FOR QUESTIONS 3 – 5, (a) SOLVE FOR THE GIVEN LETTER THEN (b) SUBSTITUTETHE GIVEN VALUES TO FIND THE VALUE OF THE INDICATED LETTER. PLACEANSWER IN CORRECT ENGINEERING NOTATION WITH THE APPROPRIATE PREFIX.ROUND ANSWER TO 3 SIGNIFICANT DIGITS WHEN NECESSARY.[M = 10°, k = 10³, m = 10-3 & µ = 10-“] 4) XL = 2nfL Solve for L then find the inductance (L – Unit of measure is h(henry's)) when the inductivereactance (XL) is 48.2 Q and the frequency (f) is 60.0 Hz.

Answered: Image /qna-images/answer/be1f8aa5-5fe5-42ea-8220-7a32ea51cb96.jpg

Answered: 4) XL = 2nfL Solve for L then find the…

4) XL = 2nfL Solve for L then find the inductance (L - Unit of measure is h(henry's)) when the inductive reactance (XL) is 48.2 2 and the frequency (f) is 60.0 Hz.

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter1: A Physics Toolkit

Section: Chapter Questions

Problem 70A

See similar textbooks

Related questions

Q: Problem 3: An AC voltage source is connected to an inductor with inductance 0.059 H. The voltage…

A: (a) The expression for the voltage across the inductor coil is, Here, L is the inductance and i is…

Q: i= 30sin (40rt +"). 27 4. The current in a circuit is described by Where i is in mA and t is in…

Q: An inductor is used to limit the currentthrough a fluorescent lamp that is operated with an rms…

A: Vr=RMS voltage=120 Vf=Frequency=60 HzIr=RMS current=0.33 AR=Resistance=0L=Inductance

Q: As shown, the battery has an emf of 12.0 V, the inductance is 2.81 mH, and the capacitance is 9.00…

A: (A) When fully charged, the capacitor has the potential difference of ε across it. The circuit with…

Q: 4. Consider the circuit below, which has a capacitor and a resistor and negligible self- inductance.…

Q: 6. Obtain the resonant frequency , of a series LCR circuit with L-2.0H, C-32µF and R=100. What is…

A: Given value--- L = 2 H. C = 32 micro F . R = 10 ohm. We have to find--- resonance frequency? Q -…

Q: 2. If the radius of the (single) loop is 13.0 cm, and the field decreases from B = 0.067 T to zero…

A: 2) The equation for the induced emf is given by, Thus,

Q: 2 the inductive reactance X, is:

Q: 30.37 An L-C circuit containing an 80-mH inductor and a 1.25-nF capacitor oscillates with a…

A: As per the hint, option (b) is answered first.b) Frequency of LC circuit is,

Q: A capacitor of 50 µF and inductance of 0.2025 Hare connected in series If the resistance of the…

Q: Problem 8: An oscillating LC circuit has inductance L and capacitance C. The maximum charge on the…

Q: In an A.C circuit, if the phase difference (p) is positive, then it shows that inductor is connected…

A: Solution

Q: 5. Find the magnitude and direction of the induced emf around the rectangular loop of sides a and b…

Q: Why in present day technology we do not use inductance filters?

A: In the present day technology inductance filters because of damping of AC signals.

Q: Problem #7: An LC circuit is made by attaching a 150-turn solenoid of length 0.75 m and diameter 10…

A: Note : As per our answering policies, we can answer upto maximum of 3 sub parts of a question.

Q: Question 2 ( - - A circuit has in series a resistor R Q, an inductor of L H, and a capacitor of C…

A: We have a series LCR circuit with initial current I(0)=0 A and initial charge Q(0)=Qo C. We need to…

Q: 3. In the circuit below the capacitor initially has a charge Qo. If the switch is closed at t = 0,…

Q: Suppose that a rectangular toroid has 2000 windings and a self-inductance of 0.040 H. If ℎ=0.10m,…

A: Given Number of turn N =2000 Self inductance L =0.04 H h =0.1 m

Q: 5. A coil of inductance 80mH and negligible resistance is connected in series with a capacitance of…

Q: Determine the resonance frequency and bandwidth from the graph. Find the Q-factor also. A resonance…

A: Frequency at resonance is the frequency at which voltage is maximum. At frequency of 5 kHz voltage…

Q: 92. An AC power supply that operates at an angular frequency of 25 rad/s is connected in series with…

A: angular frequency = W = 25 rad/s resistance = R = 1003 ohms inductance = L=6 H capacitance = C =…

Q: 3. A 44mH inductor is connected to 220V,50HZ ac supply. Determine the rms value of the current in…

A: Given value--- inductance = 44 mH. Voltage = 220 V. frequency = 50 Hz. We have to find--- rms…

Q: | 2. An inductor has an inductance of 5 milliHenrys. A voltage of 5 V is suddenly applied |across…

A: Given,

Q: Describe the relationship between the charge and current oscillating between a capacitor and…

Q: 2. Now consider an instant when the current is momentarily zero. Describe the magnitude of the…

A: Explanation and solution shown in the picture below ?

Q: Determine the maximum magnetic flux through an inductor connected to a North American electrical…

Q: 4. Consider a series LRC circuit, with an inductor L with no current initially flowing through it, a…

Q: 4. As shown in Fig. 4, an infinite conductor plane is located at z=0 planę with a surface current…

Q: 3. A radio turning circuit consists of a fixed capacitor and a variable inductor. The tuner is tuned…

Q: urrent Attempt in Progress A high-field superconducting magnet in an MRI machine has an inductance…

Q: Fill in the Blank: If the two wires are running in parallel then the impedance to ground from each…

A: Impedance for two wires running parallel is given by Zo = 138/√k log(D/d)

Q: 3. In the figure, the battery has an emf of 12.o v, the inductance is 2.81mH and the capacitance is…

A: Given The emf of the battery is the potential difference of the battery that is ΔV = 12 V. The…

Q: True or False; explain why Similar to capacitance, inductance contains only geometric information…

A: Capacitance is the ability to store energy in the form of an electric field. Inductance, which is…

Q: Would you use a large inductance or a large capacitance in series with a system to filter out low…

A: At a lower frequency, the capacitor has a large capacitive reactance because the capacitive…

Q: 1. When an impedance, consisting of an inductance L and a resistance R in series, is connected…

Q: 5. What is the inductance in Henry of an inductor whose reactance is 15.6 2 at 73.0 Hz? Round-off to…

Q: - At high frequencies, an inductor becomes an open circuit. Dis- cuss why this is so.

A: At the higher frequency the impedance of the inductor increases. the increase impedance increases…

Q: 2. Propose some other methods to find the inductance.

Q: 1. A generator is shown below. If the period of rotation of the spinning loop of wire is T, what is…

A: Maximum magnetic flux is when coil is perpendicular to magnetic flux and all field lines pass…

Q: Tarik winds a small paper tube uniformly with 173 turns of thin wire to form a solenoid. The tube's…

A: Given data : Number of turns, N = 173 Diameter of the tube, D = 7.95 mm =…

Q: An LC circuit is driven at a frequency lower than its resonance frequency. What can be said about…

A: The phase angle is given by tanϕ =XL - XcR The resonant frequency is given by ω =1LC

Q: Q-3 A) If tension surface of the globule in transformer oil is 0.05N/m, radius of globule is 1µm,…

A: Surface tension σ=0.05 N/mRadius of globule R=1 umRelative permittivity of oil E1=2.5Relative…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

4) XL = 2nfL Solve for L then find the inductance (L – Unit of measure is h(henry's)) when the inductive
reactance (XL) is 48.2 Q and the frequency (f) is 60.0 Hz.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

In general, when a derived unit becomes complicated (involves too many standard units), what is done?
Check Your Understanding Restate 4.79105kg using a metric prefix such that the resulting number is bigger than one but less than 1000.
A popular saying is Give him an inch, and hell take a mile. What would be the equivalent saying using comparable metric units?
How many significant figures does each number have? If the number is exact or if the number of significant figures is ambiguous, explain. a. 12 in the formula r12d, where r is radius and d is diameter b. 105 c. 150 d. 1.50 102 e. 1.5 102 f. 0.15 103
Write the following quantities in standard units. (a) 0.55 Ms (b) 2.8 km (c) 12 mg (d) 100 cm
State how many significant figures are proper In the results of the following calculations: (a) (106.7)(98.2)/(46.210)(1.01) ; (b) (18.7)2 ; (c) (1.601019)(3712)
One student uses a meterstick to measure the thickness of a textbook and obtains 4.3 cm 0.1 cm. Other students measure the thickness with vernier calipers and obtain four different measurements: (a) 4.32 cm 0.01 cm. (b) 4.31 cm 0.01 cm, (c) 4.24 cm 0.01 cm, and (d) 4.43 cm 0.01 cm. Which of these four measurements, if any, agree with that obtained by the first student?
State the number of significant digits and implied precision of the following numbers. 1. 350,001 years 2. 4.30 x 10^4 seconds
Given the following measurements (in metric and English respectively) of a metalcylinder: length = 5.640 cm, 2.274 in; diameter= 2.188 cm, 0.878 in. Determine theexperimental value of the conversion factor from cubic centimeters to cubic inches.[Use three (3) decimal places].
Based only on consistency of units, which of the following formulas could not be correct? In each case, A is area, V is volume, C is circumference, and R is radius. V = CA C = A/R A = 2piR2 V = 6piR2
- What are some of the advantages of scientific notation? - After which numeral is the decimal point usually placed in scientific notation?What determines the number Numerical digits written in scientific notation?
Given P(28, -108 deg, 10) in cylindrical coordinate system, what is x in rectangular coordinates of P? (Compute up to 4 decimal places)