4.a. An intersystem bonding termination will typically be used as a ground junction for a/an A. patient care area. B. communications system installation. C. fire protection system. D. information technology room. 4.b. The supply systems for sensitive electronic equipment are _______ systems. A. four-wire, three-phase B. three-wire, single-phase C. three-wire, three-phase D. four-wire, single-phase

4.a. An intersystem bonding termination will typically be used as a ground junction for a/an A. patient care area. B. communications system installation. C. fire protection system. D. information technology room. 4.b. The supply systems for sensitive electronic equipment are _______ systems. A. four-wire, three-phase B. three-wire, single-phase C. three-wire, three-phase D. four-wire, single-phase

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter15: Dryer Outlet, Lighting, And Receptacle Circuits For The Laundry, Powder Room, Rear Entry Hall,and Attic

Section: Chapter Questions

Problem 18R: A residential air-conditioning unit is installed in the attic. a. Is a lighting outlet required?...

See similar textbooks

Similar questions

It is generally understood that grounding and bonding together all metal parts of an electrical system and the metal shield of the cable television cable to the same grounding reference point in a residence will keep both systems at the same voltage level should a surge, such as lightning, occur. Therefore, if the incoming cable that has been installed by the CATV cable company installer has the metal shield grounded to a driven ground rod, does this installation conform to the NEC? ___________
A residential air-conditioning unit is installed in the attic. a. Is a lighting outlet required? __________ b. What Code section applies? __________ c. If a lighting outlet is required, how shall it be controlled? __________ d. What Code section applies? __________ e. Is a receptacle outlet required? __________ f. What Code section applies? __________
Type UF cable, buried underground, fed from a 15-ampere, ground-fault circuit interrupter at a one-family dwelling must have a minimum cover of
What are the steps for plotting points on microstation uisng offset, station, side and elevation?
In the conduit diagram shown in attached picture, determine how many wires are in each conduit between each piece of equipment. Identify each wire terminal connection and the quantity of wires, as shown in the example, above the disconnect
Which of the following is a term missing from the National Electrical Code but used by manufacturers of equipment that's suitable for use as service equipment? Micro-grid  Selective coordination Neutral disconnect link Grounding triad The _______ is required to be connected to the grounded conductor of the sensitive electronic system on the line side of the separately derived system disconnecting means. main bonding jumper  equipment grounding terminal bus neutral ground strap neutral disconnect link
6. Which type of cable would you use to connect two buildings in an office installation?A. Buried loose-tube cableB. Aerial armored cableC. OFNP cableD. Tight-buffered cable
analyse the rating of wires/ cables and mcb used for different types of loads
3.Is it advisable to use Multi-pair punch in terminating cables in patch panels? Why?
When installing a surge arrester at the service of less than 1000 volts, the grounding conductor shall be connected to ______. the grounded service conductor the grounding electrode conductor III. the grounding electrode for the service the equipment grounding terminal in the service equipment (a.) I & II only (c.) III & IV only (b.) I & III only (d.) I, II, III or IV
In the conduit layout shown in picture attached, determine how many wires are contained in each conduit between each piece of equipment. Identify each wire with a proper terminal marking, as shown in the example, above the disconnect switch.
a. The Code requires a minimum of two small-appliance circuits in a kitchen. Is it permitted to connect a receptacle in a dining room to one of the kitchen small-appliance circuits? _______________ What Code section applies to this situation? _______________ b. Are outdoor weatherproof receptacles permitted to be connected to a 20-ampere small-appliance circuit? _______________ c. Receptacles located above the countertops in the kitchen must be supplied by at least _______________ 20-ampere small-appliance circuits.