5- Increasing the load on the steam engine requires more mass of steam to be supplied to f the cylinder. 6- It is better to increase the polytropic index of compression in order to enhance T performance of reciprocating compressor. 7- The air box at entry to the compressor is used to accumulate air before supplying it to T the utility benefit of it. True of false

5- Increasing the load on the steam engine requires more mass of steam to be supplied to f the cylinder. 6- It is better to increase the polytropic index of compression in order to enhance T performance of reciprocating compressor. 7- The air box at entry to the compressor is used to accumulate air before supplying it to T the utility benefit of it. True of false

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter26: Applications Of Refrigeration Systems

Section: Chapter Questions

Problem 9RQ: Three disadvantages of parallel compressor systems are _____, _____, and ____.

See similar textbooks

Similar questions

A compressor must operate in a speed range between 0 and 1500 rpm. The friction torque of Coulomb Tc is 10 N. m. What should be the required Tw working torque if the compressor constant is 0.5 N. m. s. What is the power required by the engine that operates this compressor?
a reciprocating compressor handles 1001 cfm
Question 4 A single acting two stage reciprocating compressor takes in air at a rate of 0.2 m3/s at a pressure of 0.1 MPa @ 16˚C. The air is compressed to 0.7 MPa while running at 600 rpm. Compression is ideal and the process follows pV1.25 = C. Perfect intercooling takes place and neglecting clearance. What is the Intermediate pressure (IP) in kPa .............., the volume of the Low-Pressure cylinder in m3................... , the volume of the High-Pressure cylinder in m3.................. and the Total Cycle Power (TCP) in kW .....................
Read the question carefully before answering. Box or indicate your final ansurers when solving and draw your diagrams cleanly. Complete solution please. Use 2 decimal places when solving and for final answers. Draw the PV and TS diagram with proper label of points when required. 5. A centrifugal compressor has a single stage and 4 stage model with suction conditions of 100 kPa and 25c. The air must be discharged at 300 kPa. Find the compressor work and heat rejected for each model if the compression is isentropic, and the intercooler pressures.
The compression ratio of an Otto cycle is 8, at the beginning of the zanthropic compression process, the pressure of the air is 100 kPa, the temperature is 27 "C, the volume is 550 cm. At the end of the lzantropic expansion process, the temperature of the air is 700 K. Using the specific temperature values at room temperature (according to the cold air standard assumptions) Find the gravity of the air.
Q3: A distillation column is separating acetone(more volatile component) from ethanol. As pictured, there are two feeds with flow rates F₁=100 mol/hr and F₂-200 mol/hr. Feed 1 has z₁-0.7 and is saturated liquid. Feed 2 has z2 0.4 and is a superheated vapor (q=-0.1) where approximately 1 mol of liquid will vaporize on feed stage for each 10 mol of feed. We desired xd-0.95 and xw-0.05. How many stages are needed to achieve this separation? Ln/Vn=0.64.
2. A single acting air compressor with a clearance of 6% takes in air at atmospheric pressure and temperature of 85F, and discharges is at a pressure of 85 psia. The air handled is 0.25 ft3/cycle measured at dischard pressure. If the compression is isentropic, find the power of the compressor if rpm is 750. a. 128.6595 kW b. 3167340 ft-lb/s c. 71.6011kW d. 95.98kW Please answer this immediately. Thank you!
no. 3 question: A diesel engine powers a boat. The engine’s cylinders each have a compression ratio (Vmax/Vmin) of 12 and the Vmax is 4ft3. If 1 cylinderis in the isobaric compression stroke, find the final temperature if the initial temperature is 540F Main question: From number 3, if the gas tankaccident happened on top of Mt. Everest’s summit where patm is only 33.7 kpa and the readings obtained are the same, find the new finaltemperature
2. An air compressor is to compress 510m²/hr from 100kpa to 10bar, for an ideal compression with n=1.3, what will be the percent saving in power due to two staging?
2. A single acting air compressor with a clearance of 6% takes in air at atmospheric pressure and temperature of 65F, and discharges is at a pressure of 85 psia. The air handled is 0.25 ft3/cycle measured at dischard pressure. If the compression is isentropic, find the power of the compressor if rpm is 750. a. 128.6595 kW b. 3167340 ft-lb/s c. 71.6011kW d. 95.98kW
Exampie Air conditioning unit uses Freon R-22 for conditioned office at 25 C. The evaporating temperature is 17 C and the condensing temperature is 47 C. The compressor is reciprocating and single acting with number of cylinders of 4, volumetric efficiency of 0.9, number of revolution is 900 rpm cylinder dimensions of L/D is 1.25. If the compressor power is 3 kW and mechanical efficiency of 0.9, estimate the followings: the refrigerant mass flow rate in kg/min, refrigeration capacity in TR, cylinder dimensions, condenser heat load, coefficient of performance and relative efficiency. and
3 - A 4 cylinder 4-stroke S.I square engine has a compression ratio of (8), and bore (100 mm). The volumetric efficiency of each cylinder is (75%). The engine operates at a speed of (4800 rpm) with air to fuel ratio of (15).given the calorific value of fuel is (42 MJ/kg), atmospheric air density is (1.12 kg/m³), mean pressure in the cylinder (10 bar) and mechanical eff (80%). Determine indicated thermal eff and brake power. [answer: 42.5% , 100.48 kw]