Assign the absolute configuration to the stereocenters (marked A through G) below. Note: “extract...

A:

Q: A 2.409 g sample of a new organic material is combusted in a bomb calorimeter. The temperature of th...

A: Given that, a 2.409 g of an organic compound is combusted in bomb calorimeter. So, mass is m = 2.409...

Q: 1.)Hydrogen sulfide, a colorless gas with a foul odor, dissociates on heating: 2H2S(g) 2H2(g)+ S2(g)...

A:

Q: What mass of precipitate will be produced from the reaction of 50.0 mL of 2.50 mol/L sodium hydroxid...

A: When sodium hydroxide reacts with zinc chloride it form precipitate of zinc hydroxide.

Q: Enter a net ionic equation for the reaction of acetic acid, CH3COOHCH3COOH, with zinc. Express your ...

A:

Q: Vhich of the following examples are acid derivatives? A) Amines B) amides C) ester D) aldehydes E) a...

A: Carboxylic acid is a functional group represented by -COOH grouo. Carboxylic acid derivatives are de...

Q: Provide the correct IUPAC name for CaSO₄. and for Provide the correct IUPAC name for Ca(NO₃)₂

A:

Q: NH, но он H. H H он он ncorrect

A: AMP - adenine + monophosphate  

Q: 1. H2SO4 reacts with NaOH, producing water and sodium sulfate. What volume of 2.0 M H2SO4 will be re...

A: Given, Note: 1000 mL = 1 L Molarity of H2SO4 solution = 2.0 M = 2.0 mol/L Volume of H2SO4 solution =...

Q: Draw the strongest IMF that can form between each structure below and a water molecule. a. b.

A: Since you have asked multiple question, we will solve the first question for you. If you want any sp...

Q: A 2.50 g sample of powdered zinc is added to 100.0 mL of a 2.00 M aqueous solution of hydrobromic ac...

A: Given:- •2.50g of sample of zinc powder • 100ml of 2M HBr solution. •Total heat capacity of calorime...

Q: why are equivalence points on a titration graph equally spaced along the horizontal axis

A: A question based on acid base titrations that is to be accomplished.

Q: The decomposition of acetaldehyde is a second order reaction with a rate constant of 4.71 × 10-8 L m...

A:

Q: Calculate the degree of unsaturation. Assign the relevant peaks in the IR spectrum. Assign the pea...

A:

Q: O CHEMICAL REACTIONS Writing the net equation for a sequence of reactions Manganese commonly occurs ...

A: To write the net chemical equation of the given two steps involved, we have to identify the common c...

Q: Use the following thermochemical equations as needed to find the heat of formation of diamond: C(dia...

A: Given equations are : 1). C (diamond) +  O2 (g)  --------> CO2 (g) , ΔH1 = -395.4 KJ  2). 2CO2 (g...

Q: Annotate the H-NMR of Triphenylmathanol

A: Given that, comment or annotate the 1H-NMR of Triphenylmathanol, Ph3C-OH. In 1H-NMR, the chemical sh...

Q: The registered pharmacy technician receives a prescription for a Sodium Chloride (NaCl) solution. To...

A:

Q: Problem 3: A water has pH = 8.8 and an alkalinity of 3.2 meq/L. Estimate the concentrations of: a. H...

A: Since you have posted a question with multiple subparts, we will solve the first three subparts for ...

Q: You were given a set a results on an Excel spreadsheet to complete. Following completion of this sai...

A: Solution- Data given- Here we are having the data of volume of titrant (ml) and pH of 0.2M Na-Phosph...

Q: What need to be aware of when using ATR attachment of IR spectrometer? Give detailed solution please...

A: IR spectroscopy is one of the techniques that is used in analytical chemistry in qualitative analysi...

Q: 6 Answer true or false. (a) For a sample of gas at constant temperature, its pressure multiplied by ...

A: Detail solution for true or false statements is given below

Q: 3-3. Piché and Larachi (2007) proposed the following reaction for the oxidation of polysulfide ions ...

A:          

Q: A sample of mixture of CaCO3(s) and NaHCO3(s) was heated and the compound decomposed: CaCO3(s) = CaO...

A:

Q: Select all of the following elements that are categorized as non-metals. OA. Ag O B. K O C.B O D.S O...

A: Non metals : These are the elements which are placed to right corner of the periodic table and have ...

Q: HNO3+KOH= KNO3+H2O HCl+ Ca(OH)2= CaCl2+H2O FOR THE REACTIONS ABOVE, HOW MANY MOLES OF THE BASE ARE R...

A: 1).Balanced Reaction : HNO3 + KOH → KNO3 + H2O  

Q: 0.100 mol of AgCls) is added to 1.00 L of H20. Next, crystals of NaBr are added until 75.00% of the ...

A: Given, 0.100 mole of solid AgCl is added to 1.0 L of water NaBr is added until 75.00 % of AgCl is co...

Q: 9. Draw all resonance structures of the following compounds, showing electron movement with curved a...

A:

Q: Mass of Moles of Amount of Moles of NAHCO3 NAHCO3 Acetic Acid Аcetic Acid 6g 30mL 0.30 mol WHAT IS T...

A:

Q: 14-28 Electrophilic addition of Br2 to isoprene (2-methyl-1,3-butadiene) yields the following produc...

A:

Q: Measurements show that the enthalpy of a mls constant pressure. Furthermore, by carefully monitoring...

A: ∆H = ∆U + P∆V ∆H = change in enthalpy  ∆U = change in Energy P∆V = work done 

Mole Concept

Mole concept is a method to determine the amount of any substance that consists of some elemental particles using a grouping unit called ‘mole’. The mole concept enables one to handle the large amount of small elementary particles. The mole concept can be used in many calculations related to mole calculation, molar amount, mole ratio, and so on, which are significant in chemistry.