5. Which one of the following devices can generate sum of product functions? 1. Multiplexer 2. Encoder 3. Demultiplexer

Q: Binary to Octal Decoder using 7-Segment Display

A: To design Binary to Octal Decoder using 7-Segment Display

Q: What will be the binary representation of 66 DEC in BCD coding system

A: Given: Decimal number 66

Q: 1- Design a 3-bit UP-DOWN synchronous counter such that the UP or DOWN counter is selected by a…

A: The state diagram for the UP-DOWN synchronous counter is shown in the below figure.

Q: IS sampled, que system. The coded signal is then transmitted over a transmission channel of…

A: 53.

Q: 3.Which MUX is created when five 4-line to 1-line MUXS are connected? 1. 16-line to 1-line 2.…

A: Note: As per our policy, I have attempted the first question.

Q: Implement Four-to-one-line multiplexer with Logic diagram and Function table.

A:

Q: A DDS synthesizer has a 150-MHz clock and a constant value of 15. The ROM address register has 14…

A: It is given frequency of clock that is reference frequency is, Constant is given M = 15 Length in…

Q: 5 What is the conversion time for a 12-bit ADC with a clock frequency of 1 MHz?

A: The solution can be achieved as follows.

Q: 7. In a 4*1 Multiplexer, and given that 10=0, 1=0, 12=1, 13=1, and the data select lines (control…

A: Given that  In a 4*1 Multiplexer, and given that 10=0, 11=0, 12=1, 13=1, and the data select lines.…

Q: Home Work If the enable pulse frequency in Figure below were halved, determine the binary numbers…

A: Given waveform: To find: If the enable pulses frequency was halved, determine the binary numbers…

Q: In PLD, any of this process is called Programming?? O a. Blowing fuse O b. Read and write data o.…

A: Programmable Logic Devices are the integrated circuits. They contain an array of AND and OR gates.…

Q: For a PCM system with the following parameters, Parameters: (i) Maximum analog input frequency = 5…

A:

Q: SV D9 D8 D7 20 26 28 32 19 25 27 31 35 DO D3 D5 D6 GND 30 8's cohumn L 'KH CND OPIO 26 IZ OlaD : 2…

A: The solution is given below

Q: The subject is Digital System Please send the answer by typing ONLY. I don't want any handwritten.…

A: In this question we will write applications of encoder and decoder circuits...

Q: advantages of digital system over the analog system

A: In 1870, the first analog system was developed than developed and modified up to 2000. But the world…

Q: b Figure 1: Circuit diagram a b C y 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100

A: According to circuit diagram, nor gate will give output only when both input is 0. Nand gate will…

Q: 15.a. An encoder is being used instead of a tachometer in a DC servo system. This system of speed…

A: There are a few questions related to the sensors attached to the machine to measure the speed of…

Q: Q1. Design asynchronous (ripple ) binary counter and timing diagram for the following sequence…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 3. Draw the block diagram of an 8255 PPI chip and describe its different programming modes.…

A: block diagram for 8255 PPI is as shown in figure below

Q: Define architectural registers.

A: • Architectural registers is a type of internal register of the processor.• It is defined as those…

Q: 2. If the values of the date select lines (control inputs) A and B are 0 and 1 respectively, and…

A:

Q: What is the mathematical model for binary amplitude shift keying?

A: The solution is given below

Q: The 8085 instruction set does not include a Clear Accumulator instruction. Which single-byte logical…

A: XRA A is the instruction which is of only 1 byte of size ,which can reset the content of accumulator…

Q: Implement the following Boolean function by using 4x1 multiplexer. ����(?, ?, ?, ?) =…

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Q: Given a 8-bit number at memory location 2050H. Write 8085 instruction to move the value stored at…

A:

Q: 1- Explain the operation of the PCM encoder used in module ED-2960F. 2- Discuss the advantages and…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: the binary input to the 7442 decoder is 0111, then output pin number _____ of the IC will become…

A: the binary input to the 7442 decoder is 0111, then output pin number 7 of the IC will become active…

Q: What will be the BCD equivalent of decimal 15?

A:

Q: Answer the following questions considering the given circuit and the timing data. BOX your results!…

A: The setup time of a flip-flop is the minimum amount of time before the clock edge for which the data…

Q: Explain: Block diagram and typical parameters of Data Acquisition Boards

A: Block diagram and typical parameters of Data Acquisition Boards

Q: Determine the binary code output of the 3-bit flash ADC for the input signal in Figure below and the…

A: Given Vref =8V n=3 bits Number of levels L=2n =23 =8 So we assign a quantization level in between…

Q: A digital circuit whose number of inputs is 3, how many possible combinations of inputs will it…

A: In this question , we will find  possible combinations of input if number of input is 3....

Q: Explain how a priority encoder works

A: A priority encoder is a circuit or method that reduces the number of outputs from numerous binary…

Q: in Intel 8086 microprocessor, the memory address for the code segment 771F h and offset 3584 h is O…

A: memory address = code segment + offset  1. Given code segment = 771F and offset = 3584 H  code…

Q: VHDL Difference between function and task. What is logic data type.

A: Bit is 2 state data type. It can take 0 and 1 only. Reg is driven by always  block it can't be…

Q: A digital computer has a common bus system for 16 registers of 32 bits each. The bus is constructed…

A: Given that  Number of registers 16 Size of each register 32 bit Number of register =16 (A) No of…

Q: For a PCM system with the following parameters, Parameters: (i) Maximum analog input frequency = 5…

A: It is given that: fm=5kHzDynamic range=54dBVmax=±5.01V

Q: 2- Discuss the advantages and disadvantages of the counter-type ADC. 3- Is the conversion time of…

A: Question 2 Advantages of counter-type ADC:   (1) It is a one-bit quantizer. (2) In counter-type ADC…

Q: 4. Which one of the following devices is also referred to as Data Selector? 1. Demultiplexer 2.…

A: Multiplexer is also referred as data selector, it selects between several analog or digital input…

Q: Q.19 Draw logic diagram for 4 to 1 line multiplexer. Q.20 Draw logic diagram for 1 to 4 line…

A: Solution: Logic diagram of  the 4×1 multiplexer is given as follows: Where,…

Q: Assume that you have an 8-bit ADC with Vref = 5 Volts. If the input voltage is 3.5 Volts, what is…

A:

Q: Browse for the datasheet of 8086 from Intel and using the information from datasheet answer the…

A: i) Draw the neat diagram of 8086:

Q: Discussion: 1. What are the advantages of PCM system over other types of modulation systems? 2. What…

A: As per Bartleby guidelines we are allowed to solve only one question, please ask rest again.

Q: Explain the concept of channel coding; what is its function on the overall digital communication…

A: Communication System- Communication System is refer to the system which transfer an information from…

Q: Find the number of bits given if the PCM system has a quantization error of 0.4 V and maximum input…

A: Given: Quantization error = 0.4 V Maximum input = 6V

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.