30° T 0.4 m 0.8 m 6 m G B 3 m The jet-powered aircraft has a mass of 27 tons and a center of mass at G. If a tow cable is attached to the top of the nose wheel and exerts a force of T = 324 N as shown, determine the magnitude of the normal reaction in the nose wheel. (Express your answer in kN) Neglect the lift of the wings and the mass of the wheels. X2

30° T 0.4 m 0.8 m 6 m G B 3 m The jet-powered aircraft has a mass of 27 tons and a center of mass at G. If a tow cable is attached to the top of the nose wheel and exerts a force of T = 324 N as shown, determine the magnitude of the normal reaction in the nose wheel. (Express your answer in kN) Neglect the lift of the wings and the mass of the wheels. X2

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter10: Virtual Work And Potential Energy

Section: Chapter Questions

Problem 10.57P: Find the stable equilibrium position of the system described in Prob. 10.56 if m = 2.06 kg.

See similar textbooks

Similar questions

The cylinder having a diameter 2.5 ft weighs 57 lb and is 6 ft long. Determine the reaction (lb.) at A neglecting friction. Determine the reaction at B (lb.) neglecting friction. Weight density of water is 62.4 lb/ft3 Sp.gr Gs = 1.6
Determine the magnitude and direction of the angle theta of the force FAB that must be exerted on bar AB to maintain equilibrium of the system. The suspended mass is 110 kg. Neglect the size of the pulley at A and treat all pulleys as smooth. What should happen to maintain the equilibrium of the system if FAB acts with an angle theta= 0°?Consider g = 9.81 m/s2.
Determine The Forces P F T Required To Keep The Triangular Frame Inequilibrium.
2-D PROBLEM: A spherical tank with a radius of 3.41m that has a mass of 28928.644kg was supported in the system shown. Assuming friction and the bar weight is negligible, determine the following: β: 21.774° θ: 46.452° 1. The reaction @ point D. 2. Tension @cable BE 3. The x and y-component of the reaction @ A 4. The reaction @ A
Consider a floor crane operated by a driver which carries a drum as shown in figure. The total weight of floor crane and driver is 2700 kg acting at the point of center of gravity, G. mm; = 1 = Considering L1 = 14m, L2= 3 m L3 - 6 m, 14 = 2 m LS = 1 m; L6=7m 1. If the weight of the drum lifted by the floor crane is 800 kg, determine the total normal reaction on the rear wheels at A and total normal reaction on the front wheels at B when the boom is inclined at an angle of 25" with the horizontal, 2. Utilizing the same data given above for the same position of boom, determine the largest weight of the drum that can be lifted without causing the crane to overturn. (Hint: When the floor crane tends to overturn about point B, the wheel at A will leave the ground). Note: 1. Consider the entire system as coplanar 2. Take g 9.81 m/s wherever necessary = 9 Total normal reaction on the rear wheels at A= Total normal reaction on the front wheels at B= Largest weight of the drum=
The winch cable on a tow truck is subjected to a force of T = 8 kN when the cable is directed at = 55°. If the truck has a total mass of 3.5 Mg and mass center at G, determine the following: A.) The magnitude of the total brake frictional force F for the rear set of wheels B. B.)The magnitude of the total normal forces NA at both front wheels A for equilibrium. C.)The magnitude of the total normal forces NB at both front wheels B for equilibrium.
If d=2m and F-200N and the mass of ball 30 kg Determine the forces in cables AC and AB in equilibrium 1.5 m F -2 m- Maximum size for new files: 128MB
The mass of the uniform bar below is 20 kg. 1. Determine the magnitude of the reaction NB acting on the smooth uniform bar. 2. Determine the magnitude of the reaction Ax acting on the smooth uniform bar. 3. Determine the magnitude of the reaction Ay acting on the smooth uniform bar.
Since the mass of the rod AB is m=690(kg), calculate the reaction forces that will occur on the frictionless surfaces.
If the block remains in the equilibrium position shown, determine the mass of the block D. The unextended length of spring AB is 9 m. d1 = 8 m d2 = 10 m KAC = 44 N/m KAB = 70 N/m Mass of block D = ____ kg
Determine the magnitude (N) of the vertical component of the reaction at point A if, F=231N, a=0.59m, b=2.06m, r=1.66m and d=23.37degrees. Round off only on the final answer expressed in 3 decimal places. Instead of units, indicate U if force is upward or D if downward.
Equilibrium problems r1+r2