200 kN/m 140 kN I (m) 5 10 7.5 Figure.2: Encastré beam under variety of loads Your tasks are as follows: 1- Construct free-body diagram (FBD) to show the reaction forces and moments, and the equivalent force of the distributed load, knowing that the upward reaction force on left side is 200 kN and the reaction moment is clockwise with a value of 1300 kN.m. 2- Show FBD for each required section/cut and include the internal forces and moments. 3- Write the distribution functions of the shear force and bending moment for each cut in the heam. 4- By hand construct diagrams for the shear force and bending moment distributions. 5- Determine the magnitudces and positions of maximum shcar force and bending momcnt.

200 kN/m 140 kN I (m) 5 10 7.5 Figure.2: Encastré beam under variety of loads Your tasks are as follows: 1- Construct free-body diagram (FBD) to show the reaction forces and moments, and the equivalent force of the distributed load, knowing that the upward reaction force on left side is 200 kN and the reaction moment is clockwise with a value of 1300 kN.m. 2- Show FBD for each required section/cut and include the internal forces and moments. 3- Write the distribution functions of the shear force and bending moment for each cut in the heam. 4- By hand construct diagrams for the shear force and bending moment distributions. 5- Determine the magnitudces and positions of maximum shcar force and bending momcnt.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

When a beam has only uniformly distributed forces applied, the moment diagram consists of piecewise (answer) forces.
Draw the shear force and bending moment diagram for a cantilever beam subjected to uniformly distributed load.
For w = 100lb/ft the resultant concentrated load would be 750 lbs. Where would this force be applied to the cantilevered beam (distance from wall or point A)?
For the loaded beam shown below , Estimate the Reaction Values of supports
Is the flexure formula developed only for beams made of homogeneous material? Why?
Draw the Shear Force and Bending Moment Diagram for the loaded simply supported beam shown below. Ignore the self-weight of the beam
A simplynsupported beam of span 4 m is subjected to a point load of 20 N at its center. Estimate the reactions at its both ends and maximum moment in the beam.
For the beam shown, find the reactions at the supports and plot the shear-force and bending-moment diagrams. Label the diagrams properly and provide values at all key points within the diagrams.
Draw the shear force diagram and bending moment diagram for the beam and loading shown in picture below.
Sketch the shear and bending moment diagrams for the beams below, indicating values of shear force and bending moment at the key points. Use W = 100 N/m and L = 12 m.
Draw the shear and bending-moment diagrams for a simply supported beam AB of span L subjected to a single concentrated load P at its midpoint C
W = 150 lbs. Find horiztonal and vertical support reactions at pin A and pin E. Plesae show all work. Mass of beams is negligible.