answer all the questions please 4. Titanium reacts with iodine to form titanium(III) iodide:2 Ti(s) + 3 12(g) -->2 Til3(s) AHxn=-839 kJ.a. How much heat will be generated (or absorbed) by the reaction if 0.657 g of Til3(s) is produced?b. Is heat generated or absorbed by the reaction?c. Which are lower in energy - the reactants or the products?d. How many grams of Ti(s) was used in this reaction?

Here we are required to find the mass of Ti needed for the reaction.

4. Titanium reacts with iodine to form titanium(III) iodide: 2 Ti(s) + 3 12(g) -->2 Til(s) AH = -839 kJ. a. How much heat will be generated (or absorbed) by the reaction if 0.657 g of Tils(s) is produced? b. Is heat generated or absorbed by the reaction? c. Which are lower in energy - the reactants or the products? d. How many grams of Ti(s) was used in this reaction?

4. Titanium reacts with iodine to form titanium(III) iodide: 2 Ti(s) + 3 12(g) -->2 Til(s) AH = -839 kJ. a. How much heat will be generated (or absorbed) by the reaction if 0.657 g of Tils(s) is produced? b. Is heat generated or absorbed by the reaction? c. Which are lower in energy - the reactants or the products? d. How many grams of Ti(s) was used in this reaction?

World of Chemistry

7th Edition

ISBN:9780618562763

Author:Steven S. Zumdahl

Publisher:Steven S. Zumdahl

Chapter10: Energy

Section: Chapter Questions

Problem 61A

See similar textbooks

Similar questions

The enthalpy change for the reaction CH4(g)+2O2(g)CO2(g)+2H2O(l) is 891 kJ for the reaction as written. a. What quantity of heat is released for each mole of water formed? b. What quantity of heat is released for each mole of oxygen reacted?
9.53 Using these reactions, find the standard enthalpy change for the formation of 1 mol of PhO(s) from lead metal and oxygen gas. PbO(s)+C(graphite)Pb(s)+CO(g) H = 106.8 kJ 2C(graphite)+O2(g)2CO(g) H= -221.0 kJ If 250 g of lead reacts with oxygen to form lead(II) oxide, what quantity of thermal energy (in kJ) is ahsorhed or evolved?
9.103 One reason why the energy density of a fuel is important is that to move a vehicle one must also move its unburned fuel. Octane is a major component of gasoline. It burns according to the reaction 2C8H18(l)+25O2(g)16CO2(g)+18H2O(g) H = 1.10104 kJ Starting from this thermochemical equation, describe how you would determine the energy density, in kJ/g, for octane. Be sure to indicate what you would need to calculate or look up to complete this problem.
The addition of 3.15 g of Ba(OH)28H2O to a solution of 1.52 g of NH4SCN in loo g of water in a calorimeter caused the temperature to fall by 3.1 C. Assuming the specific heat of the solution and products is 4.20 J/g C, calculate the approximate amount of heat absorbed by the reaction, which can be represented by the following equation: Ba(OH)28H2O(s)+2NH4SCN(aq)Ba(SCN)2(aq)+2NH3(aq)+10H2O(l)
Microwave ovens convert radiation to energy. A microwave oven uses radiation with a wavelength of 12.5 cm. Assuming that all the energy from the radiation is converted to heat without loss, how many moles of photons are required to raise the temperature of a cup of water (350.0 g, specific heat =4.18J/gC) from 23.0C to 99.0C?
9.18 Calculate (a) q when a system does 54J of work and its energy decreases by 72 J and (b) E for a gas that releases 38 J of heat and has 102 J of work done on it.
How much will the temperature of a cup (180 g) of coffee at 95 C be reduced when a 45 g silver spoon (specific heat 0.24 J/g C) at 25 C is placed in the coffee and the two are allowed to reach the same temperature? Assume that the coffee has the same density and specific heat as water.
Ethanol, C2H5OH, is used as a fuel for motor vehicles, particularly in Brazil. (a) Write the balanced equation for the combustion of ethanol to CO2(g) and H2O(g), and, using the data in Appendix G, calculate the enthalpy of combustion of 1 mole of ethanol. (b) The density of ethanol is 0.7893 g/mL. Calculate the enthalpy of combustion of exactly 1 L of ethanol. (c) Assuming that an automobile’s mileage is directly proportional to the heat of combustion of the fuel, calculate how much farther an automobile could be expected to travel on 1 L of gasoline than on 1 L of ethanol. Assume that gasoline has the heat of combustion and the density of n—octane, C8H18(Hf=208.4kJ/mol;density=0.7025g/mL).
9.57 The heat of combustion of butane is —2877 kJ/mol. Use this value to find the heat of formation of butane. (You may also need to use additional thermochemical data found in Appendix E.)
A sample of nickel is heated to 99.8C and placed in a coffee-cup calorimeter containing 150.0 g water at 23.5C. After the metal cools, the final temperature of metal and water mixture is 25.0C. If the specific heat capacity of nickel is 0.444 J/C g, what mass of nickel was originally heated? Assume no heat loss to the surroundings.
Combustion reactions involve reacting a substance with oxygen. When compounds containing carbon and hydrogen are combusted, carbon dioxide and water are the products. Using the enthalpies of combustion for C4H4 ( 2341 kJ/mol), C4H8 (2755 kJ/mol), and H2 (286 kJ/mol), calculate H for the reaction C4H4(g)+2H2(g)C4H8(g)
A 5.00-g sample of aluminum pellets (specific heat capacity = 0.89 J/C g) and a 10.00-g sample of iron pellets (specific heat capacity = 0.45 J/C g) are heated to 100.0C. The mixture of hot iron and aluminum is then dropped into 97.3 g water at 22.0C. Calculate the final temperature of the metal and water mixture, assuming no heat loss to the surroundings.