31. A single loop of wire of radius 0.23 m is placed in a 0.75 T magnetic field as shown. The magnetic field is changed to a strength of 0.50 T in the opposite direction in 0.61 s. хв A. B. X C. D. X X X X X 0.23 m Before X X X What is the average emf induced the coil? 0.068 V 0.094 V 0.34 V 0.47 V X 0.23 m After . B

31. A single loop of wire of radius 0.23 m is placed in a 0.75 T magnetic field as shown. The magnetic field is changed to a strength of 0.50 T in the opposite direction in 0.61 s. хв A. B. X C. D. X X X X X 0.23 m Before X X X What is the average emf induced the coil? 0.068 V 0.094 V 0.34 V 0.47 V X 0.23 m After . B

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter25: Electromagnetic Induction

Section: Chapter Questions

Problem 4STP

See similar textbooks

Similar questions

(a) An MRI technician moves his hand from a region of very low magnetic field strength into an MRI scanner's 2.00 T field with his fingers pointing in the direction of the field. Find the average emf induced in his wedding ling, given its diameter is 2.20 cm and assuming it takes 0.250 s to move it into the field. (b) Discuss whether this current would significantly change the temperature of the ring.
A thin conducting bar (60.0 cm long) aligned in the positive y direction is moving with velocity v=(1.25m/s)i in a region with a spatially uniform 0.400-T magnetic field directed at an angle of 36.0 above the xy plane. a. What is the magnitude of the emf induced along the length of the moving bar? b. Which end of the bar is positively charged?
(a) A nonferrous screwdriver is being used in a 2.00 T magnetic field. What maximum emf can be induced along its 12.0 cm length when it moves at 6.00 m/s? (b) Is it likely that this emf will have any consequences or even be noticed?
Unreasonable results To construct a non-mechanical water meter, a 0.500-T magnetic field is placed across the supply water pipe to a home and the Hall voltage is recorded, (a) Find the flow rate through a 3.00-cm-diameter pipe if the Hall voltage is 60.0 mV. (b) What would the Hail voltage be for the same flow rate through a 10,0-cm- diameter pipe with tire same field applied?
A heart surgeon monitors the flow rate of blood through an artery using an electromagnetic flowmeter (Fig. P28.47). Electrodes A and B make contact with the outer surface of the blood vessel, which has a diameter of 3.00 mm. (a) For a magnetic field magnitude of 0.040 0 T, an emf of 160 V appears between the electrodes. Calculate the speed of the blood. (b) Explain why electrode A has to be positive as shown. (c) Does the sign of the emf depend on whether the mobile ions in the blood are predominantly positively or negatively charged? Explain.
Consider the system pictured in Figure P28.26. A 15.0-cm horizontal wire of mass 15.0 g is placed between two thin, vertical conductors, and a uniform magnetic field acts perpendicular to the page. The wire is free to move vertically without friction on the two vertical conductors. When a 5.00-A current is directed as shown in the figure, the horizontal wire moves upward at constant velocity in the presence of gravity. (a) What forces act on the horizontal wire, and (b) under what condition is the wire able to move upward at constant velocity? (c) Find the magnitude and direction of the minimum magnetic Field required to move the wire at constant speed. (d) What happens if the magnetic field exceeds this minimum value? Figure P28.26
A flat, square coil of 20 turns that has sides of length 15.0 cm is rotating in a magnetic field of strength 0.050 T. If tlie maximum emf produced in die coil is 30.0 mV, what is the angular velocity of the coil?
A rectangular conducting loop is placed near a long wire carrying a current I as shown in Figure OQS1.3. If I decreases in time, what can be said of the current induced in the loop? (a) The direction of the current depends on the size of the loop. (b) The current is clockwise. (c) The current is counterclockwise. (d) The current is zero. (e) Nothing can he said about the current in the loop without more information.
(a) If the emf of a coil rotating in a magnetic field is zero at t = 0, and increases to its first peak at t = 0.100 ms, what is the angular velocity of the coil? (b) At what time will its next maximum occur? (c) What is the period of the output? (d) When is the output first one-fourth at its maximum? (e) When is it next one-fourth at its maximum?
100-turn square coil of side 20.0 cm rotates about a vertical axis at 1.50 103 rev/min as indicated in Figure P31.42. The horizontal component of the Earths magnetic field at the coils location is equal to 2.00 105 T. (a) Calculate the maximum emf induced in the coil by this Held, (b) What is the orientation of the coil with respect to the magnetic field when the maximum emf occurs?