l5answer 4 5 6 4. A 440 V three-phase three-wire system feed two balanced Y-connected loads. One load is an induction motor which mayberepresented by an impedance of 10 + 15 ohms per phase. Theother is a lighting load equivalent to 15 ohms per phase.Find the total average powera. 32.11 kWb. 25.52 kWc. 30.28 kWd. 28.37 kW5. A 3-phase, 50 hp, 440 V, 50 Hz induction motor operates onfull load with efficiency of 89% and at a power factor of 0.85 lagging. A capacitor bank is connected in parallel toraise the full load pf to 0.95 lagging. What will be thecapacitance per phase if the capacitors are delta-connected?a. 66.8HFb. 9.23 HFc. 47.65 4 Fd. 12.65 4F

Since question 6 is not uploaded i solved 4 and 5

4. A 440 V three-phase three-wire system feed two balanced Y- connected loads. One load is an induction motor which maybe represented by an impedance of 10 + 15 ohms per phase. The other is a lighting load equivalent to 15 ohms per phase. Find the total average power a. 32.11 kW b. 25.52 kw c. 30.20 kW d. 28.37 kW 5. A 3-phase, 50 hp, 440 V, 50 Hz induction motor operates on full load with efficiency of 894 and at a power factor of

4. A 440 V three-phase three-wire system feed two balanced Y- connected loads. One load is an induction motor which maybe represented by an impedance of 10 + 15 ohms per phase. The other is a lighting load equivalent to 15 ohms per phase. Find the total average power a. 32.11 kW b. 25.52 kw c. 30.20 kW d. 28.37 kW 5. A 3-phase, 50 hp, 440 V, 50 Hz induction motor operates on full load with efficiency of 894 and at a power factor of

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

3. A three-phase 60 Hz Wye connected, 2,000-kVA, 2,300-V alternator give a short circuit-test current of 600-A for a certain field excitation. With the same excitation, the open circuit-test voltage was 900-V. The resistance between a pair of terminal was 0.12-ohm. Find the full load regulation at a) unity power factor and b) 0.8 power factor.
The output of 2200 Volts three phase induction motor used in a factory is800 HP. If the average p.f. is 0.8. Assume an average efficiency for themotor of 90 % (a) find the line current and kVA capacity of the generatorsupplying the factory. (b) If 400 HP of this load is noe supplied bysynchronous motor operating at 0.8 leading p.f. find the reduction in linecurrent and kVA capacity of generator.
A single-phase synchronous motor having a synchronous reactance of 5 ohms and negligible resistance is connected across a 2200-V supply. If the input power remains constant at 100 kW, calculate the generated e.m.f. when the power factor is 0.8 leading. Sketch the phasor diagram.
A 400-V, 3-phase induction motor load takes 900 kVA at a power factor of 0.707. Calculate the KVA rating of the capacitor bank to raise the resultant power factor of the installation of 0.866 lagging. Find also the resultant power factor when the capacitors are in circuit and the motor load has fallen to 300 kVA at 0.5 power factor.
A wye-connected synchronous motor connected to a 440V, 3-phase line is operating with an electrical load (torque) angle δ of -28 degrees while demanding 90 kW from the mains. The motor has negligible resistance and reactance of 1.5 Ω/ph.Calculate: (a) The line-to-neutral excitation voltage EO(LN) Angle = (b) The line current and power factor.IL Angle = pf =
An AC motor draws 5A from each line and runs with a line voltage of 460V. The motor is 90% efficient.a. How much electrical power does the motor use?b. How much electrical power does the motor produce?c. What is the phase voltage and phase current for the motor if the phases are connected in a wye configuration?d. If the motor runs at 1735 rpm, what is its synchronous speed, percent of slip and number of poles?
The open circuit and short circuit data of a three-phase, 3300 V, 500 kVA, star connected alternator are as follows : Open circuit test: Field current 9 A, open circuit voltage 470 line value Short circuit test: Field current 9 A, short circuit line current 80 A Resistance of the winding between the two slip rings is 2.3Ω Find the full load voltage regulation at 0.8 lagging power factor and 0.8 leading power factor.
A three phase star connected alternator of 1000 KVA, and 4600 volts, has an armature resistance of 2 ohms per phase and an armature synchronous reactance of 20 ohms per phase. Find the voltage generated at full load per phase if : a) Supplies power to a purely resistive load b) If you feed a load with inductive power factor of 0.85 c) If you feed a load with a capacitive power factor of 0.75 d) If you feed a load with capacitive power factor 0.4
A three-phase, Y-connected load takes 50 A current at 0.707 lagging power factor at 220 V between the lines. A three-phase Y-connected round-rotor synchronous motor, having a synchronous reactance of 1.27 ohm per phase, is connected in parallel with the load. The power developed by the motor is 33 kW at a power angle of 30°. Neglecting the armature resistance, calculate (a) the reactive kVA of the motor, and (b) the overall power factor of the motor and the load.
ABB company manufactures three phase, 10 kVA, 240 V, 60Hz, 6 pole wye connected synchronousgenerator. The generator is connected to an infinite bus at rated voltage. The generator has synchronousreactance of 2.0 ohms/phase and negligible stator resistance and is delivering the rated power at 0.9power factor lagging. Determine the following:a. Stator current b. Excitation voltage (per phase and line to line) c. What is the pullout torque (maximum torque) delivered by the generator?
A straight-line law connects terminal voltage and load of a 3-phase star connected alternator delivering current at 0.8 power factor lagging. At no-load, the terminal voltage is 3,500 V and at full-load of 2,280 kW, it is 3,300 V. Calculate the terminal voltage when delivering current to a 3-phase, star-connected load having a resistance of 8 o and a reactance of 6 ohm per phase. Assume constant speed and field excitation.
A 3 phase mesh-connected AC generator has a power angle of 15.4 degrees and synchronous impedance of 0.5 + j10 per phase while delivering 300A to its load at a lagging power factor and 13,200 volts line to line. Find the no load emf in volts, line to line.