Answered: 3. The current supplied by a rectifier…

3. The current supplied by a rectifier has a sinusoidal wave shape with a maximum value of 6.83 amp. What is the average current if the rectifier is of the (a) full-wave type, (b) single-wave type?

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter59: Motor Startup And Troubleshooting Basics

Section: Chapter Questions

Problem 12SQ: How is a solid-state diode tested? Explain.

See similar textbooks

Related questions

Q: What is the concept of PIV (Peak Inverse Voltage) for rectifier circuits? For which rectifier…

A: In this question we will write about PIV..

Q: . The peak input voltage (Vpi) to a full-wave bridge rectifier is 15 V sinusoidal voltage of 50 Hz.…

A: Given The peak input voltage of full wave bridge rectifier Vpi = 15 V f = 50 Hz

Q: A voltmeter measures an AC voltage of 150 V. a) What is the peak voltage? What is the RMS voltage?…

A: Given voltmeter measures an AC voltage of 150 V

Q: Give at least 3 important specifications of a rectifier circuit. For every specification, explain…

A: To convert Alternating supply to Direct supply DC, Rectifiers are used. It can controlled as well as…

Q: Determine the ripple factor for the filtered bridge rectifier with a load as indicated in the figure…

A: The given circuit is a full bridge rectifier circuit with capacitor filter. The value of all the…

Q: 3. For the half-wave rectifier given in the figure below, find the average values of the output…

Q: B. Draw the schematic diagram of a full wave bridge type rectifier. Explain its operation and sketch…

Q: Explain the operation of the diode in the full-wave bridge rectifier, the zener diode in a voltage…

A: Diode is a unidirectional device. In full wave rectifier, diode convert the negative part of the…

Q: In the DC power supply utilizing rectifiers, the last stage is Select one: a. the filter b. the…

A: Most of the electronic circuit require dc power. For this purpose ac to dc conversion is required.…

Q: voltages. 2. What design parameters of the full wave single-phase rectifier? 3. When you design 10kW…

A: Diode bridge rectifier converts the ac supply into pulsating DC. to reduce the ripple a capacitor is…

Q: How do you define the output voltage ripple in a rectifier circuit? Suggest a method to reduce the…

A: Rectifiers are used to convert Alternating supply into pulsating DC. It can be controlled as well as…

Q: 3- What are the advantages of full wave rectifier comparing to half wave? 4- What is the effect of…

A: Need to explain

Q: A conductor carries a current that is equivalent to a 5-amp continuous current in one direction and…

A: In a full wave rectifier that convert the complete cycle of AC into a pulsating Direct current. It…

Q: Calculate the theoretical output DC voltage of the half-wave rectifier circuit and compare it with…

A: By the help of the following procedures, we will find the ripple factor from the half-wave rectifier…

Q: 4. Connect and simulate center-tapped full wave rectifier circuit and draw output waveform.

A: to connect and stimulate center tapped full wave rectifier circuit and draw its output waveform

Q: say i made a full wave rectifier. can please tell me what to write in regards A brief description of…

A: According to question: Note: The diodes are acting as voltage source of 0.636V in forward biased…

Q: Create a diagram of a transformer-coupled half wave rectifier, including the input and output…

Q: B) Explain the effect on the output signal for changing the frequency of the input signal in a…

A: Explanation: Here for the half-wave rectifier, we use general RL load The circuit diagram input…

Q: Design a rectiﬁer to provide a dc output voltage of 15 V with no more than 1 percent ripple at a…

A: Given: DC voltage output, Vdc=15 V The load current, IL=2 A The percent of ripple should not be more…

Q: draw the circuit of a voltage supply comprised of full wave bridge rectifier, capacitor and IC…

A: 1. Firstly need to use step down transformer It is used to step down the AC voltage 2.After…

Q: Sketch VL and IL for the given half-wave rectifier.

Q: Consider the half wave rectifier is supplied with 115V, 80HZ signal. Assume the number of turns in…

Q: Single-phase uncontrolled (diode) bridge rectifier is supplied by 220 V, 50 Hz AC voltage. DC load…

A: For uncontrolled bridge rectifier the input current harmonics will be mainly due to the fundamental…

Q: Q1: Draw the circuit of full wave rectifier mentioned on the circuit all equipment requirements to…

A: In this question we need to draw output voltage signal and need to find output current and voltage.

Q: Create a diagram of a bridge nectifier circuit, including the input and output waveforms. Describe…

A: Bridge rectifiers is a type of full-wave rectifier that uses four or more diodes in a bridge circuit…

Q: a) For a half controlled rectifier with R-load (i) Draw the simple circuit diagram. (ii) Draw the…

Q: What is the peak output voltage for this half-wave rectifier? (2nd Approximation)

Q: Compare the output waveform for Half-Wave Rectifier with and without capacitor.

A: From the given question we need to compare the output waveform for half-wave rectifier with and…

Q: Calculations and Discussion 1. Calculate the theoretical output DC voltage of the half-wave…

Q: D1- ... IN4004G V1 9Vrms 60HZ :C R ...

Q: obtained using half wave rectifiers. Question: What is the main disadvantage of a conventional…

Q: For the half-wave rectifier given in the figure below, find the average values of the output voltage…

A: It is given that : It is Half-Wave Rectifier. Vmax = 169.71 V F=50 Hz. R=1 kΩ

Q: Which cannot be done with an input source, a zener diode and a resistor? Rectifier circuits…

A: In this question , we will write about zener diode...

Q: half bridge given in the figure for the rectifier circuit; Output current and voltage waveform draw

Q: hen a 60-Hz sinusoidal voltage is applied to the input of a full-wave rectifier, what is the output…

A: To solve above problem, one should know what rectifier circuit is and how it works. To charge a…

Q: Rectifiers. For the following rectifier circuits, calculate for the peak and average output voltage…

A: The circuit can be modified as

Q: Explain half wave and full wave rectifier circuit with example

Q: What is the effect of adding capacitor in parallel to the load at the rectifier output?

A: An energy storing device that stores charge in an electric field is called a capacitor. The ratio of…

Q: Investigate and analyze Full Wave Bridge Rectifier.

A: In this question we analyse the full wave bridge rectifier

Q: Subject: Electronics Engineering With neat sketches explain the operation of a center tapped…

Q: Draw the circuit of half wave rectifier using operational amplifier and briefly explain it.

A: Operational Amplifier is direct coupled high gain amplifier. The OP-AMP is multi terminal device.…

Q: 1.What does (time constant) means ? what its effect on filtering process ? For full wave rectifier

A: Time constant: It is the time taken by the response to reach 36.7 % of its initial value while…

Q: 1.What is the main difference between Center tapped Full wave Rectifier and Bridge Rectifier? 2.How…

Q: Assume the input signal to a rectifier circuit has a peak value of VM = 12 V and is at a frequency…

A: The information given : The peak value of VM=12 V The frequency f=60 Hz The output load resistance…

Q: The peak inverse voltage or PIV for the bridge rectifier is lower when compared to an identical…

A: The peak inverse voltage for the centre tapped full wave rectifier is. PIV = 2 Vm The peak…

Q: What are the advantages of full wave rectifier comparing to half wave?

A: We need to differentiate full wave rectifier and half wave rectifier

Q: Calculate the average value of the output voltage for ? = 60 ° of a three-phase full-wave thyristor…

A: The solution can be achieved as follows.

Question

3. The current supplied by a rectifier has a sinusoidal wave shape with a maximum
value of 6.83 amp. What is the average current if the rectifier is of the (a) full-wave type,
(b) single-wave type?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Single Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

How is a solid-state diode tested? Explain.
What is CEMF?
The half-wave rectiﬁer as shown is operating at a frequency of 60Hz, and the rms value of the transformer output voltage vI is 12.6V±10%. What are the nominal and worst case values of the dc output voltage VO if the diode voltage drop is 1V?
What is the peak output voltage for this half-wave rectifier? (2nd Approximation)
Calculate the capacitor value Conditions: 1st That, for the calculation of the peak voltage of the rectifier output, it is 9V. 2nd That the ideal ripple voltage is equal to 10% of the peak voltage at the output of the rectifier. 3rd That the maximum load current is 0.009A
Given a bridge rectifier, plot the output wave form. (Assuming Practical Model)
Determine the peak output voltage for the bridge rectifier in this figure. Assuming the practical model, what PIV rating is required for the diode? The transformer is specified to have a 12 Vrms secondary voltage for the standard 110 V across the primary.
In a center-tapped full wave rectifier circuit utilizing ideal diodes, if the primary voltage is 160Vpeak, the turns ratio is 8:1 and the load resistance is 860 ohms, what is the rectified dc voltage at the output? express answer in volts
Subject: Electronics Engineering With neat sketches explain the operation of a center tapped full-wave rectifier.
Assume the input signal to a rectifier circuit has a peak value of VM = 12 V and is at a frequency of 60 Hz. Assume the output load resistance is R = 2 k and the ripple voltage is to be limited to Vr = 0.4 V. Determine the capacitance required to yield this specification for a (a) full-wave rectifier and (b) half-wave rectifier.
Describe fully the operation of full-wave bridge-type rectifier circuit.
3. For the half-wave rectifier given in the figure below, find the average values ofthe output voltage and current, and the ripple factor of the output voltage.