4. A control system in which the manipulator variable, the control variable for the operation of the system is human is called.... a. Automatic control system b. Open circuit control system c. Loop control system d. Manual control system e. Closed circuit control system

Q: A function y(t) satisfies the following differential equation : dy(t) + y(t) = 8(t) dt where 8(t) is…

A: In this question We need to determine the y(t).  We are solving this problem using the Laplace…

Q: EX for finding the capacitance of Coaxial cable Let the potential between the two conductors is Vo…

A:

Q: Given that R1 = 10 kΩ R2 = 1 kΩ RD = 200 Ω, μnCox = 200 μA/V2, μpCox = 100 μA/V2, W/L = 20/0.18, λ =…

A: Given Data: a. A PMOS with, Positive supply Voltage VDD=1.8 V Drain resistance RD=200 ? Gate…

Q: 3. A source supplies power to a load through a line of impedance 1 +j1 22. The load consists of an…

A: Note- As per Bartleby Policy we are allowed to solve only three subparts. hence the solution for a,b…

Q: Vin(t) = 2sin(3t) find Vo(t)

A: here we have to find the output voltage across the resistor.   here we have taken C = 2000 Farads…

Q: Given C = 0.7 mF. R₁ = 124 Ohms, R₂ = 428 Ohms, and L = 1 H in Fig. P6.38, compute the voltage…

A:

Q: Q3 Determine the current Ix in figure shown by using Maxwell's loop current method. 80 30 20 Ix Hola…

A:

Q: What is the effect of a larger RB to the output, especially  when the capacitor is discharging?

A: For the given circuit it is asked the effect of a larger RB to the output, especially  when the…

Q: 1. Determine whether each of the following signals is periodic. If a signal is periodic, determine…

A: 1) for this question we need to find the system is period or non periodic (aperdioc) a)…

Q: A 10 MVA, 11 kV, 3-phase star-connected alternator is protected by the Merz-Price balance-current…

A:

Q: The electric field of a plane wave is given by Ē = â¸3 cos(@t − kz +75°) × e¯¤ V/m and the…

A:

Q: Definition of the Operational Amplifier. In which cases of circuits types it can be used.

A: The problem has been solved as follows

Q: Considering that the power developed by the power supply of the voltage source P25v < 25 watts. Find…

A:

Q: For the CS amplifier shown in Figure(3), RG = 500 k2, R₂ = 2 ks2, R₁ = 10 ks2, Rss - 3 ks, Rs = 0.2…

A: Given:

Q: Consider the FET amplifier in the fig. for these V. = 2 V VGS = 1mA/V² = 4 V Find the current DC…

A: Given a FET amplifier with, Terminal voltage, Vt=2 V. Kn'ωL=1 mAV2. Gate to source voltage, VGS=4 V.

Q: For the voltage-divider bias configuration of the figure below, determine (using approach): 6. Veko…

A:

Q: Find the bias voltages and currents of the transistor circuit below. VBB Holl RB, www IB 220 ΚΩ 12 V…

A:

Q: Implement a synchronous counter from 0 to 5, and back to 0.  Use D flip-flops for designing the…

A:

Q: In a series L-C circuit, the inductance and capacitance are 5 H and 2 μF respectively. of the…

A:

Q: To what extent did the transistor improve upon vacuum tubes?

A: We need to tell about advantages of transistors over vacuum tubes.

Q: Draw the Bode plot for the following:

A: In this question We need to draw the bode plot for the following.  We are solving this problem using…

Q: can you give me the steps plz

A: Given: A signal x(t) as, To do: Find and draw the signal, y(t)=x(t)+x(t-1)+x(t+1),

Q: 4. For the following circuit find the value of Vo1.V02.1 1kQ 20 V 0,47 ΚΩ Si

A: In this question,  We need to determine the voltage Vo1  , Vo2  and current I as shown in the…

Q: Find the maximum real power that can be transferred to an impedance ZL connected between terminals a…

A:

Q: what are the three rectanglar components called in the multisim diagram?

A: The required counter circuit can be designed in the multi-sim tool and the clock can be set to 1Hz.

Q: 15-Convert decimal number to hexadecimal? 2890 16-Add these hexadecimal numbers: FF + BB 17-Subtract…

A: The required conversion from one base number to another base number can be obtained by converting…

Q: Determine the minimum high voltage required to saturate the transistor below. +14 V ♫ ov RB 1.5 ΜΩ…

A: Given data VCC=18 V RC=9.1 kΩ RB=1.5 MΩ hFE=280 To find out We have to determine the minimum value…

Q: Lecture 5 P5.1. For the full-wave rectifier with active load Vrms=120 V, frequency f-60 Hz, load…

A: “Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: Draw a series circuit  dc source=30v R1=10 Ω R2=25 Ω R3=75 Ω solve the computed values in the…

A:

Q: The current in the circuit in (Figure 1) is known to be io = 50e-8000 (cos 6000t + 2 sin 6000t) mA…

A:

Q: In a series L-C circuit, the inductance and capacitance are 5 H and 2 HF respectively. of the…

A: Given data, Capacitance is given as  C=2 μF. Inductance is given as L=5 H.

Q: The current and voltage at the terminals of the capacitor in the circuit in are i(t) = 3.5e-2500 mA,…

A: In this question We need to determine the value of Is ,  initial voltage across the capacitor and…

Q: Question 6 A wire of diameter 2 mm and conductivity 5 x 107 S/m has 1029 free electrons per cubic…

A: Given data, Diameter is given as, d = 2 mm. Conductivity of conductor is given as,σ=5×107 S/m.…

Q: In the circuit in, switch 1 has been in position a and switch 2 has been closed for a long time. At…

A: It is given that:

Q: A round balloon of radius r=0.1 m has an electric charge Q=0.001 C distributed evenly over its…

A: it us asked to find surface charge density

Q: PROBLEM 6 Calculate the distribution factor of a 10 pole, three phase alternator having 90 slots.…

A: Both the parts has been solved as follows

Q: For a parallel RLC circuit, which one of the following statements is NOT correct? 1. 2. 3. 4. The…

A: Given: For a parallel RLC circuit, which one of the following statements is NOT correct?

Q: For this assignment you will be designing a power supply circuit for windshield heating element and…

A: According to the question, we need to design a power supply circuit for windshield heating element…

Q: Determine Rout (in k) for the figure if k = 0.3x10-3 V₁0 H 10 ΜΩ +16 V • 2.2 ΚΩ HH o V₂ VGS(Th) = 3…

A:

Q: A voltage wave is represented by v=200 sin 314 t. Find C (c) Average value (d) Frequency (e) Time…

A: It is given that: v=200sin314t

Q: 1. Calculate the following from the circuit below. RT IT, IRI, IR21R3,1R4, IR5 V1 – 12V R1 1kΩ 2 R2…

A:

Q: Why is electrical safety important for mechanical engineers ? Before beginning work in an electrical…

A: To explain: Importance of electrical safety for mechanical engineers.  Fundamental requirements…

Q: Chapter 1, problem 3. b) 101101000001012 c) 79110 - Convert the following numbers to hexadecimal

A:

Q: A certain transmitter radiates 9 kW with the carrier unmodulated and 10.125 kW when the carrier is…

A: We know that for a single-tone sinusoidal amplitude-modulation the total power is expressed as

Q: A certain voltage Tripler has 20 V rms on its input. What is the output voltage? Draw the circuit,…

A:

Q: Problem 12. A current of 5 A flows in the winding of an electric motor, the resistance of the…

A: Given: Current flowing in winding, I=5 A. Resistance of the winding, R=100 Ω.

Q: For R1-8, R2=7, R3-7, R4-8, R5-5, V1=7 V and V2=9 V in the shown circuit, apply mesh analys to find…

A: We need to find out given current for given circuit . Given data, R1=8 Ω,R2=7Ω, R3=7Ω, R4=8Ω, R5=5Ω,…

Q: Problem 8. A coil of copper wire has a resistance of 100 2 when its temperature is 0°C. Determine…

A:

Q: 11. The current flowing through a 1 mF capacitor is shown graphically in Fig. 7.44. (a) Assuming the…

A:

Q: Topic Maximum Power: Ro is the RL here. The variable resistor RL is adjusted until maximum power…

A: