5- A particle moves with an acceleration which inversely proportional to its velocity (a=k/v) and start from the origin with speed u cm s'. After 3 second its sneed is 2u. find the distance covered in the 3 seconds

5- A particle moves with an acceleration which inversely proportional to its velocity (a=k/v) and start from the origin with speed u cm s'. After 3 second its sneed is 2u. find the distance covered in the 3 seconds

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: A combustion chamber in a Gas Turbine Power Plant has efficiency equal to 62.82%, What is the actual…

Q: 2. The hollow shaft used in A the system has the following conditions: В E Outer Ø: 110 mm Ø…

A: Given data Outer diameter of shaft = 110 mm = 0.11 m Allowable shearing stress = 85 MPa

Q: Answer the following question: 1. Assume the stabilizer of an airplane is a flat plate. If the…

A: Calculate the skin friction coefficient using the Reynolds number. Cf=1.328RN Here, RN is the…

Q: 7. Determine the tension developed in cables AB, AC, and AD required for equilibrium of the 300-lb…

Q: a Gas Turbine Power Plant whoseefficiency is between 2096 to 356. Mhat is the compression ratio…

A: Answer : A is correct.

Q: 1. Given the data as shown in the figure, determine the (a) maximum torque Tmax (N-mm) that maybe…

Q: Why should the overhang distance of a lathe tool be minimized? What occurs if a lathe tool is set…

Q: A young man saw his lover having a date with another man at the park. The young man confronts his…

A: Given data Young man runs with an acceleration 2.788 ft/s2 N15°W = 0.8498 m/s2 N15°W Girl runs…

Q: 1) Given the pound(p) and eccentric(e), with a total area of 21 inch^2. What is the status of the…

A: Given that, Area of the cross-section, A=21 in2Load acting on the cube's top surface, P=28000…

Q: A diesel power plant uses fuel with heating value of 45,325 kJ/kg. What is the density of the fuel…

A: Given data fuel used in powerplant = diesel heating value of diesel = 45325 kJ/kg

Q: To mixer design, estimate the power requirement (kw/m³), agitation type for homogenous reaction…

Q: 1. Calculate the length of time a 950-watt blow dryer would have to blow on an iron pipe (0.75 cm…

Q: An ideal regenerative cycle is executed with 56700 kg/hr of steam initially at 13.44 MPa and 594 °C.…

A: m = 56700*convert(kg/hr,kg/s) = 15.75 kg/sT[1] = 594[C]P[1] = 13440[kPa] P[2] = 7240[kPa] P[3] =…

Q: Forida Tidal power plant is one of the famous. officient tidal plant. What is the energy or power…

A: Barrage area, Abarrage= 1820 m2 vertical height range, hvertical = 3.2 m Sea water density, ρsea…

Q: 7. Determine the tension developed in cables AB, AC, and AD required for equilibrium of the 300-lb…

A: Solution for problem 7.

Q: Axes A and B are centroidal for a given non-symmetric area and the product of inertia about these…

A: Given figure Step 2 Breaking the figure into two parts

Q: Q6) In a refrigerant 22 refrigeration system the capacity is 180 kW at a temperature of -30°C. The…

Q: A certain gas weighs 3.19 x 10-3 slugs/ft3 at a certain temperature and pressure. What are the…

Q: A Kaplan turbine has a runner diameter of 4 m and a hub diameter of 1.2 m. The discharge through the…

A: The runner diameter of a kaplan turbine is 4 metres, while the hub diameter is 1.2 metres.The…

Q: The spherical gas tank is fabricated by bolting together two hemispherical thin shells of thickness…

Q: An ideal regenerative cycle is executed with 56700 kg/hr of steam initially at 13.44 MPa and 594 °C.…

Q: Draw the shear and moment diagrams for each beam shown in figure:

Q: Calculate the velocity v of the 50-lb cylinder after the 20-lb cylinder has dropped 6 ft. 41 lb 50…

A: m1= 50 lbm2= 41 lbm3= 20 lb20 lb cylinder has dropped 2 ft.Hence, y1= -6 ft, y2= 6 ft, y3= 6 ft To…

Q: Q3) If in a standard vapor-compression cycle using refrigerant 22 the evaporating temperature is…

Q: The ASME evaporation units of a boiler is 24,837,500 KJ/hr. The boiler auxiliary consumes 1.5MW.…

Q: At a given instant, the gear rack on the left has a velocity of 4.5 ft/s and is accelerating at 1.8…

Q: locate the Centroid Por the following areas:

Q: What will be the pressure head of a point in mm of Hg if pressure head of that point is equal to 63…

Q: closed system is comprised of 10kg of pure water substance initially at a temperature of 400 C and a…

A: Solution is attached below

Q: A HSS tool is used to turn a steel workpart that is 300 mm long and 80 mm in diameter. The…

A: Answer: 1. Cutting speed for maximum production rate: 49.7746 m/min 2. Tool life in min of cutting:…

Q: A riffle released a bullet from the ground at an angel of 420 degrees from the horizontal with…

Q: Solar renewable energy plant has 32 solar panel with 48 KW each. What is the solar KW rated output?…

A: No of solar panel, n = 32 Power rating of each panel, P = 48 KW

Q: Power plant site depends on several factors such as: A) avoidance of pollution & noise B) degree of…

A: Option ( D ) is correct All of the above

Q: Two identical sinusoidal waves, each of amplitude A, and differing by their phase constant,…

Q: Q2) A Carnot refrigeration cycle absorbs heat at -12°C and rejects it at 40°C. (a) Calculate the…

Q: 1. Given the data as shown in the figure, determine the (a) maximum torque Tmax (N-mm) that maybe…

Q: Solar renewable energy plant has 32 solar panel with 48 KW each. What is the solar KW rated output?…

A: No of solar panel, n = 32 Power rating of each panel, P = 48 KW

Q: Define as the average consumption output or throughput over a period of time. A power factor B…

A: Capacity factor is defined as the average consumption, output or throughout over a period of time.…

Q: A wedge split a sheet of 20°C water in the air. Both wedge and sheet are 1 m long into the paper.…

A: Given Velocity, v = 4 m/s Thickness, h = 4 cm = 0.04 m Angle = 60o Find Force…

Q: opic: torsion in circular shafts The hollow shaft used in the system has the following conditions:…

Q: /hich is "NOT" part of the (5) benefits of an Energy Management Systems (A) Cost reduction B return…

A: Q 36: option C is correct Customer need Benefits of energy management system are Cost reduction…

Q: 3. Block A in figure 3 below has a mass of 4 kg and is on the verge of tipping as it begins to slide…

Q: What will be the velocity of the follower at 90° using the following equation with segment angle…

A: Find the velocity of follower at 90 °.

Q: The hollow shaft used in the system has the following conditions: Outer Ø: 110 mm Ø Allowable…

Q: 24. A 2.0 kg disk is able to move on a straight, level track with negligible friction. With the disk…

Q: d its kinematic viscosity in m?/s and in stokes

A: To find Absolute viscosity Kinematic viscosity

Q: A Kaplan turbine has a runner diameter of 4 m and a hub diameter of 1.2 m. The discharge through the…

A: Answer: (a) The net available head on the turbine is 19.1 m. (b) The power developed by the turbine…

Q: Modified Sinusoidal function is composed of a) Only one sine function b} Two sine function with…

A: Modiefied Sinusoidal Funtion

Q: This question requires the use of the Thermodynamic Property Tables supplied as additional material.…

A: Solution is given below:

Q: Which is not a major component of a steam power plant? A) boiler B) heat supply system C) generator…

A: (A) Boiler: This is the main component of steam power plant used to supply heat to the water…

Concept explainers

Conservation of Energy

In physics, the rule of the conservation of energy states that energy doesn’t disappear from the atmosphere; instead, it changes its form from one type to another. Energy is one of the most important physical quantities in nature, and it cannot be created or destroyed — only transformed.

Question

5- A particle moves with an acceleration which inversely proportional to its
velocity (a=k/v) and start from the origin with speed u cm s'. After 3 second
its speed is 2u. find the distance covered in the 3 seconds

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step by step

Solved in 5 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A motorcycle starts from rest and has a velocity described by the graph. Determine the distance traveled by motorcycle during the time interval at (0
A train is uniformly accelerated and passes successive kilometer stones with velocity of 18 kmph and 36 kmph respectively. Calculate the velocity, when it passes the third kilometer stone. Also find the time taken for each of these two intervals of one kilometer?
A block is to start from rest and slide along a rectilinear path 12 in. long in 8 sec. It is to accelerate uniformlyover half its path during the first 4 sec and retard at the same rate during the remaining 4 sec. Determine theacceleration in inches per second per second and the speed at the end of the fourth second.
A particle moves on a circular path of 40 ft radius so that its arc distance from a fixed point on the path is given by s=4t³-10t where s is in feet and t is in seconds. Compute the total acceleration at the end of 2 sec.
A particle moves in a straight line according to the law x= 2t^3 -12t^2 + 4t, where x is in meters and t is in seconds. a) when t= 6 sec, compute the velocity and b) when the particle comes to rest again, what is its acceleration?
The certain particle has a motion given by the equation s = 3t4 – 4t3 + 5t2 where s is in meter and t in seconds. Compute its values of velocity and acceleration when t=3 sec.
The velocity of a particle moving along a straight line is v=t2+2t m/s, where t is in seconds. Ofits position s=0 when t=0, find its acceleration and position when t=4 seconds.
A projectile is launched at a rate of 4.4 m/s at an angle of 55 . State the projectiles position every 0.1 s starting at t=0 s. keep going until the height of the projectile goes negative. (The shot of Odysseues...)
If a particle moves along a straight path in such a way that s = 2t2 feet, where t is in seconds, what kind of acceleration has it? Find the acceleration when t = 5 sec. Find V when t = 10 secs.
As depicted in the graph below, a two-stage rocket is launched vertically upward in the time interval 0≤t≤30s, starting from rest at s = 0 m. Construct the v-t and s-graphs and determine the velocity and total distance covered by the object at t=60 seconds.
DYNAMICS OF RIGID BODIES (RECTILINEAR MOTION WITH CONSTANT ACCELERATION) A body starts with a velocity of 3 m/s and moves in a straight line with a constant acceleration. If its velocity at the end of 5 seconds is 5.5 m/s, determine the following:(a)the uniform acceleration(b)distance travelled in 10 seconds.
A particle moves counterclockwise on a circular path of 400 ft radius. It starts from a fixed point which is horizontally to the right of the center of the path and moves so that s=10t^2+20t where s is the arc distance in feet and t is in the time in sec. Compute the horizontal and vertical components of acceleration at the end of 3 sec.