-5 2 m /s) flows in a tube that has a In the figure shown, water (density=1000 kg/m and viscosity 1x10 diameter (d=1.9 cm) and a length L= 53 m at 1.3 kg/min. A valve was installed to the pipe. The manometers reading are given as: (h = 0.128 m, z = 0.80 m). What is the head loss coefficient of the valve?

-5 2 m /s) flows in a tube that has a In the figure shown, water (density=1000 kg/m and viscosity 1x10 diameter (d=1.9 cm) and a length L= 53 m at 1.3 kg/min. A valve was installed to the pipe. The manometers reading are given as: (h = 0.128 m, z = 0.80 m). What is the head loss coefficient of the valve?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Q2/ A fluid containing (water, oil, sand) flowing through the tube and open to the atmosphere as shown in the figure below.. Note that p° = 1.013*10° Pa Calculate the absolute pressure (Pa). Density: Pwater = 1000 kg/m³ Poil = 800 kg/m³ Psand = 200 kg/m³ Po h3=12 cm hy=12 cm hs al2cm oiL Pa h=5 cm h2 = 6 cm Sand water
Q2/ A fluid containing (water, oil, sand) flowing through the tube and open to the atmosphere as shown in the figure below... Note that p° = 1.013*10$ Pa Calculate the absolute pressure (Pa). Density: Pwater = 1000 kg/m³ Poil = 800 kg/m' Psand = 200 kg/m' %3D h3=12 cm oiL Pa hi=5 cm h2=6 cm !3! →Sand water
The device shown in the fugure below is known as a venturi. In theis specific venturi the differential pressure between locations 1 and 2 is 5 psi and the diameter ratio is D2/D1 =0.35 if D2= 8inches find the air flow rate through the frictionless venturi
Q2/ A fluid containing (water, oil, sand) flowing through the tube and open to the atmosphere as shown in the figure below.. Note that p°- 1.013*105 Pa Calculate the absolute pressure (Pa). Density: Pwater = 1000 kg/m Pail = 800 kg/m Pand = 200 kg/m P. h3=12 cm hg al2cm oIL Pa h25 cm ng = 6 cm %3D Sand water
A manometer, shown in the figure is being used to measure the head or pressure drop across a flowmeter. The heavy fluid is mercury, with a density of 13.6 g/cm3, and the top fluid is water, with density of 1.00 g/cm3. The reading on the manometer is R = 32.7cm. Calculate the difference in kPa, answer rounded to 1 decimal place.
= Water flows into a tank and out through another pipe, as shown in the figure below. The water in the tank has a surface area, Asur f 5.6 m². At the bottom of the tank there is a door inclined at an angle = 25 degrees with respect to the horizontal. The door has a length L = 1.1 m and a width w=1 m (out of the page). The flowrate into the tank is Q₁ (t) flowrate out is Qo(t) = 0.05 m³/s At time t = Asurf = 0.26 m³/s and the 0, the water has a depth ho = 2.5 m. The density of water is p = 1000 kg/m³. Ө h(t) Qout
A 200 m long pipe slopes down at 1 in 100 and tapers from 0-25 m diameter to 0-15 m diameter the pressure at th the lower end. If the pipe carries 100 litres of oil of specific gravity 0-85, find lower end. The upper end gauge reads 50 kPa. [Ans. 54-9 kP
A tube is given in which methyl alcohol is poured at a temperature of 25 degrees Celsius. To measure the flow velocity, a pitot tube (with mercury as a sealing liquid) is connected to the given tube (see figure). If the reading of the differential manometer in the pitot tube is h=225mm*hg - calculate the velocity of methyl alcohol
A 60 mm diameter pipe has a discharge of 450 litre/min. At a section the pipe has a sudden expansion to a size of 90 mm diameter. If the pressure just upstream of the expansion is 20 kPa, calculate the pressure just after the expansion. Assume the pipe to be horizontal at the expansion region. :2 d2 2 :2
The water levels in the reservoirs are constant in the three reservoir systems given below, where local losses are neglected. How many meters is the piezometer height at the node (D)? The fluid passing through the pipes is water and its kinematic viscosity is 1.02x10-6 m²/ s. Other data are given in the table below. please help me fast
For a certain value opening in a shut off valve experiment(exercise 1), the water with a velocity of 0.65 m/s passes through a the pipe of diameter 24 mm. Viscosity of water is 1.14 x10-3Ns/m². Find Reynold's number for this valve opening=
Oil of SG = 0.87 and a kinematic viscosity v = 2.2 x 10-4 m²/s flows through the vertical pipe shown in the figure below at a rate of 4 x 10-4 m³/s. Determine the manometer reading, h. Assume SGm = 1.3, D = 19 mm, 1 = 4 m. h = i eTextbook and Media m SG. Q -D SG