3. The Figure below shows a parallel-plate capacitor of plate area A= 10.5 cm² and plate separation 2d= 7.12 mm. The left half of the gap is filled with material of dielectric constant K₁= 21.0; the top of the right half is filled with material of dielectric constant K₂ = 42.0; the bottom of the right half is filled with material of dielectric constant K3 = 58.0. What is the capacitance? TH K₁

3. The Figure below shows a parallel-plate capacitor of plate area A= 10.5 cm² and plate separation 2d= 7.12 mm. The left half of the gap is filled with material of dielectric constant K₁= 21.0; the top of the right half is filled with material of dielectric constant K₂ = 42.0; the bottom of the right half is filled with material of dielectric constant K3 = 58.0. What is the capacitance? TH K₁

College Physics

10th Edition

ISBN:9781285737027

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter16: Electrical Energy And Capacitance

Section: Chapter Questions

Problem 56P: A parallel-plate capacitor has plates of area A = 7.00 102 m2 separated by distance d = 2.00 104...

See similar textbooks

Similar questions

A 1.00-F capacitor is charged by being connected across a 10.0-V battery. It is then disconnected from the battery and connected across an uncharged 2.00-F capacitor. Determine the resulting charge on each capacitor.
A parallel-plate capacitor has plates of area A = 7.00 102 m2 separated by distance d = 2.00 104 m. (a) Calculate the capacitance if the space between the plates is filled with air. What is the capacitance if the space is filled half with air and half with a dielectric of constant = 3.70 as in (b) Figure P16.56a, and (c) Figure P16.56b? (Hint: In (b) and (c), one of the capacitors is a parallel combination and the other is a series combination.) Figure P16.56
A parallel-plate capacitor has square plates that are 8.00 cm on each side and 3.80 mm apart. The space between the plates is completely filled with two square slabs of dielectric, each 8.00 cm on a side and 1.90 mm thick. One slab is Pyrex glass and the other slab is polystyrene. If the potential difference between the plates is 86.0 V, find how much electrical energy can be stored in this capacitor.
Show that for a given dielectric material the maximum energy a parallel plate capacitor can store is directly proportional to the volume of dielectric (Volume = A. d). Note that the applied voltage is limited by the dielectric strength.
An electronics technician wishes to construct a parallel plate capacitor using rutile ( = 100) as the dielectric. The area of the plates is 1.00 cm2. What is the capacitance if the rutile thickness is 1.00 mm? (a) 88.5 pF (b) 177 pF (c) 8.85 F (d) 100 F (e) 35.4 F
(i) A battery is attached to several different capacitors connected in parallel. Which of the following statements is true? (a) All capacitors have the same charge, and the equivalent capacitance is greater than the capacitance of any of the capacitors in the group, (b) The capacitor with the largest capacitance carries the smallest charge, (c) The potential difference across each capacitor is the same, and the equivalent capacitance is greater than any of the capacitors in the group. (d) The capacitor with the smallest capacitance carries the largest charge. (e) The potential differences across the capacitors are the same only if the capacitances are the same, (ii) The capacitors are reconnected in series, and the combination is again connected to the battery. From the same choices, choose the one that is true.
A parallel-plate capacitor has plates of area A = 7.00 102 m2 separated by distance d = 2.00 104 m. (a) Calculate the capacitance if the space between the plates is filled with air. What is the capacitance if the space is filled half with air and half with a dielectric of constant = 3.70 as in (b) Figure P16.56a, and (c) Figure P16.56b? (Hint: In (b) and (c), one of the capacitors is a parallel combination and the other is a series combination.) Figure P16.56
Calculate the equivalent capacitance between points a and b in Figure P26.77. Notice that this system is not a simple series or parallel combination. Suggestion: Assume a potential difference v between [joints a and b. Write expressions for vab in terms of the charges and capacitances for the various possible pathways from a to b and require conservation of charge for those capacitor plates that are connected to each other.
A parallel-plate capacitor with plates of area LW and plate separation t has the region between its plates filled with wedges of two dielectric materials as shown in Figure P25.48. Assume t is much less than both L and W. (a) Determine its capacitance. (b) Should the capacitance be the same if the labels 1 and 2 are interchanged? Demonstrate that your expression does or does not have this property. (c) Show that if 1 and 2 approach equality to a common value , your result becomes the same as the capacitance of a capacitor containing a single dielectric: C = 0LW/t. Figure P25.48
A parallel-plate capacitor of plate separation d is charged to a potential difference V0. A dielectric slab of thickness d and dielectric constant is introduced between the plates while the battery remains connected to the plates. (a) Show that the ratio of energy stored after the dielectric is introduced to the energy stored in the empty capacitor is U/U0 = . (b) Give a physical explanation for this increase in stored energy. (c) What happens to the charge on the capacitor? Note: This situation is not the same as in Example 25.5, in which the battery was removed from the circuit before the dielectric was introduced.
What total capacitances can you make by connecting a 5.00 F and an 8.00 F capacitor together?
A parallel-plate capacitor with capacitance C0 stores charge of magnitude Q0 on plates of area A0 separated by distance d0. The potential difference across the plates is V0. If the capacitor is attached to a battery and the charge is doubled to 2Q0, what are the ratios (a) Cnew/C0 and (b) Vnew/V0? A second capacitor is identical to the first capacitor except the plate area is doubled to 2A0. If given a charge of Q0, what are the ratios (c) Cnew/C0 and (d) Vnew/V0? A third capacitor is identical to the first capacitor, except the distance between the plates is doubled to 2d0. If the third capacitor is then given a charge of Q0, what are the ratios (e) Cnew/C0 and (f) Vnew/V0?