2200 7.5katt 10 Kz Draw the out Put waveT

Q: Calculate the following values of a 4-bit ADC with Vin = 0.6v and Vr = 1.2v. %3D • Determine the…

A: It is given that: 4 bit ADC Vin=0.6 VVr=1.2 V

Q: 1) (a) Find the input impedance of the circuit in Fig. using the concept of reflected impedance. (b)…

A: Please refer the attached images for the complete answer..

Q: 1on 182 A2 A AL Ith

A: Any electrical circuit comprises of resistors, inductors and capacitors. A source, either voltage or…

Q: differential equation

A:

Q: Using the block diagram reduction technique, determine C/R for the block diagram shown below. and…

A: In this question we will find transfer function using block diagram reduction technique and verify…

Q: 4.Show a general mathematical expression which is appropriate to describe a one-dimensional…

A: We need to show a general mathematical expression which is appropriate to describe a one-dimensional…

Q: Measured R (2) (No Power) Voltage (V) Current (A) Calculated R (S2) (Powered) 2.5k2 3V 1.2mA 2.5kQ…

A: The solution is given below

Q: 16) Assume a battery can be modelled by a 9 V source and a series resistance of 1.8 N. What is its…

A:

Q: sing the Circuit below, determine the following: 1. The Power taken by the 3 ohm resistor 2. The…

A: We need to find out voltage and current and power for given circuit

Q: iii) full load rot

A:

Q: 1. The following sequences x(n) and h(n) are given: x(n) = 35(n) + 75(n+2) - 100(n-1) + 50(n-2) %3D…

A:

Q: 2) An NMOS device of gate dielectric (k=10.2) thickness 53nm and W/L ratio of 1 biased at Vd=0.07v…

A:

Q: a) Design a Butterworth band-pass filter using the TL084 amplifier and draw it with the following…

A: Filter is a device that process the signal and gives desired output. It can be active or passive and…

Q: Consider a family of logic gates that operates under the static discipline with the following…

A: According to the question, we need to find noise margins The data are given as the following voltage…

Q: Discuss how a very large electric field is generated by using an Induction coll

A: Discuss how a very large electric field is generated by using an induction coil.

Q: $1= 30/0° Amperes S, = 220 20° Volts USE MESH ANALYSIS to get: a. 11, 12, 13, b. lo c. V3 and P3…

A: Note : i) Frequency is not given,  we assume frequency =50 Hz ii) Current I2 is in all three loops…

Q: 3. For the emitter-stabilized bias circuit, determine: a. IBQ b. ICQ с. VСEQ 20ν

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: What is the use of Pin 7, 9 (Set 2 and Set 1) and Pin 4,12 (Reset 1 and 2) How to connect these…

A: According to the question, we need to explain the work of the pin number (7, 9) & (4, 12) of the…

Q: 6. I= . E= 200 V- R, = 150 0 R2 = 3000

A: The solution is given below

Q: 5.33.1 For the circuit involving an ideal op amp shown in the image below, if R1 = 21 k2, R2 = 24…

A:

Q: In installing a telephone system in a building, PABX is used up to the riser (conduit is used) and…

A: It is mentioned that in installing a telephone system in a building, PABX is used up to the riser…

Q: Using a uniform illuminated parabolic reflector, calculate the half power beamwidth for an antenna…

A: The solution is given below

Q: 1. R,=". %3D Ry = 100 Ω %3D R2= 50 Ω R3 =50Ω

A:

Q: a) Define the term "Switching Circuit". State the application area that the switching circuits are…

A: Solve the first question, unless the student has asked for a specific question to be solved, subject…

Q: For the circuit involving ideal op amps shown in the image below, if R1 = 11 k2, R2 = 11 kS2, R3 =…

A:

Q: MUX 1 S1 S2

A: The solution is given below

Q: 5.21 For the circuit involving an ideal op amp shown in the image below, if R1 = 6 k2 and R2 = 13…

A:

Q: Given the following circuit, determine: (a)The secondary peak voltage.

A:

Q: 3. Write each of the following numbers in the form of a + bi a) cos(3 – i) b) 2i sin h (4 – Tni)

A: a) Given  cos(3-i)

Q: Problem solving 1. A building has 21 housing units. Each housing unit has the following circuit…

A: Given: A building has 21 housing units. Each housing unit has the following circuit specification:…

Q: (b) An input x(t) as in Figure Q1(a) is passed through an LTI system with impulse response given by…

A:

Q: A load impedance given by Z1. = 100 –-ji00 2 is con- nected through a kossless transmission line…

A:

Q: b) Design a circuit using a single op amp to generate the following output, vo - | (4v, + 2v2 +…

A: Disclaimer: "Since you have asked multiple question, we will solve the first question for you. If…

Q: Use Kirchhoff's Laws to solve the branch curents in the network below. I1 a I2 4230°. I3 b 1Ω Is 2Vx…

A:

Q: phase sequence, determine: a) Va'b' b) Va"b" a 0.5 + j1.5 N 0.8 + j2N b' b" 0.5 + j1.5 N 0.8 + j2 N…

A:

Q: Find the transfer function from input voltage e; to the output voltage e, across e 0.5 H inductor…

A: We need to find transfer function for given circuit

Q: 12 10 L90 1S Lo Za = 5 ohms Zb= 3-j4 ohms Zc= 2 ohms Zd 12 ohms V1= 20 angle 0 V2 = 10 angle 90 V3 =…

A:

Q: 1) The magnitude of the resultant flux in two phase supply system is equal to: A. В. Pm C. Pm D. m…

A: Since you have asked multiple objective questions , so we will solve first three question for you.…

Q: 2. Find the transfer function T(s)=Y(s)/R(s) of a signal flow graph shown in Fig. 2 using Mason's…

A: We need to find transfer function for given signal flow graph

Q: (given: R1= 1kN, R2= 10kn, C1=20µF and C2=5µF) R: Fig. 1

A:

Q: ) A 128-bit parallel binary adder is to be constructed using Full Adderblocks only. How many Full…

A: A n-bit parallel adder requires n full adders to perform the operation.

Q: Design a combinational logic circuit whose input is a four-bit number and whose output is the 2's…

A: Combinational circuit: It is a digital circuit and its output is dependent on the combination of the…

Q: 10. A capacitor has 12 V across it with 3 mA of current. How much is the Xc ( in rectangular form )?…

A:

Q: Find the output of the following circuit 33 kf2 10 kf) Vout

A:

Q: 9. For the connected graph below 10 12 Us select tree T- {2,3, 4, 6, 7, 10 } and find matrices (a)…

A:

Q: A 440 V, 3-phase, 50 Hz, 4-pole, Y-connected induction motor has a fu the rotor has an impedance of…

A:

Q: 14-13 Some common parameters for several types of coarial cable are a characteristic impedance of 50…

A:

Q: 3. Given: Cox = 10 fF/um² W= 5um L= 0.lum Ves- VTH 1 V Vos =0 Find : total charge stored in channel,…

A: We need to find out charge for given details

Q: 1) Given vector A 6ax + ay, express A in cylindrical and spherical base vectors. 21 Given vector A =…

A: In this question vector A is given....We have to convert it in different coordinate system.....…

Q: raw the energy band diagram of a p-n-p* bipolar junction transistor. Show all the relevant energies…

A: We need to draw the energy band diagram of a p-n-p+ bipolar junction transistor. We need to show all…

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.