4.3 Lesson: INTEREFERENCE AND DIFFRACTIONDirection: Solve the problem on the picture. Please write legibly and round off the final answer to two decimal places. 3. Calculate the angle for the third-order maximum of 490-nm wavelength yellow light falling ondouble slits separated by 0.120 mmGIVEN:SOLUTION:UNKNOWN:FROMULA:FINAL ANSWER:

Answered: Image /qna-images/answer/5b93b364-8887-4e4b-97d3-c1f1c56168ba.jpg

Answered: 3. Calculate the angle for the…

3. Calculate the angle for the third-order maximum of 490-nm wavelength yellow light falling on double slits separated by 0.120 mm GIVEN: SOLUTION: UNKNOWN: FROMULA: FINAL ANSWER:

University Physics Volume 3

17th Edition

ISBN:9781938168185

Author:William Moebs, Jeff Sanny

Publisher:William Moebs, Jeff Sanny

Chapter3: Interference

Section: Chapter Questions

Problem 17P: Calculate the angle for the third-order maximum of 580-nm wavelength yellow light falling on double...

See similar textbooks

Related questions

Q: The pendulum swings back and forth. As the height decreases, PE is lost and KE is gained and vice…

A: We know, P.E. = mgh K.E. = 12mV2 A) P.E. = mgh⇒h =P.E.mg=62×9.8=0.306 m B) h =P.E.mg=32×9.8=0.153 m…

Q: True or False: The free electrons will keep on repelling each other until they concentrate on the…

A: Conductors are those materials in which excess of free electrons are present. On room temperature…

Q: An electric iron of resistance 9 ohms takes a current of 2 A. Find the heat developed in 20 s.

A: Given data : Resistance = R Current = I…

Q: Two protons move parallel to the x-axis in opposite directions at the same speed v=3.0 × 105 m⁄s. At…

Q: Density of steel = 9.8 g c find density in kg m 32 :3 cm²

Q: What is the magnetic force on the current's direction? The figure depicts the direction of electric…

A: Say we have a wire of length L in which a current of magnitude I is being passed in the upward…

Q: A circuit is constructed with four resistors, one capacitor, one battery and a switch as shown. The…

Q: Which of the following describes an incompressible flow? O The pressure at a given point cannot…

A: Introduction :- Here we need to know the basic definition of incompressible flow in case of fluid…

Q: -3 Density of copper = 8.98cm³ find density in kg m 3 ?

A: Given:Density of copper is 8.9 g/cm3To Find:Density of copper in kg/m3

Q: 18. A disk is turning with an angular acceleration of 10 [m/s²]. What is the tangential acceleration…

Q: Find the gravitational potential energy of a light that a mass of 45 kg and is 8.22 m above the…

A: Given: The mass of the object is 45 kg. The height of the object from the ground is 8.22 m.

Q: The amplitude of 12πcos(300t) =12 O True False The frequency f of 12πcos(300t) =300/2π O True False…

A: Solution 1- Given that :- Equation y = 12π.cos(300t) The general form of the above given equation…

Q: According to the Guinness Book of World Records, the longest home run ever measured was hit by Roy…

Q: 5. Calculate the wavelength of light that has its third minimum at an angle of 40.0º when falling on…

Q: A machine gun fires 15 bullets / s each of mass 34 g the speed to each bullets is 40 cm/s, then…

A: Given data : Speed of each bullet = V Mass of each bullet…

Q: A 10.0 kg marble is moving at an initial speed of 2.00 m/s. A constant force is applied to the…

Q: Mass of a body is 2.022 kg, What is it's weight?

A: Solution: Given: m = mass of the body = 2.022 kg g = gravitational acceleration = 9.807 m/s2 W =…

Q: Express 31 km h-¹ in m s-¹

A: Given:Speed is 31 km/hrTo Find:Speed in m/s

Q: 1. What limitations are observed in making measurements using the: a. meter stick b. vernier caliper…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: When applying an electric field of magnitude 20.07 megavolts per meter across a resistor made from…

Q: If two 10 μC negatively charged objects experience a force between them of 22.5 N, how far apart are…

A: We know thatF=kq1q2r2HereF=Electrostatic forcek=Coulomb constantq1,q2=Chargesr=distance between…

Q: pencil is placed +0.5 meters from a curved mirror. The image is recorded to be upside down at +0.8…

A: Given Object distance u = +0.5 m Image distance v = +0.8 m To find Radius of curvature of mirror

Q: the possible values for the magnetic quantum number? For each value, find the corresponding z…

Q: Learning Task 2 - Applying the rules of refraction for converging and diverging lens, draw a ray…

A: Converging lens image formation.

Q: A runner goes north 500 m, turns east 1050 m and then goes south for 800 m. What is his displacement…

Q: You have been asked to do the following tasks to reflect your understanding to D.C circuit's…

Q: Determine the moments of the 5-kN force about point O and about point B

A: Centre of mass is just a mathematical concept. It is where the mass is supposed to be concentrated.…

Q: A race car has a maximum speed of 0.104 km/s what is this speed in miles per hour?

A: Speed of car (in km/s), v = 0.104 km/s Speed of car, v = ? (In miles per hour)

Q: 1. What is the total mechanical energy (TME) of a 1000kg motorcycle resting on the top of a 10m…

Q: A circuit consists of two 100-kΩ resistors in series with an ideal 12.0-V battery. Calculate the…

Q: a 1kg rock is released from a height of 20m ignoring air resistance, determine GPE, KE and total…

A: mass of rock (m) = 1 kg initial height = 20 m

Q: The sound waves travel with speed. of 328 m/s. If is wavelength is 8 m. Find the frequency of wave?

A: Given Speed (v) = 328 m/s Wavelength (λ) = 8 m We know , relation between speed of sound (v) ,…

Q: 3. The weight of a particle varies with altitude such that W = m(gr)/r², where ro is the radius of…

A: Plz find the attached hand written solution.

Q: Determine mass=?

A: Given; Volume,v=45 cm3 Density,d=0.25 g cm3Find mass ?

Q: Determine mass=3

A: Given; Determine mass for the data given as; Volume,v= 15 cm3 Density,d= 0.10 g cm3

Q: There are eight identical charges with magnitude Q Coulombs located at the corners of a cube. Four…

Q: 3. List TWO differences between charging an object by contact and charging an object by friction.

A: Answer:- Charging an object by friction:- (1) When an object is charged by friction, there is…

Q: 4. In Figure S6.4, four particles of masses 1kg, 2kg, 3kg and 4kg are at the vertices of a rhombus…

A: Co-ordinate of mass 1kg = ( 0 , 0 ) Co-ordinate of mass 2kg = ( 2m ,0) Co-ordinate of mass 3kg = (…

Q: Given data: Velocity = 15 m/s Mass = 18 kg Calculate kinetic energy?

A: Given data : Velocity = v Mass = m To find :…

Q: A projectile is fired vertically upward with an initial velocity of 150 m/sec from a point 2 m above…

A: In the given question, Initial velocity of the projectile (u) = 150m/s The projectile is fired…

Q: Determine the magnitude of the vector sum V = V₁ + V₂ and the angle 0x which V makes with the…

Q: Explain why the time constant for an RC circuit increases with R and with C. (The answer “That’s…

Q: Give evidence that the density of water does not follow that of most substances, when heated.

A: Of course, density of most matter in the earth(not to say universe) depend on temperature. Water's…

Q: Given data: Force = 18 N Time = 4.6 s Find the Impulse

A: Given value--- Force = 18 N. Time = 4.6 s. We have to find--- Impulse?

Q: 1. The diagram below shows two light rays emanating from the top of the object and incident towards…

Q: Volume = 45 cm3 density - Determine mass = ? 0.25 gem³ 8cm

A: volume of object (V) = 45 cm3density (d) = 0.25 gcm3

Q: the value

A: solution of above problem is below:

Q: ement for water flow is attached to cm. 1.8 kN/m, will be. decimal place]

Q: Calculate the magn about the base point O of 600N force 2m 409 4m O 600N y X 4n 2m A d 40⁰ 600N

Q: Use the following table to refer to each element in your answers. F G H E D A B C 210 211 Pb 211 Bi…

Concept explainers

Interference of Light

The word "constructive" signifies addition in interference. Constructive interference occurs when the path of the waves that start from the slit differs by 1 entire wavelength or in the intervals of the same. Hence, the waves that are presented on the screen are in phase (crest to crest/trough to trough). The waves interfering constructively forms bright fringes on the screen.

Question

4.3 Lesson: INTEREFERENCE AND DIFFRACTION Direction: Solve the problem on the picture. Please write legibly and round off the final answer to two decimal places.

3. Calculate the angle for the third-order maximum of 490-nm wavelength yellow light falling on
double slits separated by 0.120 mm
GIVEN:
SOLUTION:
UNKNOWN:
FROMULA:
FINAL ANSWER:

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Calculate the angle for the third-order maximum of 580-nm wavelength yellow light falling on double slits separated by 0.100 mm.
What is the smallest separation between two slits that will produce a second-order maximum for 720-nm red light?
Find the distance between two slits that produces the first minimum for 410-nm violet light at an angle of 45.0°.
What is the separation between two slits for which 610-nm orange light has its first maximum at an angle of 30.0°?
At what angle is the first-order maximum for 450-nm wavelength blue light falling on double slits separated by 0.0500 mm?
Assume light of wavelength 650 nm passes through two slits 3.00 m wide, with their centers 9.00 m apart. Make a sketch of the combined diffraction and interference pattern in the form of a graph of intensity versus = (a sin )/. You may use Figure 37.7 as a starting point.
A diffraction pattern is formed on a screen 120 cm away from a 0.400-mm-wide slit. Monochromatic 546.1-nm light is used. Calculate the fractional intensity I/Imax at a point on the screen 4.10 mm from the center of the principal maximum.
Calculate the wavelength of light that produces its first minimum at an angle of 36.9° when falling on a single slit of width 1.00 m.
The pupil of a cats eye narrows to a vertical slit of width 0.500 mm in daylight. Assume the average wavelength of the light is 500 nm. What is the angular resolution for horizontally separated mice?
Suppose the single slit in Figure 38.4 is 6.00 cm wide and in front of a microwave source operating at 7.50 GHz. (a) Calculate the angle for the first minimum in the diffraction pattern. (b) What is the relative intensity l/lmax at 0 =- 15.0? (c) Assume two such sources, separated laterally by 20.0 cm, are behind the slit. What must be the maximum distance between the plane of the sources and the slit if the diffraction patterns are to be resolved? In this case, the approximation sin tan 8 is not valid because of the relatively small value of a/.
Two lamps producing light of wavelength 589 nm are fixed 1.0 m apart on a wooden plank. What is the maximum distance an observer can be and still resolve the lamps as two separate sources of light, if the resolution is affected solely by the diffraction of light entering the eye? Assume light enters the eye through a pupil of diameter 4.5 mm.
Can the lines in a diffraction grating be too close together to be useful as a spectroscopic tool for visible light? If so, what type of EM radiation would the grating be suitable for? Explain.