All parts of question five please. Heading 2* Important5. For an LROC-circuit on a typical US outlet that has an inductance of 0.58 H, a current of 5.5 A, and a resistanceof 10 , find:a) Capacitanceb) Impedancec) Phase Angled) Resonance Frequency6. What's the power factor: 753,000 kVA, 701,000 kW2D00DOD0IK »

Since you have asked multiple questions, we will solve the first question for you. If you want any…

Answered: 5. For an LRC-circuit on a typical US…

5. For an LRC-circuit on a typical US outlet that has an inductance of 0.58 H, a current of 5.5 A, and a resistance of 10 2, find: a) Capacitance b) Impedance c) Phase Angle d) Resonance Frequency

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter15: Alternating-current Circuits

Section: Chapter Questions

Problem 20P: At 1000 Hz, the reactance of a 5.0-mH inductor is equal to the reactance of a particular capacitor....

See similar textbooks

Related questions

Q: 6. You have a 400-2 resistor, a 0.300-H inductor, and a 8.00-µF capacitor. Suppose you take the…

A: The impedance of a series L-C-R circuit is Z=R2+XL-XC2 R is resistance Inductive Reactance, XL=ωL…

Q: An AC generator with an output rms voltage of 36.0 V ata frequency of 60.0 Hz is connected across a…

Q: An AC voltage source of V = 310 sin (25?t) is connected to a 140 Ω resistor, where V is in Volts and…

Q: An inductor (L = 400 mH), a capacitor (C = 4.43 µF), and a resistor (R = 500 Ω) are connected in…

Q: Can an RLC circuit have the same impedance at two different frequencies? Explain.

A: The impedance of a RLC circuit is given by Z=R2+XL-XC2

Q: 8. The impedance of the given AC circuit is.. а. Хс b. R с. X d. R?

A: Impedence is given by Z = R2+(XL-XC)2

Q: A 60-Hz AC source with a voltage amplitude of 120 V powers a series RLC circuit. The capacitive…

A: Capacitance of capacitor C = 3 uF

Q: 3) An RLC circuit has a 15.0 2 resistor, a 25.0 mH inductor, and a 30.0 µF capacitor in series. The…

A: R = 15 ohm L = 25 mH C = 30.0 μF Vrms = 12 V frequency = 425 Hz

Q: 11. Figure shows a series LCR circuit connected to a variable frequency 230V source. L-5.0H, C=80µF,…

A: Given value--- E = 230 V. R = 40 ohm. L = 5 H. C = 80 micro F. We have to find--- resonance…

Q: A 1200hz ac signal at 50 v is connect across a RLC circuit consisting of a 100omh resistor a 0.5…

Q: 3. The maximum voltage of an ac signal is 8.0 V. What is the rms value of this voltage? 4. An ac…

Q: AC circuit

Q: An inductor has a 54.0-Ω reactance when connected to a 60.0-Hz source. The inductor is removed and…

A: Given:- Reactance(xL)=54.0 ohm Frequency(f)=60 Hz Voitage(v) = 100 V Frequncy (f)=50.0 Hz Find the…

Q: An inductor (L = 410 mH), a capacitor (C = 4.43 μF), and a resistor (R = 430 ) are connected in…

Q: A series RLC circuit has a resistance of 25.0 Ω, a capacitance of 50.0 μF, and an inductance of…

A: Given: The resistance of the circuit is 25.0 Ω. The capacitance of the circuit is 50.0 μF. The…

Q: 1. Calculate the impedance for a series RLC circuit with a 1.0 k2 resistor, a 4400 pF capacitor, and…

A: According to the company policy, only 1st question will be answered. Please post the rest…

Q: 5. A coil of inductance 80mH and negligible resistance is connected in series with a capacitance of…

Q: circuits

A: Ohm's law is one of the fundamental relationships that is found in maximum electronic circuits.…

Q: An AC source with an output rms voltage of 19.5 V at a frequency of 60.0 Hz is connected across a…

Q: In a series resonant circuit, the impedance of the circuit is a. zero b. minimum c. none of…

A: In the resonant circuit, the inductive reactance of the inductor becomes equal in value to the…

Q: An inductor has a 57.8-0 reactance when connected to a 60.0-Hz source. The inductor is removed and…

A: Solution:- 1) The reactance of an inductor of inductance L at frequency f , is given by Z =…

Q: A 38.6-μF capacitor is connected across a 60.0-Hz generator. An inductor is then connected in…

A: The capacitive reactance and the inductive reactance are the same in the case when the corresponding…

Q: An inductor (L = 400 mH), a capacitor (C = 4.43 µF), and a resistor (R = 500 Ω) are connected in…

A: a) The expression to determine the impedance is,

Q: 5. The angular frequency of an LCR circuit operating at resonance frequency can be written as: 1 LC…

Q: 3. A radio turning circuit consists of a fixed capacitor and a variable inductor. The tuner is tuned…

Q: An inductor is connected to a 20.0-Hz power supply that produces a 50.0-V rms voltage. What…

Q: #10 Power used in a Series RLS Circuit A device may be regarded as a series RLC cir- cuit with a…

A: Write the formula for capacitive resistance.

Q: A coil of inductance 40 mH, resistor of resistance 300 Q and a capacitor of capacitance 19.9 µF are…

A: L = 40 mH = 0.04 H R = 300 ohm C = 19.9 micro farad frequency (f) = 80 Hz Vpeak = 330 volts

Q: Q4. A coil has a resistance of 42 and an inductance of 9.55 mH. Calculate the following a. Reactance…

A: Solution: given that R = 4 Ohm L = 9.55 mH f = 50 Hz V = 240 V

Q: Given the value of impedance, Z for an RLC circuit at resonance frequency is 300 N. Calculate the…

A: impedence,Z=R2+(XL-XC)2at resonanceXL=XCZ=Rgiven that Z=300Ω so,R=300ΩR is a constant will not vary…

Q: you have a series RLC Circuit made wíth a Resistor R=43-0 J, inductor L=27.0 MH and capacitor C=…

Q: 6. Give one condition for resonance to occur in a series RLC circuit.

Q: An AC source with an output rms voltage of 36.0 V at a frequency of 60.0 Hz is connected across a…

A: Given data The rms voltage is given as V = 36 V. The frequency is given as f = 60 Hz. The…

Q: 11. A series RLC circuit consists of 100-N resistor, a 10.0-µF capacitor, and a 0.3 H inductor. The…

A: GivenR=100 ΩC=10 μF=10×10-6 FL=0.35 HVrms=120 Vf=60 Hz

Q: What must be the capacitance for a station at 1700 kHz ? What is the inductance (assumed…

Q: 1- Explain the effect of increasing and decreasing of resistor's value on series and parallel RLC…

A: 1. A series RLC circuit is an electrical circuit made up of a resistor (R), an inductor (L), and a…

Q: 23. Consider an LC circuit-that is, an RLC circuit with R = 0-with input voltage E(t) = Eo sin wt.…

Q: 36) (a) Calculate the resonant angular frequency of an RLC series circuit for which ?=20Ω, ?=75 mH,…

A: Given,Resistance, R = 20 Ωinductance, L = 75 mHcapacitance, C = 4.0 μC

Question

All parts of question five please.

Heading 2
* Important
5. For an LROC-circuit on a typical US outlet that has an inductance of 0.58 H, a current of 5.5 A, and a resistance
of 10 , find:
a) Capacitance
b) Impedance
c) Phase Angle
d) Resonance Frequency
6. What's the power factor: 753,000 kVA, 701,000 kW
2
D00
DOD0
IK »

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

An LC circuit in an AM tuner (in a car stereo) uses a coil with an inductance of 2.5 mH and a variable capacitor. If the natural frequency of the circuit is to be adjustable over the range 540 to 1600 kHz (the AM broadcast band), that range of capacitance is required?
An AC generator with an output rms voltage of 36.0 V at a frequency of 60.0 Hz is connected across a 12.0-F capacitor. Find the (a) capacitive reactance, (b) rms current, and (c) maximum current in the circuit. (d) Does the capacitor have its maximum charge when the current takes its maximum value? Explain.
At 1000 Hz, the reactance of a 5.0-mH inductor is equal to the reactance of a particular capacitor. What is the capacitance of the capacitor?
At what frequency will an 80.0 mF capacitor have a reactance of 0.250 ?
What capacitance should be used to produce a 2.00 M(reactance at 60.0 Hz?
The two circuits shown below act as crude low-pass filters. The input voltage to the circuits is vin, and the output voltage is vout. (a) Show that for the capacitor circuit, voutvin=11+2R2C2 and for the inductor circuit, voutvin=RR2+2L2 (b) Slow that for low frequencies, voutvin , but for high frequencies, vout0 .
In an LC circuit, what determines the frequency and the amplitude of the energy oscillations in either the inductor or capacitor?
Check Your Understanding Show that the tins voltages across a resistor, a capacitor, and an inductor in an ac circuit where the tins current is Irmsare given by IrmsR,IrmsXC , and IrmsXL, respectively. Determine these values for the components of the RLC circuit of Equation 15.12. Pave=12t0v0cos (15.12)
An AC generator with an output rms voltage of 36.0 V at a frequency of 60.0 Hz is connected across a 12.0-F capacitor. Find the (a) capacitive reactance, (b) rms current, and (c) maximum current in the circuit. (d) Does the capacitor have its maximum charge when the current takes its maximum value? Explain.
Why in present day technology we do not use inductance filters?
plss answer within 20mins Suppose you want the current amplitude in a pure inductor in a radio receiver to be 263.41 uA when the voltage amplitude is 7.23 V at a frequency of 3.15 MHz (corresponding to the upper end of the AM broadcast band). What inductance is needed? Final answer should be in two (2) decimal places. Express your answer in exponential form. For Example: 1.13 x 10-4 should be answerd as 1.13e-4. 5.00 x 103 should be expressed as 5.00e+3. For the final answer, express the unit in symbols. For example: 5.00 x 103 Kelvin should be expressed as 5.00e+3 (K).
Suppose you wanted to build a circuit that would oscillate at 30,000 Hz (30 kHz) by employing a capacitor and an inductor in series. Being a experimenter with physics, you open your parts drawer and find a capacitor that is marked 1 μμf which you figure is a good start. But, all you have now is a spool of wire and you decide to make a solenoid to provide the inductance.