(3) Overall Momentum Balance Equation A horizontal turbulent liquid jet of diameter Dand average velocity v, impinges on a vertical plate mounted on a cart, thus exerting a force F on a plate, as shown in Fig. P1.4-3. Determine the opposing force needed to keep the plate moving at a constant velocity v, (< v). Neglect the viscous and gravity forces. (Hint: Let the control volume Q move with the plate) Plate Nozzie Jet Cart

(3) Overall Momentum Balance Equation A horizontal turbulent liquid jet of diameter Dand average velocity v, impinges on a vertical plate mounted on a cart, thus exerting a force F on a plate, as shown in Fig. P1.4-3. Determine the opposing force needed to keep the plate moving at a constant velocity v, (< v). Neglect the viscous and gravity forces. (Hint: Let the control volume Q move with the plate) Plate Nozzie Jet Cart

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A belt moves upward at velocity V, dragging a fi lm ofviscous liquid of thickness h , as in Fig. . Near the belt,the fi lm moves upward due to no slip. At its outer edge, thefi lm moves downward due to gravity. Assuming thatthe only nonzero velocity is υ ( x ), with zero shear stress atthe outer fi lm edge, derive a formula for ( a ) υ ( x ), ( b ) the average velocity V avg in the fi lm, and ( c ) the velocity V c forwhich there is no net flow either up or down. ( d ) Sketchυ ( x ) for case ( c ).
A 3-in diameter horizontal water jet having a velocity of 140 ft/s strikes a curved plate, which deflects the water 180 degrees at the same speed. Ignoring the frictional effects, determine the force required to hold the plate against the water stream. Please no conversion need it, only the 3in into .25feet, please. for me, I got 3.71KN on the x-axis.
In Fig. water exits from a nozzle into atmosphericpressure of 101 kPa. If the manometer fl uid has a specifi cgravity of 1.6 and h = 66 cm, with friction neglected, whatis the average velocity at section 2?( a ) 4.55 m/s, ( b ) 2.4 m/s, ( c ) 2.95 m/s, ( d ) 5.55 m/s, ( e ) 3.4 m/s
Consider Fig. P3.36 as a general problem for analysis of amixing ejector pump. If all conditions ( p , ρ , V ) are knownat sections 1 and 2 and if the wall friction is negligible,derive formulas for estimating ( a ) V 3 and ( b ) p 3 .
The bottom of a river has a 4-m-high bump that approximates a Rankine half-body, as in Fig. The pressure at point B on the bottom is 130 kPa, and the river velocity is 2.5 m/s. Use inviscid theory to estimate the water pressure at point A on the bump, which is 2 m above point B.
can u explain questions Q3 more clearly and am I able to apply the momentum formula ?
In Prob. it would be difficult to solve for Ω because of itappears in all three of the dimensionless pump coefficients.Suppose that, in Prob. 5.61, Ω is unknown but D = 12 cmand Q = 25 m 3 /h. The fluid is gasoline at 20 ° C. Rescale thecoefficients, , to make a plot ofdimensionless power versus dimensionless rotation speed.Enter this plot to find the maximum rotation speed Ωforwhich the power will not exceed 300 W.
Assume an inviscid, incompressible flow. Also, standard sea level density and pressure are 1.23 kg/m3 (0.002377 slug/ft3) and 1.01 × 105 N/m2 (2116 lb/ft2), respectively. Show that a source flow is a physically possible incompressible floweverywhere except at the origin. Also show that it is irrotationaleverywhere.
An 8-in model pump delivering 180°F water at 800 gal/minand 2400 r/min begins to cavitate when the inlet pressureand velocity are 12 lbf/in2 absolute and 20 ft/s, respectively.Find the required NPSH of a prototype that is4 times larger and runs at 1000 r/min.
A hole is placed in the front of a cylinder to measure thestream velocity of sea-level fresh water. The measuredpressure at the hole is 2840 lbf/ft2. If the hole is misalignedby 12° from the stream and misinterpreted as stagnationpressure, what is the error in velocity?
A liquid jet of velocity V j and diameter D j strikes a fi xedhollow cone, as in Fig. P3.47, and defl ects back as a conicalsheet at the same velocity. Find the cone angle θ for whichthe restraining force F = 3/2ρAjVj2 .
tall water tank discharges through a well-rounded orifi ce,as in Fig. P3.95. Use the Torricelli formula to estimate the exit velocity. ( a ) If, at this instant, the forceF required to hold the plate is 40 N, what is the depth h ?( b ) If the tank surface is dropping at the rate of 2.5 cm/s,what is the tank diameter D ?