3. A three phase wye connected load having 15 + j20 ohms is supplied from a source of 230V. If a balanced delate connected load having a resistance of 16 ohms and 12 ohms capacitive reactance in series in each phase. Determine the total line current.

3. A three phase wye connected load having 15 + j20 ohms is supplied from a source of 230V. If a balanced delate connected load having a resistance of 16 ohms and 12 ohms capacitive reactance in series in each phase. Determine the total line current.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.45P: Two balanced Y-connected loads, one drawing 10 kW at 0.8 power factor lagging and the other IS kW at...

See similar textbooks

Related questions

Q: Q.36: The two-wattmeter method connected to star-connected load produces wattmeter readings P,=-560W…

A: Given problem is based on two wattmetet method of power measurement. Look below for the…

Q: three-phase WYE load with impedance of 1.33+j ohms per phase, is connected to a balanced 230V abc…

Q: The current ICA in a balanced three-phase Δ-connected load is 8 −15° A. If the phase sequence is…

A: Given: the ICA in a balance three phase delta connected load is = 8∠-15°. To find: The value of…

Q: 11.51 In a balanced three-phase system, the abc-phase- sequence source is wye connected and Van…

Q: 11.17 An abc-sequence balanced three-phase wye-connected source supplies power to a balanced…

Q: A wye connected balanced load, supplied from a 3-phase balance supply with a line voltage of 416V at…

A: Given:W1=1980WW2=782Wf=50HzV=416V

Q: 8. A three-phase balanced load has voltage VAC= - 300 sin (wt + 80) V, CBA circuit, the line current…

Q: (c) A balanced three-phase wye-connected load is connected to a balanced three-phase delta-connected…

Q: b Vba +Van – - а + Vac C Assume that the given three phase system is perfectly balanced, with a…

A: In the Star Connection, the 3 winding's similar endpoints are connected to a common point known as…

Q: In the circuit shown below, a three-phase star-connected unbalanced load is connected to a balanced…

A: In this question, We need to determine the value of impedance Zc if voltage difference across the…

Q: The c-phase voltage of a balanced three-phase Y-connected system is 450 −25° V. If the phase…

Q: A 480 V, 60 Hz, three-phase source is connected to a wye-connected load, in which each element has…

A: Given: Three phase source with specifications, VL=480 Vf=60 Hz Wye-connected load in which each…

Q: A 220 V, 3-phase voltage is applied to a balanced delta-connected 3-phase lad of phase impedane…

A: Impedance- Impedance is opposition to current flow. Impedance is combine effect of…

Q: The load per phase of a balanced 3Ø wye connected load is 8 + j6 Ohms per phase. This is connected…

A: A balanced star connection contains three-phase voltages that are dispersed 120 degrees apart yet…

Q: 1. A balanced three-phase circuit has the following characteristics: a. Y-Y connected b. The line…

Q: Obtain the readings of wattmeter 1 and wattmeter 2 in a three-phase three-wire system having…

Q: A Y-Y three-phase system has a source of 380Vand a load of impedance of 6+j5 Ohm/phase through a…

A: Line voltage is given as For star connection phase voltage and line voltage are related by the…

Q: A balanced delta connected load having an impedance Z, = 300 + j210 ohms in each phase is supplied…

Q: A balance Y-connected load of (3 + j8 ) ohms per phase is supplied by a balanced three- phase, 60…

A: In this question, We need to determine the voltage VAB , VCA and current IA as per our…

Q: 1. A 3-phase, 4-wire system which has a system voltage of 254-V L-N with loads connected in wye; Za…

A: Power:- Machine's output power is referred as the rate of doing work. Active power, apparent power…

Q: 2. A balanced 3-phase a-b-c system with line-to-line voltage Vab = 20820⁰ V supplies to a balanced A…

Q: Q 4: A Y-connected balanced 3 phase source with z=0.2+j0.1/phase is connected to a Y-connected…

Q: A Y-connected balanced 3 phase source with z=0.2+j0.1/phase is connected to a Y-connected balanced…

Q: The 3-phase balanced load star-connected has impedance per phase of Zy=8+j6 ohm. If the load…

A: It is given that: Zy=8+j6 ohmV=208 V

Q: A delta-connected balanced three-phase load is supplied from a three-phase, 380 V supply. The line…

A: Since we can only answer upto 3 sub-parts,I'll answer the first three.If you need help with other…

Q: A three-phase balanced wye-wye system has a line voltage of 208 V ms. The line current is 6 A ms and…

A: Steps: Draw the per-phase model of the given circuit Find R using per phase power loss Find Z using…

Q: A 480 V, 60 Hz, three-phase source is connected to a delta-connected load, in which each element has…

A: Given data, A three phase source is connected to a delta connected load. VL=480 Vf=60 HzZph=9+j3 Ω

Q: The load per phase of a balanced 30 wye connected load is 8 + j6 Ohms per phase. This is connected…

A: For 3-phase supply, if they provide the voltage without saying line ya phase, then normally that is…

Q: 5. A three-phase wye-connected load is supplied by an abc-sequence balanced three-phase wye-…

A: In a three phase system there are two ways to connect a three phase load. Star/Wye Connection Delta…

Q: 40: A three-phase balanced system with a acb (-ve) sequence line voltage of 380Vms feeds a…

Q: 2. One phase voltage of a three-phase wye-connected load is Vbn=340VZ+20°. Ib vab 340V@+20" Vbc Vca…

A: Fig: Given phasor diagram

Q: Let us consider a positive phase sequence circuit with a line voltage of 450V at 50HZ. The wye…

Q: A balanced delta connected load of 14+j16 ohm per phase is connected at the end of three phase line.…

A: Given: A balanced delta connected load per phase impedance=(14+j16) ohm Per phase line…

Q: balance Y-connected load of ( 3 + j8 ) ohms per phase is supplied by a balanced three-phase, 60 Hz,…

Q: 1. A three-phase delta-connected load of 15+ j18 N per phase is supplied by an abc-sequence balanced…

A: In this question, We need to determine the phase current, line current phase load voltage and…

Q: The circuit shown below is excited by a balanced three-phase source with a line voltage Vab = 207.84…

A: Here, As shwon in the figure the source is a balanced three phase shource and the load is the delta…

Q: A 3-phase, 4-wire system which has a system voltage of 254-V L-N with loads connected in wye; Za =…

A: It is given that: VL=254 VZa=10∠0°ΩZb=10∠37°ΩZc=10∠-53°Ω

Q: Example A three-phase, balanced delta-connected load of (4+j8) ohms is connected across a 400 V,…

Q: In a balanced three-phase system power is measured by two-wattmeters method and the ratio of the two…

A: In the two-wattmeters method. The phase angle ϕ is given by the expression as shown below:…

Q: Obtain the readings of two wattmeter’s in a three-phase, three-wire system having effective line…

Q: B/ A Balanced abc-sequence Y-connected source with Van =100410V is connected to a A-connected…

A: The solution can be achieved as follows.

Q: 2. A balanced three-phase source furnishes power to the following three loads: Load 1: 5 kVA at 0.83…

Q: In a balanced abc sequential three-phase star-star connected system, the total power on the line is…

A: In the power system we are going to study about the connections between source to load. For large…

Q: A set of balanced three-phase transmission lines with line-to-line voltages of 13 kV is connected to…

A: Given: For balanced 3-phase star-connected load, per-phase impedance Z=8+3j Ω=8.544∠20.55° Ω,…

Q: Athree-phase delta-connected load of 15 j180 per phase is supplied by an abc-sequence balanced…

Q: A balanced wye connected load of 8 + j6 per phase is connected to a balanced 3-phase 400v supply.…

Q: 2. The load per phase of a balanced 30 wye connected load is 8 + j6 Ohms per phase. This is…

A: In the given system, the load and source are balanced,so we can do the calculations of on per phase…

Q: A balanced abc-sequence Y-connected source with Van = 100430°V is connected to a A-connected…

A: In this question, we will find phase and line currents for given star connected source and delta…

Q: For abe phase sequence, calculate the line currents for a balanced three-phase wye-wye system as…

A: Given a balanced three phase wye-wye system,

Q: If the load is delta-connected with impedance per phase of Z=30-j40 ohm and V line = 440 V, predict…

A: The solution is given below

Concept explainers

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.

Question

3. A three phase wye connected load having 15 + j20 ohms is supplied from a source of 230V. If a balanced
delate connected load having a resistance of 16 ohms and 12 ohms capacitive reactance in series in each
phase. Determine the total line current.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Analysis of Single Phase and Three Phase System

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Two balanced Y-connected loads, one drawing 10 kW at 0.8 power factor lagging and the other IS kW at 0.9 power factor leading, are connected in parallel and supplied by a balanced three-phase Y-connected, 480-V source. (a) Determine the source current. (b) If the load neutrals are connected to the source neutral by a zero-ohm neutral wire through an ammeter, what will the ammeter read?
A balanced three-phase 240-V source supplies a balanced three-phase Load. If the line current IA is measured to be 15 A and is in phase with the line-to-line voltage, VBC, find the per-phase load impedance if the load is (a) Y-connected, (b) -conneeted.
1.A three phase wye connected load having 15 + j20 ohms is supplied from a source of 230V. If a balanced delta connected load having a resistance of 16 ohms and 12 ohms capacitive reactance in series in each phase. Determine the total line current.
Consider the balanced 3-phase circuit shown below (a) Sketch the single phase equivalent circuit. Show all values on the sketch. (b) Calculate the following: the total complex power absorbed by the wye connected load. the phase current, ICA.
The current ICA in a balanced three-phase Δ-connected load is 8 −15° A. If the phase sequence is positive, what is the value of IcC?
A 220-V, 3- φ voltage is applied to a balanced delta-connected 3- φ load of phase impedance (15 + j20) Ω. Find the line voltage in volts
A balanced delta-connected load has phase impedances of 4+j3 Ohms. It is connected to balanced transmission lines, with Vab = 1.5kV @ 15 degrees. a) What is the current through each of the load phases? b) What is the current through each of the transmission lines? c) Which ACSR cable should be used for these transmission lines to give a 20% current rating margin for this load?
Determine the line current of a Y-connected balanced three-phase load, consuming 300 kW at power factor = 0.8 lagging and operating at 480 V. Work on PER UNIT with Sbase = 375 kVA and Vbase = 480V. Choose the best answer.
A wye-connected unbalanced load, Za = 10 angle 36.9 , Zb = 10 angle -36.9 , and Zc = 10 angle 0 are connected across a balanced 130-V, 3-phase system. Determine the reading of two wattmeters with line c as common.
A three-phase positive sequence Υ-connected source with Van=50 |_30˚ Vrms , phase It feeds a balanced Y-connected load with an impedance of (67+j5) ohms per . If the impedance per phase of the line between source and load is also (1+j) ohms, find the total complex power of the load and draw the power triangle of the load.
A balanced star-connected load having an impedance (15+j20) ohms per phase is connected to a three-phase, 440 V, 50 Hz supply. Find the line currents and the power absorbed by the load. Assume negative phase sequence.
A three phase Y‐connected balanced load having phase impedance of 40 + j30, The neutral is grounded through a 10 resistor. Find the sequence impedance matrix. Using symmetrical components, determine the phase currents when connected to unbalanced supply of voltages Va=380∠0 ̊V, Vb=280∠‐140 ̊ V and Vc=160∠90 ̊ V.