. The peak input voltage (Vpi) to a full-wave bridge rectifier is 15 V sinusoidal voltage of 50 Hz. Determine: (a) The peak-output-voltage (Vpo) of the rectifier. (b) The dc output voltage (Va) of the rectifier. (c) The PIV rating of each diode of the rectifier. (d) The output frequency of the rectifier. 22

. The peak input voltage (Vpi) to a full-wave bridge rectifier is 15 V sinusoidal voltage of 50 Hz. Determine: (a) The peak-output-voltage (Vpo) of the rectifier. (b) The dc output voltage (Va) of the rectifier. (c) The PIV rating of each diode of the rectifier. (d) The output frequency of the rectifier. 22

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter12: Electronic Control Devices

Section: Chapter Questions

Problem 4RQ: What is the difference between a diode and rectifier?

See similar textbooks

Similar questions

Discuss the advantages and disadvantages of all rectifier circuits :
Describe fully the operation of full-wave bridge-type rectifier circuit.
What is a full-wave bridge-type rectifier circuit? Describe fully the operation of full-wave bridge-type rectifier circuit.
Calculate the capacitor value Conditions: 1st That, for the calculation of the peak voltage of the rectifier output, it is 9V. 2nd That the ideal ripple voltage is equal to 10% of the peak voltage at the output of the rectifier. 3rd That the maximum load current is 0.009A
A 3.3-V, 30-A dc power supply is to be designed with a ripple of less than1.5percent. Assume that a half-wave rectiﬁer circuit (60 Hz) with a capacitor ﬁlter is used. (a) What is the size of the ﬁlter capacitor C? (b)What is the PIV rating for the diode? (c)What is the rms value of the transformer voltage needed for the rectiﬁer?(d) What is the value of the peak repetitive diode current in the diode? (e) What is the surge current at t =0+?
Determine the peak output voltage for the bridge rectifier in this figure. Assuming the practical model, what PIV rating is required for the diode? The transformer is specified to have a 12 Vrms secondary voltage for the standard 110 V across the primary.
1- Connect the half-wave rectifier with resistive load (RL=1KΩ ) and setthe parameters value of peak amplitude equal (220) volt, frequency equal(50) HZ.2- Draw the output waveform for the DC output and the r.m.s value of theoutput voltages.3- What is the value of the peak inverse voltage on the diode in half -waverectifier?
1. Discribe shortly , a)What is the diode conduction angle in a three phase three pulse rectifier? b)What is the output voltage of a three phase three pulse rectifier operating on a line to line voltage of220V?c) What is the output voltage of a three phase three pulse rectifier operating on a line to neutral voltageof 220V?
The half-wave rectiﬁer as shown is operating at a frequency of 60Hz, and the rms value of the transformer output voltage vI is 12.6V±10%. What are the nominal and worst case values of the dc output voltage VO if the diode voltage drop is 1V?
1. Draw and briefly explain the ideal characteristics of PN-junction diode ? 2. Explain briefly about avalanche and Zener breakdown ? 3. In which region can Zener diode be used as a regulator? Why? 4. What is the ripple factor? For a good filter, should the ripple factor be high or low? 5. What is a rectifier? What is the difference between a full-wave rectifier and a half-wave rectifier?
Explain the concept of operation of the full-wave rectifier circuit from input to output and how the AC signal will be converted to DC output shown in the photo below.
A 2500-V, 2-A, dc power supply is to be designed with a ripple voltage ≤ 0.5 percent. Assume that a half-wave rectiﬁer circuit (60 Hz) with a capacitor ﬁlter is used. (a) What is the size of the ﬁlter capacitor C? (b) What is the minimum PIV rating for the diode? (c) What is the rms value of the transformer voltage needed for the rectiﬁer? (d) What is the peak value of the repetitive current in the diode? (e) What is the surge current at t =0+?