2. Design the salient dimensions of a syphon well drop for the following particulars : Fall = 3.8 m General ground level = + 163.36 m Full supply depth = 75 cm Bed level upstream = + 162.83 Discharge = 1 cumec Bed width upstream and downstream = 2.4 m

2. Design the salient dimensions of a syphon well drop for the following particulars : Fall = 3.8 m General ground level = + 163.36 m Full supply depth = 75 cm Bed level upstream = + 162.83 Discharge = 1 cumec Bed width upstream and downstream = 2.4 m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Consider a farm irrigation ditch in a loam soil having the following dimensions: bottom width,0.5m; total depth, 0.6 m; side slopes of 1horizontal to 1 vertical, and depth of water, 0.4 m.The bottom of the ditch has a uniform slope of 1 m/km. Assume a Manning’s roughnesscoefficient, n of 0.02 Find the mean velocity of flow. ANSWER SHOULD BE 0.58 m/s
Describe about the Well Points as a method of Dewatering Intermediate Depths.
*hydraulics *use handwritten A rectangular channel 5.50 m wide and 1.30 m deep is laid on a uniform slope of 0.002. The roughness coefficient of the channel is 0.013. 1.) Which of the following most nearly gives the rate of flow in the channel in m^3/s. Choices are A.) 21.04 B.) 13.02 C.) 1.03 D.) 22.63 E.) 0.24 F.)0.67 2.) Which of the following most nearly gives the saving’s in lining per meter length of channel that could have been offered by using the most efficient rectangular section but adhering to the same flow capacity and slope in m^2/s. Choices are A.) 21.04 B.) 13.02 C.) 1.03 D.) 22.63 E.) 0.24 F.)0.67 3.) Which of the following most nearly gives the savings in earth excavation per meter length of channel that could have been offered by using the most efficient rectangular Section but adhering to the same flow capacity and slope in m^3/s. Choices are A.) 21.04 B.) 13.02 C.) 1.03 D.) 22.63 E.) 0.24 F.)0.67
A rectangular channel of best hydraulic cross-section, n = 0.016, is laid on a slope of 0.0064 and carries 98 m³/ s. For critical conditions, what with is required?
The coefficient of permeability below a dam is 4m/day. The water on the upstream side is 20m higher than on the downstream side. To estimate the seepage below the dam, a flownet was graphically drawn such that the number of potential drops Nd=10 and number of flow channels Nf=4. The base of the dam is founded 1m below the ground. Between the heel and the toe of the dam, a distance of 30m, there are 8 potential drops. Evaluate the seepage flow per meter width of the dam in liters per minute. Determine the uplift pressure at the heel of the dam in kPa. Determine the uplift pressure at the toe of the dam in kPa.
A trapezoidal channel with 3 meters bottom width, side slope 2H:1V, channel gradient of 0.002, and n = 0.025, carries a discharge of 200 m3 /min. Compute the normal depth and velocity. Given data Wbottom (b)= 3 meters Slope= 2:1 S= 0.002 n= 0.025 Q= 200 m3 /min= 3. 33 m3 /sec Normal depth=? Velocity=? Formula below:
If a rectangular suppressed weir 1.5m high extends across a rectangularchannel 3m wide. Measured head is 0.44 meters. Using Francis formula(show your checking) and neglecting velocity of approach, find thedischarge (cms). INCLUDE FBD!!!
In which situations are wet ESPs (WESPs) used?
Determine the true difference in elevation between A and B given the data in the table for a two-peg test dumpy level. Solution pls ty
A rectangular channel 5.2 m wide by 1.4 m deep was laid to have a hydraulic slope of 0.001. Using n = 0.013. 1. What is its yield in m³/s? a. 16.63 b. 12.47 c. 19.12 d. 14.14 2. What savings in earth excavation could be realized by using most economical proportion? a. 0.85 cum b. 0.96 cum c. 1.05 cum d. 0.92 cum 3. What savings in lining per meter length could be realized by using most economical proportion? a. 0.8 m b. 0.944 m c. 1.13 m d. 1.04 m
Compute the volume of fill per unit length for an earthdam 9.0m high , assuming a top width of 2.4m , sideslope of 3:1 upstream and 2:1 downstream , and a levelbase perpendicular to the center line of the dam? step by step with explanation
Show drawing please. And show checking. If a rectangular suppressed weir 1.5m high extends across a rectangularchannel 3m wide. Measured head is 0.44 meters. Using Francis formula(show your checking) and neglecting velocity of approach, find thedischarge (cms).