A Keystone Pipeline has a diameter of 36 inches and a design flow rate of 590,000 barrels per day of crude oil at 40ºC. Estimate the pump horsepower required if the length of the pipe is 2.9 mile(s). The pipe material is new steel. For crude oil at 40ºC, take  μ ≈ 0.0053 kg/m-s ÷ 47.88 = 0.0000111 slug/ft-s. The density, with SG = 0.86, is 0.86(1.94) = 1.67 slug/ft3. Take f ≈ 0.0155.

Q: Oil of viscosity 10E-3 Pa-s and specific gravity 0.90, flows through 60 m of 100mm diameter pipe and…

A:

Q: 1. A research experiment requires a laminar flow of water at 20°C through a 120mm diameter pipe at a…

A:

Q: Oil (sg=0.90, v=0.0003m^2/s) enters a 50mm diameter tube. Estimate the entrance length if the flow…

A:

Q: Keystone Pipeline has a diameter of 36 inches and a design flow rate of 590,000 barrels per day of…

A:

Q: 5. Water at 50C flows in a 150-mm diameter pipe with a velocity of 6.5 m/s. The surface roughness of…

A:

Q: A pipeline connecting ten tanks contains 10 standard long elbows, 5 globe valves that is half open,…

A: Diameter of pipe d=40 mmL= 200 m μ=.99mNm-2sρ=998 kg/m3m˙=4000 kg/hrf=.0032

Q: A water tank used for fire fighting is shown in the figure. A fire extinguishing installation was…

A: (1) It is given that, The total length of the pipe is Apply Bernoulli's equation between section 1…

Q: Q5: A smooth pipe of diameter 400 mm and length 800 m carries water at volumetric flow rate 0.04…

A: Given data Diameter of pipe = 400 mm = 0.4 m Length of pipe = 800 m Volumetric flow = 0.04 m3/s…

Q: 21. A 29 cm diameter pipe carries oil of specific gravity 0.9 at the rate 135 lit/sec and the…

A: Given data: Diameter of the pipe, d=29 cm=0.29 m Specific gravity of the oil, s=0.9 ⇒Density of the…

Q: A pipeline connecting ten tanks contains 10 standard long elbows, 5 globe valves that is half open,…

A: Given, Q = 4000 kg/h f = 0.0032   Velocity of flow,  V = QA=4000998×3600π4×0.0402= 88.597 m/sec…

Q: Considering pipe loss only, how much head is required to deliver 0.222 m³/s of heavy fuel oil at…

A:

Q: turbulent flow of a fluid in 0.6m diameter pipe, the velocity 0.15m from the wall 2.7m/s. Estimate…

A:

Q: The rate of flow of water in a 150 mm diameter is measured with a venturi meter with a 50 mm…

A: Given: The diameter of the pipe, D = 150 mm The diameter of cone at throat, d = 50 mm The pressure…

Q: (4) What pressure drop is required in order to pump water at 20°C through a pipe 25 cm in diameter…

A:

Q: Given a frictionless flow of water at 125.6 ft^s in a long, horizontal, conical pipe, of diameter 2…

A:

Q: Water of density 1000 kg/ m³ and kinematic viscosity 1.022 X 106 m²/s, is pumped between two…

A:

Q: The present pumping rate of North Slope crude oil through the Alaska Pipeline is about 600,000…

A: Given data: d=48 inchesρ=860 kg/m3μ=0.0040 kg/m.s Need t0 determine the maximum flow rate.

Q: Water flows at an average velocity of 10 m/s through a horizontal tube of diameter 5 cm. The…

A: Note: Since you have posted a question with multiple sub-parts, we will solve first three sub- parts…

Q: It is desired to deliver 60 m3/h of water at 20°C through ahorizontal asphalted cast iron pipe.…

A: Given: The length of the pipe is L=100 m. The pressure drop in the pipe is ∆P=40 kPa. The volume…

Q: A pipeline connecting three tanks contains 10 standard long elbows, 5 globe valves that is half…

A:

Q: 9. Glycerin (SG = 1.26) and µ = 1.49 Pa.s) flows through a rectangular conduit 300 mm by 450 mm at…

A:

Q: 9.50. When 0.28 m³/s of water flow in a 0.3 m pipeline, 63 kW are lost in friction in 300 m of pipe.…

A:

Q: Sketch the shear stress and velocity distribution for laminar flow across a pipe section?

A:

Q: 2. A pump is required to deliver water to an elevated storage tank. The water must be raised 44 m,…

A: Please find the solution below

Q: estimate the distance X required to obtain a volume flow rate of 7.1 x 10^-3 m^3/s.

A: Given: The flow through pipe, Q = 7.1x10-3 m3/s The diameter of pipe, D = 50 mm = 0.05 m The…

Q: (4) What pressure drop is required in order to pump water at 20°C through a pipe 25 cm in diameter…

A: 4 ) given data  Pipe dimension  Diameter = 25cm  Length = 1234m  Flow rate = 1.97 m2 sec -1  Pipe…

Q: Water at 20°C fl ows by gravity through a smooth pipe fromone reservoir to a lower one. The…

A: Given data:  For Water,                     at   20°C , ρ = 998 kg/m3 , μ = 0.001 kg/m-s…

Q: The pressure drop, due to the head and minor losses, between the two ends of a horizontal pipeline…

A:

Q: A 25cm circular pipe carries 0.16m3 /sec of water under a pressure of 200Pa. The pipe is laid at an…

A: Gieven ,  mass flow rate Q =0.16 m3/s diameter of pipe  = 25  cm Pressure , P =200 pa elevation…

Q: 8. Crude oil flow through a level section of the Alaskan pipeline at a rate of 2.94 m³s'. The pipe…

A: Given: Volume flow rate of the crude oil→Q=2.94 m3sec inside diameter of the pipe→D=1.22 m so area…

Q: Ethylene glycol at 20°C flows through 125 meters of cast iron pipe of diameter 6 cm. The measured…

A:

Q: (4) What pressure drop is required in order to pump water at 20°C through a pipe 25 cmin diameter…

A: Given data: -  The length of the pipe is L = 1234 m. The diameter of the pipe is D = 25 cm. The…

Q: length = 10cm diameter = 4mm length = 10cm diameter =1mm length = 10cm diameter = 4mm diameter = 1mm…

A: Given: velocity at the inlet→V1=0.5 ms Diameter of the inlet pipe→D1=4mm=0.004m Hence area of the…

Q: A pipe of unknown type, length and diameter includes a threaded union (KL = 0.08), 90° %3D threaded…

A: Given data  minor loss coefficients for threaded union = 0.08  minor loss coefficient for 90o…

Q: Oil of density 950 kg/m³ and viscosity 1E-2 Pas is to be pumped 10 through a pipeline and the…

A:

Q: Rate the flow inside a pipe with Re = 1.8x10^4 and ε/D = 0.027

A: The quantity of surface roughness inside the pipe is referred to as relative roughness. The…

Q: After analyzing the flow type in a refinery oil (s = 0.8, v= 1.94x10-4 ft2/s) flowing through a…

A: Given, diameter, d=9inch=0.75ftspecific gravity, s=0.8density, ρ=800kg/m3=49.94lbm/ft3kinematic…

Q: Calculate the hourly energy cost for pumping riverwater at 288.706K, from a river to a hilltop,…

A:

Q: In the design of a 500m long water pipeline it is proposed to keep head loss, hf, less than 6m for a…

A:

Q: Air flowing horizontally at a speed of 100mph through a duct 4 sq.ft in cross-section. The duct…

A:

Q: Oil of density 950 kg/m and viscosity 102 Ns/m2 is to be pumped 10 km through a pipeline and the…

A: Given data: Density of oil is, ρ=950 kg/m3 Viscosity of oil is, μ=10-2 N·s/m2 Length of pipeline,…

Q: A flow of 0.20 ft3/s of glycerine (sg=1.26) passes through a 4-in-ductile iron pipe. At 100 °F, the…

A:

Q: A pipe system, connecting two reservoirs whose difference in water surface elevation is 13 m,…

A:

Q: (2) It is desired to deliver 60 m'/hr of water at 20°C through horizontal asphalted cast iron pipe.…

A: This problem is solved by using iterations by assuming the pipe diameters. Write the given data.…

Q: Air flows through a duct at 2,700 cubic feet per minute (CFM). After several feet and a few vents,…

A: The Answer is Below

Q: 6. A 6 250 m long, 914 mm (inside diameter) cast iron pipeline connects an upstream reservoir (water…

A: The vehicle of liquid in a shut conductor is critical in our day by day tasks. A concise thought of…

Properties of Fluids

The term fluid represents a type of substance that can easily change its shape under any external pressure/force and can flow. Fluids can acquire any shape in which it is stored and can resist normal stresses but cannot resist shear stress in rest condition. Whenever external shear stress is applied to fluids, it starts to flow. The fluids may be liquid or gas. Example- water, air, etc.