(3 4" 30 m Blower 40 m

Q: The cylindrical container in Fig. is 20 cm in diameterand has a conical contraction at the bottom…

A: Goven that,

Q: P6.32 SAE 30 oil at 20°C flows in the 3-cm-diameter pipe in Fig. P6.32, which slopes at 37°. For the…

A:

Q: Keystone Pipeline has a diameter of 36 inches and a design flow rate of 590,000 barrels per day of…

A:

Q: Water flocks from a large tank through an orifice of 75 mm diameter and against a block, as shown in…

A: To find: The minimum height to which water must rise in the tank in order to start the block moving…

Q: Q8. Considering frictionless, incompressible, one- dimensional flow of water through the horizontal…

A:

Q: A 15 mm x 250 mm x 100 mm woodblock weighing 10 N is struck by a water jet of 20 mm diameter as seen…

A: Given data: The weight of the block is W = 10 N. The diameter of the water jet is d = 20 mm. The…

Q: Two reservoirs, which differ in surface elevation by 40 m,are connected by 350 m of new pipe of…

A: Write the given Data:

Q: Q5: A smooth pipe of diameter 400 mm and length 800 m carries water at volumetric flow rate 0.04…

A: Given data Diameter of pipe = 400 mm = 0.4 m Length of pipe = 800 m Volumetric flow = 0.04 m3/s…

Q: Required information Assume that r = 0.149 m, ro = 0.15 m, µ = 1.49 kg/m-s (glycerin), p = 1260…

A: Calculated the inner shear stress in Pa.

Q: A water tunnel test section has a 1-m diameter and fl owproperties V = 20 m/s, p =100 kPa, and T…

A: The properties of water at T= 20 oC are given as, The diameter of the water tunnel is given as,…

Q: The tank–pipe system of Fig. is to deliver at least11 m3/h of water at 20°C to the reservoir. What…

A: The properties of water at 20 degrees Celsius are: The velocity of water inside the pipe can be…

Q: A 3-ft-diameter duct is used to carry ventilating air (p = 2.373 x 10-3 slugs/ft,v = 1.57 × 10-4 ft…

A:

Q: : The pipe flow in Fig. 2 is driven by pressurize eded to provide water flow rate Q =75 m³/h?. T…

A:

Q: Estimate the diameter of the chimney as per the data given below: Mass of flue gases flowing through…

A:

Q: 3. Water at 20°C is to be pumped from reservoir 1 to 2 in a 6-in-diameter asphalted cast iron pipe…

A: The power required by the pump to displace fluid from a place to another can be calculated using the…

Q: estimate the allowable distance Y if the allowable pressure in the systems is -18kPa (gage). aasume…

A:

Q: An 11.5-in-diameter centrifugal pump, running at1750 r/min, delivers 850 gal/min and a head of 105…

A:

Q: ater flows through a horizontal 150 − ?? pipe under a pressure of 414 ???. Assuming no losses,…

A:

Q: The pipe fl ow in Fig.  is driven by pressurized air inthe tank. What gage pressure p1 is needed to…

A: Given Data: The flow rate is: Q=60 m3/h. The diameter of the pipe is: d= 5 cm. The head at pipe…

Q: A Keystone Pipeline has a diameter of 36 inches and a design flow rate of 590,000 barrels per day of…

A: Given: Diameter of pipeline =36 inch Diameter of pipeline=3 ft.                  Flow rate =590,000…

Q: The reservoirs in Fig.  are connected by cast iron pipesjoined abruptly, with sharp-edged entrance…

A: Given data: The diameter of pipe 1 is d1=1 in. The length of pipe 1 is l1=20 ft. The diameter of…

Q: For the system-Water at 20°C flows by gravity through a smooth pipe fromone reservoir to a lower…

A: Write the given data: L=360 mhf=60 mQ=90 m3/h=0.025 m3/s2.7×10-4 m3/s1 m3/hfor T=20 °ρ=998…

Q: 9.50. When 0.28 m³/s of water flow in a 0.3 m pipeline, 63 kW are lost in friction in 300 m of pipe.…

A:

Q: For flow of water at 20°C through a straight, smooth pipe at0.06 m3/h, the pipe diameter for which…

A: Provided the water have the temperature of 20 deg Celsius and have a volumetric flow rate or…

Q: A rectangular sheet-metal duct is 200 ft long and has afixed height H = 6 in. The width B, however,…

A: Given For air at 20oC

Q: A pump delivers 1 hp to a water at 68°F flowing in a 10-in-diameter horizontal, cast iron pipe at V…

A:

Q: Water fl ows steadily through the box in Fig. P3.63. Averagevelocity at all ports is 7 m/s. The…

A: Given Data: The velocity at port 1 is V1 = 7 m/s. The velocity at port 2 is V2 = 7 m/s. The…

Q: Air at 20°C and 1 atm flow past a long flat plate, at the endof which is placed a narrow scoop, as…

A: Write the properties of air at a given temperature value. Determine the Reynold number for the…

Q: 2. Corsider a horizontal 120 cm-diameter galvanized-iron pipe simuating the Alaskan pipel ine. The…

A: We have given

Q: Q2) A flocculation basin has dimensions of 17.4m length, 11.4m width , and 5.8m depth, with three…

A: Given Data17.4mw=11.4md=5.8mμ=1.139×10-3N.s/m2ρ=999.1kg/m3CD=1.8 ***As per our company policy we are…

Q: The pump in Fig. is used to deliver gasoline at 20°Cthrough 350 m of 30-cm-diameter galvanized iron…

A: Given, T1 = 20°C L = 350 m D = 30 cm = 0.3 m Q =? Considering Properties of Gasoline at 20°C,ρ = 680…

Q: The back pressure of the worst operating condition of a fixed geometry wind tunnel (pox= 120 kPa,…

A: Given data: pox=120 kPaAnt=0.9 m2Aduct=1.5 m2Ae=1.9 m2 Need to determine the back pressure of the…

Q: estimate the allowable distance Y if the allowable pressure in the systems is -188kPa (gage). aasume…

A: This problem is related to fluid mechanics. Fluid mechanics is the subject of mechanical engineering…

Q: Two reservoirs are connected by 198ft of 2-in diameter tubing. What is the flow rate when the…

A:

Q: A horizontal pipe bend with a deflection angle of 120o has an entrance diameter of 300 mm and exit…

A:

Q: Two horizontal pipes in series , each 1000 ft long and discahrges water at the rate of 4.75 ft^3/s,…

A:

Q: A number of straight 25-cm-long microtubes of diameter dare bundled together into a “honeycomb”…

A: Given: The cross-sectional area of the honeycomb is Ab=0.0006 m2. The length of the tube is L=25…

Q: Water at 20 ° C is to be siphoned through a tube 1 m longand 2 mm in diameter, as in Fig. . Is there…

A: Draw the diagram for the problem. Here, the points 1 and 2 indicate the points in the siphon as…

Q: Water at 20 ° C flows steadily through the piping junction inFig. P3.32, entering section 1 at 20…

A: Assume the whole section is a control volume. Therefore, the inlet discharge into the control volume…

Q: 8. Ahorizontal pipe has a non-negligible expansion (K, = (1 Asmall Atarge as shown in the figure.…

A:

Q: P.4.10 Oil of viscosity 10 mNs/m? and specific gravity 0.90, flows through 60 m of 100 mm diameter…

A:

Q: Calculate the hourly energy cost for pumping riverwater at 288.706K, from a river to a hilltop,…

A:

Q: irstream flows in a converging duct from a cross-sectional area A1=50cm2 to across-sectional area…

A: Given  at inlet A1= 50 cm2 T1= 300 K V1=100 m/sec P1= 300 kPa A2= 40 cm2

Q: A blower supplies standard air to a plenum that feeds twohorizontal square sheet-metal ducts with…

A: Consider all units in British.  This question is solved with the help of energy equations.  As we…

Q: A necked-down section in a pipe flow, called a venturi,develops a low throat pressure that can…

A: Solution: D1=diamter at throat (section 1)D2=diameter of pipe (section2)ρ=density of water The…

Q: Water at 20°C fl ows through a pipe at 300 gal/min with afriction head loss of 45 ft. What is the…

A: GIVEN:Q=300gal/minhead loss h=45ft

Hydronics