very soluble4. Would the Ksp calculation of sodium chloride be too high or too low based on the following errors? Explain why.Some of your solution was spilled as the beaker was being dehydrated.a.Reflection:b. Your "saturated" solution wasn't really saturated at the beginning of your experiment.

4. very soluble Would the Ksp calculation of sodium chloride be too high or too low based on the following errors? Explain why. a. Some of your solution was spilled as the beaker was being dehydrated. Reflection: b. Your "saturated" solution wasn't really saturated at the beginning of your experiment.

4. very soluble Would the Ksp calculation of sodium chloride be too high or too low based on the following errors? Explain why. a. Some of your solution was spilled as the beaker was being dehydrated. Reflection: b. Your "saturated" solution wasn't really saturated at the beginning of your experiment.

EBK A SMALL SCALE APPROACH TO ORGANIC L

4th Edition

ISBN:9781305446021

Author:Lampman

Publisher:Lampman

Chapter88: Column Chromatography

Section: Chapter Questions

Problem 5P

See similar textbooks

Similar questions

2. Look up the solubility data for benzoic acid in the solvent toluene. Is benzoic acid more or less soluble in toluene than water? Why? 3. What would be a disadvantage of using toluene in this experiment? J 2. Look up the solubility data for benzoic acid in the solvent toluene. Is benzoic acid more or less soluble in toluene than water? Why? 3. What would be a disadvantage of using toluene in this experiment?
Compute for the numerical value of the gravimetric factor required to convert the given precipitate into the desired analyte. 1. Magnesium ammonium phosphate (MgNH4PO4) precipitate into phosphorous (as diphosphorous pentoxide, P2O5). 2. Magnesium ammonium phosphate hexahydrate (MgNH4PO4.6H2O) precipitate into nitrogen.
Compute for the numerical value of the gravimetric factor required to convert the given precipitate into the desired analyte. Answer the following: a. Magnesium oxide (MgO) precipitate into magnesium. Express answer in THREE SIGNIFICANT FIGURES. b. Silver chromate (Ag2CrO4) precipitate into silver. Express answer in THREE SIGNIFICANT FIGURES. c. Magnesium ammonium phosphate hexahydrate (MgNH4PO4.6H2O) precipitate into phosphorous (as tetraphosphorous decoxide, P4O10) . Express answer in THREE SIGNIFICANT FIGURES.
Can you proceed with sample analysis even without standardizing the titrant solution? Why or why not? You have finished two trials of the sample analysis for the experiment and you noticed that the burette is almost empty (~5 mL remaining). Should you add more titrant before the next sample analysis or not? Why or why not?
Which error will lead to negative deviation from the theoretical Keq? a. cuvette was filled to the brim with the sample. b. cuvette was washed with sodium hydroxide instead of distilled water. C. standard with the highest concentration was used in autozero. d. cuvette was misplaced such that the opaque side faces the light
A 25.00 mL of pond water was analyzed using Winkler method. A standardized sodium thiosulfate (0.1000 M) was used to titrate the water sample. a. Calculate the moles of sodium thiosulfate reacted to the sample if 1.75 mL was used during the titration. b. How much moles of I2 reacted with the manganese oxide precipitate? c. Compute for the dissolved oxygen in the sample. Express the concentration in ppm.
How many grams of NaAsO, should be weighed out to prepare a stock solution of 100 mg/L in 500 mL deionized water. Use the stock solution to prepare 4 different standard solution that can be used to prepare an analytical calibration curve to measure the concentration of 750 sample in the concentration range of 10-35 mg/L. Draw a proposed calibration curve (based on the results you achieved).
7- Place the stopper on the volumetric flask and mix the solution thoroughly by inverting and shaking the flask. Don't add water to a level above the line on the neck of the flask. beaker balance $4.68 stirrer bar 6 volumetric flask C D Conclusion: state the concentration of your solution. E E Analysis: a. Calculate the concentration of your solution. b. Why was it necessary to invert the volumetric flask? c. Why should the final solution be left stopper? d. If we filled the flask to above the line how would this have changed the concentration of the solution?
Often, palnters mix blue and white palnt to lighten Its color. Which of the following statements below are true regarding how the presence of two pigments In a single unknown solutlon would affect the results of your experiment? O With two cations in solution, both cations can potentially react with the chosen test. O if there are two different results/ppt/color changes, there could be interference, making the identification very difficult. O For any available test that has two matching or simlar results, multiple tests will need to be performed in order to identify both pigments correctly O The two cations can react with each other to form a precipitate. Therefore, the cations are no longer available to react with the reagent added for a particular test making it very difficult, it not impossible, to identify the cations.
Consider the following scenario: After the first compound elutes off of the column, you collect multiple fractions without seeing the next compound begin to elute. What change might you want to make before you continue taking fractions?
» You will only use one temperature for this experiment. It is recommended to use room temperature. Temperature (°C) 25 C Write the Ksp expression here: Calculate the Ksp value here (show work): Solid: Sr(103)2 Volume of distilled water Mass of solid (mL) (g) 100mL 150g Molarity of Sr²+ 4.2x10^-3 Molarity of 103* 8.4x10^3
Temperature - distillate volume plot for fractional distillation of benzene (b. pt. 80°C) and toluene (b. pt. 110°C ) The area where toluene is being distilled from the mixture. a. cannot be determined. b. FR1 c. FR3 d. FR2