2. In Figure, the battery voltage is V= 65 volts, and the values of the resistances, in ohms, are 38, 17, and 27, as shown. Find: (a) Total resistance seen by the battery, (b) Current measured by the ammeters shown in the figure, V= 65 V 38 Q 170 272

2. In Figure, the battery voltage is V= 65 volts, and the values of the resistances, in ohms, are 38, 17, and 27, as shown. Find: (a) Total resistance seen by the battery, (b) Current measured by the ammeters shown in the figure, V= 65 V 38 Q 170 272

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Two batteries, 10.5 volts with internal resistance of 1.5 ohm and 9 volts with internal resistance…

Q: 120 volt battery is connected at the terminals with the positive terminal at point A and the…

A: Resistance opposes the flow of current. Inductor is passive element that store energy in magnetic…

Q: 2. Five dry cells, each of which has an internal resistance and emf's of 0.05 ohm and 1.5 volts…

Q: For the circuit shown, if Vs=10 Volt, and Is=1 Ampere, then the current Ix (in A) is: 2Ω Ix VsO Is O…

Q: Four identical dry cells with an emf of 1.4 volts and internal resistance of 0.06 ohm each, are…

Q: Washing machine rated at 4.2A at 120V. What is its internal resistance?

A: Evaluating the internal resistance of washing machine by the use of the Ohm’s law:

Q: 42 in A Battery =24 V 122 12 8Ω A battery with an emf of 24 volts and an internal resistance of 1…

Q: Design a multi range ammeter to give the following ranges 100mA, 1A, 5A, and 50A. If d'Arsonval…

Q: Compute the percent efficiency of the electrical system of the figure below. Note: Resistors absorbs…

A: Given circuit-

Q: 2. Find the current flowing in the 4-ohm resistor and the power dissipated in the 6- ohm resistor.…

A: In this question we need to find a current flowing through 4 ohm resistor and power dissipation in 6…

Q: 120 volt battery is connected at the terminals with the positive terminal at point A and the…

A: In parallel connection voltage across each element is equal. In series connection the current…

Q: ) Sketch the network of Figure below and determine the de voltage available. Meal Dide Meal Dide 2.2…

A: When diode is forward bias it is on and when diode is reverse bias it is off. During on condition…

Q: Determine the Power consumed by the load (Green) when it is connected to a supply voltage of 48Vdc…

Q: 30.) A 4-ohm resistance is connected in series with the parallel connection of 8 and 16 ohms. If the…

A: Kirchoff's voltage and the current law is an important law in the electrical networks which is used…

Q: 1. In the circuit shown, determine the equivalent resistance, total current and power in each…

A: To solve the above problem, one should know how to find equivalent resistance for series and…

Q: At 315 °K temperature, the voltage equivalent of temperature of

A: Boltzmann's constant is- 8.62×10-5eV/°K=8.62×10-5×1.6×10-19V/°K…

Q: B- Calculate the value and limiting error in ohm for resistances have the following ranges R1 = 45…

Q: 2. In the figure shown below, determine the following: Battery voltage = 240 volts a. The current in…

A: This problem is from circuit analysis.

Q: 1.From the Ohm's law principle, the following data are given. E = 18 volts, RL = ohms, It = Z…

A: We need to find internal resistance of battery and load voltage

Q: 1. Construct the circuit shown in Figure 2.1. 2. Measure the voltage across the bulb, the current…

Q: In the circuit shown below, the external resistance connected across the terminals of the battery is…

Q: 3. In Figute, the battery voitage is V= 65 volts, and the values of the resistances, in ohms, are…

Q: 2. In Figure, the battery voltage is V = 65 volts, and the values of the resistances, in ohms, are…

Q: In the following Figure, the current in resistance R, is i,= 14A and the resistances are R, =R; = R,…

Q: Motor Suppose the voltmeter in the circuit shows 20 V, and the conductance of the motor is 25 mS.…

Q: 3) Find the currents and voltages in the circuit bel 30 V

A: In this question we will find unknown voltage and currents using KCL and KVL.... Kirchoff voltage…

Q: 3. For the circuit shown, both meters (voltmeter and ammeter) are idealized, the battery has no…

A: Voltage and current

Q: Two batteries A and B are connected in parallel; to supply a current of 160 amperes to a load…

A: We need to calculate voltage and power for given circuit .

Q: 2. In Figure, the battery voltage is V = 65 volts, and the values of the resistances, in ohms, are…

A: Voltage across all resistor is same so all resistors are in parallel. Current=Voltage across…

Q: 60 2 12 Ω io 5Ω 6Ω 80 Ω V + X 20 2

A: When two resistors R1 & R2 are connected in series, their equivalent resistance is R1 + R2. When…

Q: Given f = 8 volts , d = 3 ohms , e = 1 ohms Determine VAB (not VBA)

A: From the given figure, total resistance between the path AB is,

Q: 2. In Figure, the battery voltage is V = 65 volts, and the values of the resistances, in ohms, are…

A: All elements are in parallel and voltage across theme is same so total resistance is equal to…

Q: 2. In Figure, the battery voltage is V = 65 volts, and the values of the resistances, in ohms, are…

Q: An ammeter is connected in series with an unknown resistance, and a voltmeter is connected across…

A: Given, Ammeter reads, I = 12.4 amps Voltmeter reads, V = 18 volts

Q: Find the unknown quantities, 'I' and 'R' in the circuit shown if V 120 volts and VR = 70 volts. + VR…

Q: 3. Using Kirchhoff's Laws, find the current supplied by both batteries shown in Figure 3. 50 ww {…

A: The solution can be achieved as follows.

Q: Find the value of i, and V,. Determine the voltuge supplied by the dependent voltage sourve.…

Q: 2. In Figure, the battery voltage is V= 65 volts, and the values of the resistances, in ohms, are…

Q: [₂ 20 V 10 ohms 30 ohms 40 ohms 10 ohms b 50 ohms T4 : 40 V

A: In this question we need to find a current through 20 V source.

Q: Q1) The 60-Watt light bulb in Figure below is rated at 120 volts. Calculate V, to make the light…

Q: Find the load voltage V₁, the load current / L, and the current supplied by each cell in the battery…

Q: 21 2, and 15. The load across a 12-V battery consists of a series combination of three resistances…

A: Ohm's law: This law states that the current is directly proportional to the voltage and inversely…

Q: From the figure given below, If the input voltage. V=75 volts and the resistances are X=15 ohms and…

A: The solution can be achieved as follows.

Q: 60 V 10 N 20 N 16 N

Q: 2. In Figure, the battery voltage is V = 65 volts, and the values of the resistances, in ohms, are…

Q: IR I k2 b.1 For the network shown in the figure to the right, determine the range of RL and IL that…

A: In this question, Voltage regulator circuit is given. Find the range of load current and load…

Q: In the circuit shown below, the external resistance connected across the terminals of the battery is…

Concept explainers

Type of Magnetic Material

Every material has a unique composition that defines its magnetic behavior. Some materials get attracted towards a magnet and are called magnetic materials. Based on the magnetic properties held by each material, they are classified into different types.

Question

O 6 P1,AK/s l|Asiacell
تجربه.pdf
2. In Figure, the battery voltage is V = 65 volts, and the values of the
resistances, in ohms, are 38, 17, and 27, as shown. Find:
(a) Total resistance seen by the battery,
(b) Current measured by the ammeters shown in the figure,
V= 65 V
38 2
172
27 Q
7
V / V

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A power plant produces 1000MW to supply a city 40km away. Current flows from the power plant on a single wire with resistance through the city and returns via the ground, with negligible resistance. At the power plant the voltage between wire and ground is 115 kV. Determine: (a) the current in the wire, and (b) the fraction of the power lost in transmission.
Whale and Kanmuro are two islands located at the Chimera archipelago. These two are separated by a distance of 16 miles. A power link is to be established between them. The power link delivers a maximum power of 584 megawatts at full capacity with an operating voltage of 580 kilovolts. Note that 1 mile is 1.6 kilometers. Solve for the resistivity (in ohm-micrometers) of the cable asusming a conductor diameter of 1.55 centimeters.
At a temperature of 25°C (common temperature for components in an enclosed operating system), determine the thermal voltage VT.
Since R1=18.10Kohm, R2=67.58Kohm, RC= 1.08Kohm, RE= 3.23Kohm, VCC=14.00V, Beta=241.00 in the circuit given in the figure, calculate the IC current by doing a complete analysis. When performing your operations, 2 steps will be taken after the point. choose the closest one from the stylish ones according to the +/-10% margin of error. There is only 1 correct answer to the question.
A motor,the input to which is 20kW at 220V,is supplied by a two-core cable.400m long.If the power lost in the cable Is not to exceed 5% of the motor Input . Calculate the minimum permissible C.S.Area of the cable conductor What will be the voltage at the feeding point ? Assume the resistivity of the conductor at working temperature to be 0.02 microohm/m
Question 5 A natural gas plant with a 50MW operates at an average loading of 75% year round. How many kWh does the plant to supply to the grid? Question 6 For Question 5, the natural gas power plant costs $175,000,000 to build and costs $20M a year to operate. What is the average cost per kWh or MWh for the power produced if the estimated plant life is 20 years? Assume a discount rate of 5%.
A 20 kVA machine has a full load copper loss of 400 W, an iron loss of 150 W, and a mechanical loss of 200 W. Determine:a) Efficiency at 3/4 of full load with f.d.p. 0.8. Ans: 95,43%b) Performance at full load with f.d.p. 0.9. Ans: 96%c) Peak performance apparent power. Ans: 18,71 kVAd) Yield in the previous case for f.d.p. Unit. Ans: 96,39% I need the procedures to get these results. Thanks
Q2/B: A grading string of four insulators has a uniform voltage across each disc. The capacitance of each pin to earth is C. The capacitance of the top unit is 5 C as shown.(a) Calculate the capacitance of the remaining discs, (b) If the voltages of units one and two are 60% and 40% of line voltage.,Calculate other voltages and string efficiency.
Q: Suppose that a fork lifter has a total energy consumption of 150 W.Hr. The total trips of the vehicle are 375. How the battery duty cycle may be calculated in this case?
A high voltage transmission line conducts 1000 A starting at 700 kV for a distance of 160 km meters. If the resistance in the wire is 0.3 ohms/km, what is the power loss due to resistive losses? (M=10^(6))
1. A resistor, in series with a 138-microfarad capacitor, is connected to a 60-cycle source. If the voltage drop across the capacitor is 115 volts and the power taken by the circuit is 922 watts, calculate (a) the circuit current, (b) the ohmic value of the resistor, (c) the line voltage, (d) the circuit power factor. Please show complete solution and the circuit diagram. Please round off answers up to the 3rd decimal place. Thank you!
(Renewable Energy) 1. Compare Wind Energy and Solar Energy with reference to the following parameters a) Site Requirements, b) Working, c) Advantages and Disadvantages, d) Efficiency and e) Cost of Installation and operation