2. Which momentary voltage occurs when the conductor loop is in a uniformly rotating generator at 45° or at 120°? The peak voltage is 325V. (229.8V, 281.5V)

Q: Example/ when the circuit below have R1-22 RI R,: R2-5 N Ro Ru Rz R3-6 Q R4-2 2 R5-8 2 Calculate the...

A: Given:

Q: Theoretical calculations: 1. How can you draw the spectrum of FM?

A: MODULATION: It is the method of transmitting a signal through modulating high frequency carrier sig...

Q: Theoretical calculations: 5. How does the bandwidth change in relation to increasing signal amplitud...

A: We need to tell about frequency modulation

Q: A 10Vp carrier signal is amplitude modulated by two different frequencies 5 KHz and 10 KHz with ampl...

A:

Q: The time constant for the RC circuit

A:

Q: Voice information with a frequency range of 0.3 - 4 kHz is sampled according to Nyquist requirements...

A: It is given that: fm=0.3~4 kHzL=256 levelsn=log2256=8 bitsd=0.5M=16

Q: 1. Given the circuit, VA=15V (ignore the variable symbol) CR1 CR2 VA R1 R2 3.ЗК 3.ЗК a.) Which diode...

A: Diode cr1 is forward biased and diode cr2 is reversed biased.

Q: A LPF has cutoff frequency of we = 100 rad/s. The filter is repeated three times. Find the new cutof...

A: Given: A LPF has a cutoff frequency of ωc = 100 rad /sec The filter is repeated 3 times. To find: Fi...

Q: Theoretical Calculations: 5. Name five other application for op- amp, sketch their circui and their ...

A:

Q: 50V 10 N Va 30 V 102. 2i 102. GA

A: The solution is given below

Q: Problem 1 10 K D3 The diodes in the circuit are Silicon with forward voltage of 0.7 V. Fill up the t...

A: The given circuit diagram is shown below:

Q: A Y-connected, 3-phase, 50 Hz, 6-pole, slip ring induction motor has following data: Rating: 400 ...

A: Given Rs=0.08 Ω,   Rr'=0.1 Ω,   Xs=Xr'=0.3 Ω J=10Kg·m2 N=960 rpm P= 50 kW f=50 Hz

Q: What do you mean by over modulation?

A:

Q: An RLC circuit has a resistance of (2.66x10^2) S2, an inductance of (1.93x10^1) mH, and a capacitanc...

A: For a RLC circuit -The value of resistance is,R=2.66×102 ΩThe value of inductance is,L=1.93×101mHL=1...

Q: Main Circuit Diagram: A. Vs R33 RL lov B.

A:

Q: QUESTION 9 RAM uses a to store a bit. ) capacitor transistor diode ) flip-flop

A: Q 9) SRAM uses flipflop to store a bit information Last option is correct   Note: Likewise DRAM uses...

Q: a Ix A,079( 2Vx 12 be HE 10 I3 I2 -jia I4 jia 12 2Ix Vx I1 e all

A:

Q: An AM transmitter has a carrier power of 100W at a frequency of 3 MHz. It is modulated at 75% by a 1...

A:

Q: can someone explain to me step by step how to get the equations of Vx and ix for this circuit just n...

A: It is only asked to derive the equation for vx and ix so that these two unknown variables can be sol...

Q: 3. Consider open-loop transfer function: 10K(s + 1) G(s) = s2(s² + 12s + 20) a) Apply Nyquist Stabil...

A: Root locus: This is a graphical representation of the system in the S-plane for all possible locatio...

Q: Example Determine the baud and minimum bandwidth necessary to pass a 10 kbps binary signal using amp...

A:

Q: a) Set up the supernode equation b) Set up the supernode auxiliary equation. c) Set up the equation ...

A:

Q: 4. Transform the 2-A and 4-A current sources to their equivalent voltage sources then find 11 and 12...

A: Brief description : Mesh analysis is used to calculate all the mess currents. In the given circuit d...

Q: Determine I, V1, V2, and Vout using 2nd approximation. 5ka 3kQ V1 RL V2 3.3kO 三13V Vout =7V Equivale...

A:

Q: Below given figure depicts a discrete time signal processing system, {xx} D D a) Find difference equ...

A: (a)  yt=Z-1χ1tχ1t=Z-1χt-14χ1t-15ytZ-14+1χ1t=Z-1χt-15Z-1yt Implies, yt+Z-14yt=Z-2χt-15Z-2tyt1+Z-14+Z-...

Q: Summary of instrumentation amplifier

A: We need give the summary of an instrumentation amplifier.

Q: From the circuit below solve for the current of D1 and D2 as practical diode.

A:

Q: What is the approximate voltage amplitude and frequency of the waveform below?

A: The amplitude and frequency of the signal can be measured by considering the number of divisions and...

Q: 2. Use mesh-current analysis to find the branch currents indicated in the networks shown below. I3 2...

A: In this question,  Find the all unknown current in the shown the circuit using the KCL and KVL.   

Q: A chip has an organization of 32M×4. What is the capacity of the chip measured in? bytes bits words ...

A:

Q: 9.4. The signals in Figure P9.2 are zero except as shown. (a) For the signal xn] of Figure P9.2(a), ...

A: As per our guidelines we are supposed to be answer the first question only.  Kindly repost the other...

Q: 4. Given (a) x(t) = 6t² ; (b) x(t) = t³/4 ; (c) x(t) = 4/ (s²+16). Obtain the Laplace transforms.

A: It is given that: a)xt=6t2b)xt=t34c)xt=4s2+16

Q: 37. Sketch v, for each network of Fig. 2.181 for the input shown.

A: The diode will conduct only during forward bias so the diode can be replaced by short circuit and du...

Q: 15. Determine the value of RS for the network of Fig. 7.87 to establish V D = 10 V. 16 V Rp 36 k2 2 ...

A: In this question,  Drain voltage is given VD = 10V Find the source resistance Rs?  We know drain cur...

Q: A charge located at the origin in free space produces a fields for which Ez=2kV/m at point P(-2, 4, ...

A:

Q: Q2) By using Kirchhoff's Current Law Find the current through a 122 resistance(I,), and current thro...

A: We need to find current for given circuit

Q: 1. When is a satisfactory common-mode rejection obtained? 2. To what type of circuit does a differen...

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for yo...

Q: Find the even and odd parts of the signal x(t) = sin [- cos (t)] – cos [sin (t)] + (t – 1) (t – 2 7)...

A:

Q: For the circuit in the figure use the superposition theorem and obtain the contribution of the sourc...

A: This question belongs to circuit theory . It is based on the concept of super position theorem in th...

Q: Use Superposition to find the current through resistor R1, given that E = 6.0 V. I-SRC = 6.2 mA, R1 ...

A:

Q: A capacitor branch having a ratio of xC to RC of 5 ohms is paralleled with an impedance consisting o...

A:

Q: 10. A 110-Volt AC line feeds two circuits in parallel. The currents are (2.2 – j6.5)A and(1.8 – j3.5...

A: In this question , two parallel branch voltage and currents are given....We have to find out power c...

Q: For an AM DSBFC transmitter with an unmodulated carrier power, Pc =250 W that is modulated simultane...

A:

Q: Theoretical calculations: 3. How dose the bandwidth change in relation to increasing signal amplitud...

A:

Q: Determine a.  total impedance     b.,. current Ip   and  c. total power drawn by the circuit

A:

Q: 10. A 110-Volt AC line feeds two circuits in parallel. The currents are (2.2 – j6.5)A and(1.8 – j3.5...

A: The solution is given below 

Q: Given waveform of v;, sketch the waveform of v. of the op-amp circuit. Assume that the diodes are si...

A:

Q: Subfrwed the folloeing given yectors firnm A = 30+ j$2 mÁ B = (-395-j ) are another. 14

A:

Q: The power input to a 3 – phase induction motor is 40 kW. The stator losses total 1 kW and the fricti...

A:

Q: A 4-quadrant DC chopper with bipolar switching operating at a switching frequency of 2kHz, is connec...

A: Given R=2 ohm Edc =120 V Eb=50 V