6 cm 2 cm 4 cm 6 cm
Q: A projectile is fired with an initial velocity of vo (m/sec) upward at an angle (0) with the…
A: It is very basic derivations of projectile motion range and maximum height.
Q: A cast-iron pulley transmits 49 kW at 1,750 rpm. The shaft to which it is to be keyed is 44.4 mm in…
A:
Q: In a process water at 30°C flows over a plate maintained at 10°C with a free stream velocity of 0.3…
A: Given data Temperature of water = T∞ =30°CTemperature of plate = Tw = 10°Cvelocity of flow of water…
Q: In the below system, the pump uses 20°C water. If z2 = 225 ft, what is the flow rate (in ft3/s) if d…
A:
Q: * For the cantilever beam shown. find the value of Normal stress due to :axial load at point A 4 KN…
A:
Q: Find the stress Force=2 N Area=2 mm2
A: Given data : Force=F Area=A To find : Stress
Q: A 1.8-kg collar is attached to a spring with unstretched length of 1.03 m. The collar moves in the…
A: Given: Mass of the collar→m=1.8 Kg Radius of the ring→r=1.03 m Unstretched length of the…
Q: The angular velocity of the disk is defined by ω = (5t2 +2) rad/s where t is in seconds. Determine…
A: Givenω=5t2+2t=0.5s
Q: A tainter semicircular gate is shown in the figure. Considering a ft wide strip, determine the…
A: Givenγ=62.4 lbs/ft3r=5ftl=2.5ft
Q: 3. The following are the Heat rate curves pertaining to three units in a plant. Unit 1: Min 250 MW,…
A:
Q: A tank 10 m high and 2 m in diameter is 15 mm thick. The max tangential stress is ? The max…
A: Given data height = 10 m diameter = 2 m thickness = 15 mm find the maximum tangential stress and…
Q: Find work done F=2.1 N Displacement=0.23 m
A: Given data : Force applied=F F=2.1 N Displacement=d d=0.23 m
Q: Discuss briefly as points the importance of Octane Number on the combustion process and engine…
A:
Q: load (KN) Elongation (mm) | PAL D 0-5 a. I 3-8 0.3 7-9 12.9 14-3 15-9 16.9 17-8 1.61 21-2 24-2 26-9…
A: Solution is given below:
Q: For the given truss below, do the following: a. Determine the forces in the members AB, AC, CD and…
A:
Q: A single cylinder engine is used to drive an irrigation pump. The set-up has the following data:…
A: The diameter of the pump pulley: 305.5556 mm
Q: Question: A particle moves in the x-y plane with an x-component of velocity in meter per second…
A: Given data Vx = 4√t ay= 4e^t When t = 4, y=10, x=4 and Vx = 10. Find the equation of path of the…
Q: at point a in pipeline carrying water, the diameter is 1m, the pressure is 98kPa and the velocity is…
A: Given:d1=1 mP1=98 kPav1=1 m/sz1=0 md2=0.5 mP2=20 KPa
Q: Coal has the following ultimate analysis: C=73.71%, H=1.78%, O=1.43%, N=1.69%, S=4.74%, and the…
A: Given C =73.71% H =1.78% O =1.43% N =1.69% S =4.74% Find Higher heating value, HHV
Q: 5. According to an individual, his preference of selecting a leader is based on three major factors…
A: Given: Weight of the moral value: →Wm=0.43 Weight of the experience: →We=0.31 Weight of the…
Q: 1-Two rivets holds three sheets of steel together, and is loaded as shown below. If the maximum…
A:
Q: A machine, subject to a harmonic force of 500N with 0.5Hz frequency, is modelled as a mass of 800kg…
A:
Q: Mr Chua experimented on water movement within a rigid tank. The rigid tank is divided into two equal…
A: Given data P1=200 kPaT1=25°C Here, P is the pressure and T is the temperature. Now we have to find…
Q: Completely solve and box the final answer. Write legibly 8. A total of 512.5 HP has been rejected…
A:
Q: 9.9 Combustion gases with cp = 1148 J/kg K and gas constant R = 287 J/kgK enter the stator of a…
A: A dimensionless quantity in fluid mechanics which is the ratio between the velocity of the fluid…
Q: A car moving on a level road at a speed of 60 km/hr has wheel base 2.76 metres, distance of C.G.…
A: Given data as per the question speed=60 kmhr=1667 mswheel base (l)=2.76 mdistance of CG from…
Q: 3-Determine the maximum vertical force P that can be applied to the bell crank so that the average…
A:
Q: 1 m 1 m 30° b. 0.5 m 0.5 m b 1m -75 mm-
A: Given Data The mass of the drum is:m=20 kg The supported diamter of frame is :D=2mm Now draw the…
Q: 2 A hollow circular steel strut with its ends position- fixed, has a length of 3 m, external…
A: We know that a 3 m long hollow circular steel strut with fixed ends has an exterior diameter of 12.5…
Q: 6) is a sheet metal forming process performed by placing a sheet-metal blank over a die cavity and…
A: Only four to five multiple questions are allowed to solve.
Q: Looking at the x direction, provide the front view, top view, and right-side view using the meter…
A: According to the details provided in the question, we need to grow three projection views of the…
Q: Rd in the figure shown below
A: we will use equilibrium equation
Q: A trapezoidal plate shown in the figure is submerged in water is 3.2 m below the surface. The bases…
A: Answer: The magnitude of the force is 3379.968 kN and it's location from the bottom is 2.957 m.
Q: ycle work of an air standard otto engine is 1100 kj/kg. Maximum cycle temperature is 3300 deg. C and…
A: Given:Wc=1100 KJ/KgT3=3300°C =3573 KT2=700°C =973 K
Q: 2. A 200 lb block rests on a horizontal surface. The coefficient of static friction between the…
A: Given Mass, m = 200 lb = 90.71 kg Friction = 0.35 Find Force, P
Q: The acceleration of a particle is defined by the a = -10v knowing that at tso the velocity is 30…
A:
Q: In a cascade refrigeration system,the compressor power in the low and high pressure loop are 12 kw…
A: It is very basic question of coefficient of performance if
Q: Under what conditions, an absorption machine give less cooling effect?
A: Given question: Under what conditions, an absorption machine give less cooling effect? The given…
Q: Question: A particle moves in the x-y plane with an x-component of velocity in meter per second…
A: Given data Vx=4√t ay= 4e^t when t = 4 , y= 10,x=4 and Vx=10 find a)equation of path of particle…
Q: ompute the heat conducted in KW through a sheet of plate glass, k = 0.025 Cal/s-cm-ºC, which is 3.5…
A: Given Thermal conductivity, k = 0.025 Cal/s-cm-ºC = 10.46…
Q: Problem 4-1 A tubular steel strut is 8 cm external diameter and 5 cm internal diameter; 3 m long and…
A: We know that a 3 m long tubular steel strut with hinged ends has an exterior diameter of 8 cm and an…
Q: Find work done F=2.1 N Displacement=0.23 m
A: Given data : Force =F Displacement=d To find : Work done
Q: 5. A test run using this coal showed a dry products of combustion analysis by volume of nitrogen…
A:
Q: The solar energy can generate 1.5 kW per one square meter of a solar collector with a total area of…
A:
Q: Looking at the x direction, provide the front view, top view, and right-side view using the meter…
A: Find Front view, top view, and right side view with dimensions.
Q: A pipe 12 mmm diameter with a velocity of 0.50 m/s is attached by a nozzle at the end having a…
A: Equating the volumetric flow rate
Q: A) Find the internal forces and moments acting at a-a. 300 mm 300 mm 600 mm B D A a a 200 mm -400 mm…
A: find the internal forces and moments at section a-a.
Q: Learning Goal: To find a position vector between two arbitrary points. As shown, two cables connect…
A: Given data Cz=1.3 ft Bx= 8.50ft By= 5.50ft l= 8.50ft Find the position vector from A to B. And…
Q: What is the principle of operation of vapor absorption system?
A:
Q: 15 A specific fluid is kept in a cubic container. The container weighs 10 N when it is empty. When…
A: Given data Weight of container when it is empty = 10 N Weight of container when completely filled by…
Please help ASAP!
Thank youu.
Step by step
Solved in 2 steps with 2 images
- The position of center of gravity in an equilateral triangle of base b and height h from its base is Select one: h/2 h/3 3h 2h/3The position of center of gravity in a right-angle triangle of base b and height h from its vertex(apex) is Select one: 2h/3 3h h/2 2hV=38 h1=96 h2=12 D1=6 D2=3 angle = 0 degree
- 26 Centre of gravity of a 3D object is based on a. Perimeter b. Volume c. Mass d. AreaTwo circular platforms are attached to a fluid reservoir. On one platform rests seventeen baby armadillos.. A force of 3.4 N is applied downward to the empty platform with radius 9.8 m. The area of the other platform has radius 2.3 m. How much force is applied to the platform with the armadillos?Convert 500 meters squared per second squared to BTU per pound-mass. Answer to the third decimal place.