21. Given a capacitance of 30 nF and a voltage of 30 J, compute for the charge and energy.
Q: A. The instantaneous If the rms values of voltage and current are 120 V and e power is, (a) 120-/2 c...
A: Instantaneous power Instantaneous power absorbed by an element is defined as the product of the inst...
Q: Q3) Obtain the transfer function C(s)/R(s) for the closed loop system shown figure (2) use signal fl...
A:
Q: (a) (i) If the power supply voltage to the Wheatstone bridge in Figure Q.2a( increased, what will ha...
A: solve ques..1
Q: The synchronous reactance of a generator is 1.0 per unit, and the leakage reactance of its armature ...
A:
Q: (a) Answer the following questions. (i) Explain briefly the main funetion of a power transformer in ...
A:
Q: A transformer is connected as shown bellow: R1 3:1 RL Source voltage Vsupply=120V, R1=5Q RL=2N Trans...
A: In this question we will find total circuit power in given single phase transformer...
Q: The regulation of a 250 volt shunt generator is 6 percent. Calculate the no load voltage.
A: GivenFull load volatge=250 vPercentage of regulation=6%
Q: ) Referring to the waveforms shown in Figure Q1(b), 60 A 60 -20 V Figure Q1(b) (i) Sketch the phasor...
A: Since you have posted the questions with multiple subpart so we are supposed to answer 3 subpart.
Q: Solve the following problems. Use 3 decimal places. Copy the problems. 1. A silver wire has a resist...
A: 1) The resistance of the silver is given as: Rs=ρslsπds2 The resistance of the manganin is given as:...
Q: Find the time constant for the RC circuit in Fig.
A: To solve above question, one should understand the behavior of Inductor and capacitor in DC circuit....
Q: Q4: A system has a characteristic equation s'+ 10s² +2s + 30 = 0. Using the Routh-Hurwitz criterion,...
A: From RH Criteria If sign change happens it conclude that there are poles of RHP so system will be un...
Q: Two equal-valued resistors dissipate a power of 10 W. The resistors are connected in: O Parallel Eit...
A: According to question : When both the resistor are connected in series then same current I will flow...
Q: 2. An inductance of 1 henry and a resistance of 1 ohm are connected in series with a constant e.m.f....
A:
Q: The main difference between transformer and dc motor is O The transformer has a core O The transform...
A:
Q: Given points A=(\rho =5,\phi ={ 70 °},z=-3)A=(ρ=5,ϕ=70 o ,z=−3) and B=(\rho =2,\phi ={ -30° },z=1) f...
A:
Q: A 3-phase star connected alternator is rated at 2000KVA 13.5KV. The armature effective resistance an...
A:
Q: (b) A balanced three-phase delta connected source supplies to a balance three-phase star connected l...
A:
Q: If al is set to Ox05 and ax is set to 0x0007, eax is set to 0x00000020, and rax is set to Ox00000000...
A:
Q: Calculate the inductance (H) of an air cored coil that has a length of 9 cm, a core with rectangular...
A: Consider the formula for the inductance of the air cored coil is, L=μN2Al Here, N is the number of t...
Q: The gate characteristic of an SCR has a straight-line slope of 125. What should be the gate-source r...
A:
Q: (i) Examine reactive power, apparent power and power factor of the Load-3. (ii) Solve the total appa...
A:
Q: A transformer is connected as shown bellow: R1 3:1 RL Source voltage Vsupply=120V, R1=20 RL=20 Trans...
A:
Q: Determine add sketch theout in CK the the in Put vol tage 15VPP. Following cincuit belowIAssume Si N...
A:
Q: A voltage waveform, e(t) = 100 V sin ( 314 rad/s t), is connected across a 5mH pure inductance. Calc...
A:
Q: (a) The unknown low-value resistance (Rx) was measured using an ammeter-voltmeter method with a volt...
A: 5) (a) To calculate the actual value of Rx (unknown low value resistance) measured using an ammeter ...
Q: a) Define the meaning of the balanced three phase system.
A: 3 phase system means the power system which has 3 phases here generally considered by R B Y or a b c...
Q: SP 7: Using superposition, find the current l, in the circuit. 3 kx 42 Io
A:
Q: EI AL IP Зі ↑ 6A
A: Given circuit shown
Q: 20V ov Vin R Vout 8V -10V
A:
Q: 4.32 Consider a 75 kVA, 2400/240 V, 60 Hz transformer. Assume that the open-circuit and short- circu...
A:
Q: 5. Find the branch currents Ii, I2 and I3 using mesh analysis. 6Ω 13 10 Ω 15 V iz 10 V ww
A: Circuit is given as:
Q: 図2j20 J122 201 Zs 25 10-jloSL 回a 回 ZE 248-j6 CALGULATE (A) THE TOTAL IMPEDANGE, (B) THE GURRENT Z3 A...
A:
Q: 16. Calculate the output voltage, Vo, in the circuit of Fig. 14.55. 100 ka V -01 V. 20 ka 400 ka 10 ...
A: This question belongs to analog electronics . It is related to operational amplifier . It is based o...
Q: The voltage phasor diagram for a certain series RLC circuit is shown in Figure below. Find the maxim...
A: Step 1-Given:∆VL=193V∆VC=75V∆VR=124VTo find-∆Vmax(in volt)
Q: Y(s) Q4) For the first order system U(s) (s+1) Find the output response (Y(1) when the input is unit...
A: For the first order system,Y(s)U(s) = 1s+1
Q: Electrical Engineering 40Ω 50Ω. 1502 4V 802 15mA ( T 25Ω. Isos 802 Please solve for the current I5o0...
A:
Q: A 8 pole lap wound armature rotated at 350brpm is required to generate 260V. The useful flux per pol...
A: A DC machine is classified in two types. DC motors DC generators Above question is based on DC gen...
Q: A 4 pole wave wound shunt generator delivers 195A at a terminal voltage of 205V. Ra and Rsh are 0.05...
A: It is given that: Vt=205 VIL=195 ARa=0.05 ΩRsh=70 ΩP=4
Q: Determine the output voltage Vo. The voltage across the LED is 2 volts when forward biased. Vo = VOL...
A:
Q: Analog data contains frequencies from 30 MHz to 70 MHz. We wish to convert this to a digital signal ...
A: Please find the detailed solution in below images. Also the answer is 140 MHz
Q: A thyristor (SCR) structure is a a. N-P-N-P device b. N-P-N device c. P-N-P ...
A: SCR stand for silicon controlled rectifier. It is a device that controls current in only one way. I...
Q: 8: A system has a characteristic equation Find the range of K for a stable system. s + 2s? + (K + 1)...
A:
Q: Calculate the power density at 420watts transmitted through an antenna with a gain of 45 if the surf...
A:
Q: 6-16 The discrete-spectrum signal of Problem 6-4, having components at 1.2 kHz, 3.6 kHz, and 6 kHz, ...
A: If a physical quantity takes only distinct values with gaps between them, it is said to have a discr...
Q: Determine the power density of an antenna with an effective radiated power of 320W and a gain of 24d...
A: Given Radiated power = 320 W Distance, R = 35m Gain in dB = 24. Power density Pd = ?
Q: (C) VD and Vs- (d) VDs- 20. For the voltage-divider configuration of Fig. 6.84, determine: (a) Ipo a...
A: Brief description: Generally the current flowing into the gate terminal of the MOSFET is zero amper...
Q: A 24-V battery is used to supply a 3-carbon type resistor network and two lamps. The connection of t...
A: This question belongs to network theory . It is based on the calculation of total resistance and tot...
Q: Draw the time domain representation of amplitude modulated signal with proper scale and modulation i...
A: Brief description: Modulation is one of the important technique in the communication system where on...
Q: 19. What is the total power of two resistances connected in series with individual power of 10 and 2...
A:
Q: 2. Calculate l, in the 2ohms resistor using Norton's Theorem. 10 A 20 V 0לל load
A:
CR1: ANSWER 21
Trending now
This is a popular solution!
Step by step
Solved in 2 steps with 2 images
- Determine the electric field strength at a point 1.00 cm to the left of the middle charge shown in the figure below. (Enter the magnitude of the electric field only.) Three charges lie along a horizontal line. A 6.00 µC positive charge is on the left. 3.00 cm to its right is a 1.50 µC positive charge. 2.00 cm to the right of the 1.50 µC charge is a −2.00 µC charge. N/C(b) If a charge of −3.89 µC is placed at this point, what are the magnitude and direction of the force on it? magnitude N direction ---Select--- toward the right toward the left upward downwardTo the right of the infinite sheet with a surface charge density of a= 5.0nC/m², there is an infinitely sized conductive sheet with a thickness of 20.0 cm at a distance of 3.0m. If the position of the leaf is taken as X=0, (you can get k=9x109 ) a) Electric field at X=-1.0m b) Electric field at X= 4.0mc) What is the electric field at X= 3.10m?An electron moves east in a uniform 14 N / C electric field directed west. At point A, the velocity of the electron is 8 * 10⁵ m / s to the east. What is the speed of the electron when it reaches point B, 75 m east of point A?
- 1) A source charge gives rise to an electric field. At one particular point in space, the magnitude of the electric field due to this source charge is 1500 N/C. A +12 nC test charge is placed at this point. How will the magnitude of the electric field change if the +12 nC test charge is replaced by a +24 nC test charge?What is the field strength (volts per meter) in free space for a test charge located 1000 m from a charge of 0.001 CTwo 2.00-mC charged particles are located on the x axis.One is at x 1.00 m, and the other is at x 1.00 m.(a) Determine the electric field on the y axis at y0.500 m. (b) Calculate the electric force on a 3.00-mCcharge placed on the y axis at y 0.500 m.
- A bar of length L = 0.2 has a charge Q = 30 nC, determine at what distance (if any) from its center the electric field is 100 N / C.lectric field is the product of the electrostatic constant and a point charge divided by the square of its distance from a charge. If a point charge of 2.5 nanocoulombs is 5.5 x 10 ^-3 meter from a charge, calculate force exerted by the electric field. (note: electrostatic constant is 8.99×10^9N⋅m^2/C^2)Sketch the electric field lines in the vicinity of two opposite charges, where the negative charge is three times greater in magnitude than the positive.
- What is the electric field 2 m away from the infinite long linear charge with uniform charge density pl (C / m)A series of six infinite charged sheets are placed on positive x-axis at a distance of 5 micro m with each other. Consider the first sheet is placed at x=0. The third sheet is grounded. Electric 5x10 N/C and is uniform in the region. Calculate the potential at the first sheet and the last sheet respectively A series of six infinite charged sheets are placed on positive x-axis at a distance of 5 with each other. Consider the first sheet is placed at x=0. The third sheet is grounded The Electric field is 5x10' N/C and is uniform in the region. Calculate the potential at the first sheet and the last sheet respectively. (a) -5 V and 7.5 V (b) 5 V and - 7.5 V (c)-7.5 V and 5 V (d) 7.5 V and -5 VA long horizontal wire contains a current such that 9.0✕1018 electrons per second flow through any given point from left to right. Determine the (a)current and(b)magnitude of the field of the long wire at a point 10 mm parallel to it in the north