Q.5: Given R1=102, R2=152, R3=22N and R4=102, find (i) the equivalent resistance of the circuit,(ii) the magnitude of power dissipated through resistance R1 and (iii) the magnitude of powerdissipated through resistance R4.ww wwwR,Vowwwwww12.0V

Answered: Image /qna-images/answer/fd5f349d-fb07-4290-b4fc-f37dcb3ce6bc.jpg

Answered: 5: Given R1=102, R2=152, R3=22N and…

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter29: Direct Current (dc) Circuits

Section: Chapter Questions

Problem 19PQ

See similar textbooks

Similar questions

Explain why R=R0(1 + a?T) for the temperature variation of the resistance R of an object is not as accurate as P=P0(1 + a?T) which gives the temperature variation of resistivity P.
The student engineer of a campus radio station wishes to verify the effectiveness of the lightning rod on the antenna mast (Fig. P21.71). The unknown resistance Rx is between points C and E. Point E is a true ground, but it is inaccessible for direct measurement because this stratum is several meters below the Earths surface. Two identical rods are driven into the ground at A and B, introducing an unknown resistance Ry. The procedure is as follows. Measure resistance R1 between points A and B, then connect A and B with a heavy conducting wire and measure resistance R2 between points A and C. (a) Derive an equation for Rx in terms of the observable resistances, R1 and R2. (b) A satisfactory ground resistance would be Rx 2.00 . Is the grounding of the station adequate if measurements give R1 = 13.0 and R2 = 6.00 ? Explain. Figure P21.71
An ECG monitor must have an KC time constant lessthan 1.00102s to be able to measure variations involtage oversmall time intervals, (a) If the resistance of the circuit (duemostly to that of the patient's chest) is 1.00kTwhat is the maximum capacitance of the circuit?(b) Would It be difficult in practice to limit the capacitance to less than the value found in (a)?
The values of the components in a simple series RC circuit containing a switch (Fig. P21.53) are C = 1.00 F, R = 2.00 106 , and = 10.0 V. At the instant 10.0 s after the switch is closed, calculate (a) the charge on the capacitor, (b) the current in the resistor, (c) the rate at which energy is being stored in the capacitor, and (d) the rate at which energy is being delivered by the battery.
f RR is the total resistance of two resistors, connected in parallel, with resistances R1R1 and R2R2, then 1R=1R1+1R21R=1R1+1R2. If the resistances are measured in Ohms as R1=25Ω,R2=42ΩR1=25Ω,R2=42Ω, with possible error of 1%1% in each case, estimate the maximum error in the calculated value of RR.
Which resistor, R1 or R2, experiences greater power dissipation in the circuit, given that R1 is greater than R2?
Consider the circuit shown in the figure below. Here, R1 = 2.00 Ω, R2 = 10.00 Ω, R3 = 5.00 Ω, R4 = 4.00 Ω, R5 = 3.00 Ω, and emf = 8.00 V. (a) Calculate the equivalent resistance of the R2 = 10.00 Ω and R3 = 5.00 Ω, resistors connected in parallel. (b) Using the result of part (a), calculate the combined resistance of the R2 = 10.00 Ω , R3 = 5.00 Ω , and R4 = 4.00 Ω resistors. (c) Calculate the equivalent resistance of the combined resistance found in part (b) and the parallel R5 = 3.00 Ω resistor.
For the circuit shown in Fig.1 below, C1 = 5μF, C2 = 4μF, C3 = 6μF and ∆V = 65V. Find:(a) the equivalent capacitance, (b) the charge on each capacitor and (c) the potential differenceacross each capacitor.Figure 1: Problem 2.Problem 3For the circuit shown in Fig.2 below, determine the resistance R such that the current in R is0.50 A, with the sense from a to b.Figure 2: Problem 2.Problem 4A straight wire of length 0.40 m, carrying current I = 7.0 A is oriented at angle θ = 27◦ toa uniform magnetic field B = 1.2 T. The field is in the positive x-direction. Determine themagnitude and direction of the magnetic force on the wire.1
Consider the circuit shown in the figure below. Here, R1 = 2.00 Ω, R2 = 10.00 Ω, R3 = 5.00 Ω, R4 = 4.00 Ω, R5 = 3.00 Ω, and emf = 8.00 V. (d) Combine the equivalent resistance found in part (c) with the R1 = 2.00 Ω resistor. (e) Calculate the total current in the circuit. (f) What is the voltage drop across the R1 = 2.00 Ω resistor?
A student performs a lab where the voltagedrop across a resistor is measured as a functionof current. Plot a graph from the values givenin the following table, and determine theresistance of the circuit. Current, I (mA) Potential Difference, Current, I (mA)V (V)0.00 0.00200 9.00400 16.0600 24.0800 31.01000 40.0
Given the following circuit, find the equivalent resistance and the electric current that passes through resistor R7. The resistance values are R1= 10 oms (Ω), R2= 15 oms, R3= 5 oms, R4= 25 oms, R5= 10 oms, R6= 10 oms, R7= 20 oms (The supply voltage is 10 volts)
In Fig. , the battery has negligible internal resistance and E = 48.0 V. R1 = R2 = 4.00 Ω and R4 = 3.00 Ω. What must the resistance R3 be for the resistor network to dissipate electrical energy at a rate of 295 W?

SEE MORE QUESTIONS

Recommended textbooks for you

Physics for Scientists and Engineers: Foundations…

Physics

ISBN:

9781133939146

Author:

Katz, Debora M.

Publisher:

Cengage Learning

University Physics Volume 2

Physics

ISBN:

9781938168161

Author:

OpenStax

Publisher:

OpenStax

Principles of Physics: A Calculus-Based Text

Physics

ISBN:

9781133104261

Author:

Raymond A. Serway, John W. Jewett

Publisher:

Cengage Learning

Physics for Scientists and Engineers: Foundations…

Physics

ISBN:

9781133939146

Author:

Katz, Debora M.

Publisher:

Cengage Learning

University Physics Volume 2

Physics

ISBN:

9781938168161

Author:

OpenStax

Publisher:

OpenStax

Principles of Physics: A Calculus-Based Text

Physics

ISBN:

9781133104261

Author:

Raymond A. Serway, John W. Jewett

Publisher:

Cengage Learning

College Physics

Physics

ISBN:

9781938168000

Author:

Paul Peter Urone, Roger Hinrichs

Publisher:

OpenStax College

SEE MORE TEXTBOOKS

5: Given R1=102, R2=152, R3=22N and R4=102, find (i) the equivalent resistance of the circuit, (ii) the magnitude of power dissipated through resistance R1 and (iii) the magnitude of power dissipated through resistance R4. ww R.