3- Using the appropriate graph, explain the charging and discharging paths in a stable 555 timer.

Q: Jon 2: 1. Which TTL level closes the analog switch and which opens it?

A: Transistor - Transistor is abbreviated as TTL It has two states low and high

Q: Differentiate between MCB and kit kat fuse

A: MCB : MCB stands for miniature circuit breaker it is a electrical device in such way that it…

Q: Define LED chaser. Explain briefly in own understanding.

A: LED chaser: An LED driving circuit is made up of a light chaser. It is made up of a series of LEDs…

Q: How would you design a fuse protection system? Choose the right answer with justification: a)…

A: We need to answer how efficiently we can design a fuse protection system for PLC's.

Q: Applications and advantages for Timer for Home Appliances in Peak Hours?

A: It is required to discuss about the application and advantages for timer for home appliances in peak…

Q: Explain the working of LVDT sensor with a neat diagram.

A:

Q: List three factors that would contribute to a variation between calculated and measured values.

A: There is various factors which contribute to cause in measured value .  Fualty equipment  Wrong…

Q: Please I want a table of comparisons between plc & Dcs & scada

A: Comparison between PLC, Dcs and Scada, PLC…

Q: Compare 5 different PLC brands/models and 5 HMI brands/models? Note: Sir, if you write on the…

A: Given: Compare 5 different PLC brands/models and 5 HMI brands/models.

Q: Q.1) What is the type of PCI transaction diagram? Redraw the timing when the IRDY# and TRDY# is…

A: We are authorized to answer one question at a time since you have not mentioned which question you…

Q: 5. When rewinding an audio or video cassette tape, why does the tape rewind faster at the end?

A: when rewinding an audio or video cassette tape , why does the tape rewind faster at the end?

Q: Calculate the dynamic range and resolution of a 14-bit, 6 volt ac ADC.

A: Given values are =

Q: Complete the timing diagram for the circuit until the arrow: CLK

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Identify and describe the working of a Smart Sensor for a Automated home lighting systems

A:

Q: A LED which bright

A: Diode- When diode is forward biased it is short circuited in a circuit ideally. When diode is…

Q: Discussions: - 1) Explain the difference in operation of 555 timer between an astable mode and a…

A: The differences in the operation of the 555 timers between the astable mode and monostable  mode are…

Q: Describe the Charging a Compressed Air Storage System.

A: Describe the Charging a Compressed Air Storage System.

Q: Explain the working of digital storage oscilloscope type recorder with a neat diagram.

A: to explain the working of digital storage oscilloscope type recorder with a neat diagram

Q: Which of the following is a programmable peripheral interface? Select the correct response: 82A59C…

A: Answer:option:-4 82C55A

Q: If control requirements are very complex or extensive, a? Can be installed. A. Master sequencer…

A: If control requirements are very complex or extensive ........... Can be installed

Q: Describe the following relay logic diagram (RLD) symbols for timers functions. А. В. С. D.

A:

Q: Q1) List the procedural steps taken by the microcontroller when a call to service routine was…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Define minterms.

A: A Minterm of n factors is a result of the factors in which each shows up precisely once in evident…

Q: er the following questions (answers to be typed, handwritten answer for this question will not be…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: About the electrical circuit using the ladder diagram (PLC Ladder)? 24G 4 G

A:

Q: 1) What is a PLC? In what position is it used in the SCADA system?

A: PLC stands for Programmable Logic Controller. It is a ruggedized computer used for industrial…

Q: Write 8051 program to receive bytes of data serially and put them in P1, Set the baud rate as 9600,…

A:

Q: Write information about timer (IC NE555). Note: Please do not handwritten.

A: The following is the answer for the question

Q: Design a timer555 ,which should turn ON the relay immediately after pressing a push button and…

A: Q6 Monastable multiuibrator using 555 times-Monostable multiuibrator implemented using the 555 IC…

Q: Which 1 below is NOT PLC's configuration types Modular Unitary O Rack mounted Automation O

A: Asked that which one below is NOT PLCs configuration types

Q: Construct the code segment in order to keep the LED array blinking on and off in an infinite loop.…

A: The 8086 micro processor is a 16 bit micro processor. Its address bus is 20 bits and data bus is 16…

Q: What is the meaning of the following abbreviations : PAM, PDM, PPM

A: According to the question we have to discuss about PAM, PDM, PPM.

Q: Convert decimal to binary. Show detail calculation 150; 82, 34

A: To convert decimal number in binary number, divide the decimal number by 2 till the remained less…

Q: Using Timer Interrupt, Write the code of the microcontroller program for Arduino IDE for a system…

A: According to the question, we need to write the code for the microcontroller program for Arduino IDE…

Q: Why can a 555 timer IC be said to be in monostable mode?

A: The 555 timer IC is an 8-pin robust electronic device. It can be operated as Astable Multivibrator,…

Q: Explain the construction and operation of CRO with diagram.(write by computer)

A: CATHODE RAY OSCILLOSCOPE:   CRO is used to display, measure and analyze various types of wave forms…

Q: Discuss: Include how the output voltage is produced in LDR, then how the ouput voltage is produced…

A: Include how the output voltage is produced in LDR, then how the output voltage is produced in 555…

Q: constellation diagram for 9600 bps modem

A: Given that,      Rb=9600 bps

Q: Explain how the PACA can be set up to measure the duration of a pulse using the gated time…

A: A pulse accumulator counts how many active edges are present at the input of its channel. PACA is a…

Q: Identify and Explain with neat sketch of the Digital Storage Oscilloscope,

A: The digital storage oscilloscope is an instrument which gives the storage of a digital waveform or…

Q: 01: Discuss the principle of operation of the (Synchro) and the (Resolver) machines, then choose and…

A: The synchro and the resolver is electrically similar to the transformer and mechanically similar to…

Q: 1) Describe, with the aid of sketches, the mechanisms built into the design of an HRC fuse link to…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Main Block Diagram Operation of DHT11 Humidity Sensor on Arduino?

A: The DHT-11 Temperature and Humidity Sensor or The DHT -11 sensor that reads the atmospheric…

Q: Explain the working of digital storage oscilloscope type recorder with a neat diagram

A: to explain the working of digital storage oscilloscope type recorder with a neat diagram

Q: Write about fault tolerance.

A: We have given the following problem Write about fault tolerance.

Q: Electronic Question(SV) What is procedural Hook up?

A: In System Verilog the process of randomize  the variable is called randomization. Rand keyword is…

Q: 13. Name the terminals of an SCS.

A:

Q: For the ALU circuit shown below, what should be the control word (S251SO) to perform the (sl A)…

A: According to the question, for the given circuit as shown below We need to find the condition for…

Q: What function does this implement? Draw the timing diagram

A:

Coulomb’s Law

Coulomb's law states that the attraction or repulsion force between two charged things is proportional to the product of their charges and inversely proportional to the square of their distance. It has an effect along the line that connects the two-point charges.