6. Determine the force in each cable needed to support the flowerpot whose weight is 10ON とれ В 6 m 4 m D 3 m 2 m 2 m

Q: A water tank of cross-sectional area 2.5 m2 and height 120 in contains 1500 (US) gallons of water.…

A: Let A=Area of tank =2.5m2 h=120in  ρ = density of water= 1000kg/m3 F =Force on the base of the tank…

Q: Find the minimum force F to cause movement of the 400/1000 lb. system shown. The 5º wedge is…

A: To find: The minimum force F to cause movement. Given: The 5° wedge is weightless. The coefficient…

Q: A crane is used to lower weights into the sea (density = 1,025 kg/m3) for an underwater construction…

A: Given    Density of block = 2,300 kg/m3            Volume, V = 0.4m x 0.4m x 3m Find   Tension in…

Q: 700 N 2650 N 90°- 60° P For the system shown above, the magnitude of the resultant force must not…

A:

Q: A 490 Kg crate, as shown, is supported by three cords. One cord has a spring in it. Set k= 2.3 kN/m…

A:

Q: A light fixture of negligible mass, has three applied forces acting on it as show |F,| = 4 kN 1.2 m…

A:

Q: 250 N 60 N -0.7 m 0.15 m 0.15 m Figure:4

A:

Q: dAB F1 = 20 kN, F2 = 30 kN o B a) Calculate the force P that will keep the system F2 kN in balance.…

A:

Q: Required information Determine the magnitude of the forces. In the given figure, y = 300 N, V2 = 1.6…

A: Draw the free body diagram of the system. Apply force equilibrium in a horizontal direction.…

Q: Determine the magnitude of the three P1,P2 and P3, given that they are equivalent to the force…

A: Given   Resultant force, R=-800i + 700j+500k lb Angle = 25o Find   Three forces

Q: Q3: The diagram shows the open bonnet of a car. The bonnet is vertical force V held open at an angle…

A: 1) Draw the FBD for the given question. The other two forces will be the reaction force at the hinge…

Q: SA3) A 6-m uniform rod is acted upon by different forces at different points as shown in the…

A: Let "F" be the force that should be needed to balance the rod. And let it be acting at a distance of…

Q: Several blocks are resting on a simply supported beam. Determine the reaction forces. each block =…

A:

Q: 1. The hanging box is being pulled by two ropes T1 and T2 as shown below. T1 = 565 Newtons and T2 =…

A:

Q: The force f (t) as seen is applied to a stationary mechanical system, where k =847 N/m, b = 1,123…

A:

Q: The Magnitude of the reaction Force (R and T) is

A: Given Data :

Q: With what force magnitude T must the person pull on the cable in order to cause the scale A to read…

A:

Q: C 2 m 2 m 2 m B 2 m F 500 kg 4 m A

A: Note - as per our guidelines we are supposed to answer  only one question. Kindly repost other…

Q: The motorcycle weighs 151 kg and the driver weighs 64 kg. Dimensions: l1 = 0,31 m and l2 = 0,23 m…

A:

Q: (a) The wooden rod AB supports the roof ADC. If the mass of roof is 70 Kg and its weight acting at…

A:

Q: Determine the force in each cable needed to support the weight of mini extruder (2000 N) on the…

A:

Q: 2.0m 100 kg 2.0 m 0. 1.5m 1.5m The pulley at E is frictionless. Point B is a pinned connection;…

A:

Q: 2. The crate weighs 450 kg and is supported by three cables as shown in the figure below. B 2m 1m 1m…

A: As per the company policy, we are restricted to solve the first three sub-parts of the question.…

Q: a) Figure Q3.1 shows a boom supports the two vertical loads, Fı and F2. Identify and determine the…

A:

Q: 1. A Christmas decoration consists of three identical balls, each with a mass of 0.15 kg. It was…

A:

Q: b. Consider the following system, where you are applying a load P: cg cg Mathematically, show which…

A: Solution: (a) Given Data: b = 5 h = 7 d = 2

Q: The climber A suspended from the rope weighs 75 kg as shown in the figure below. Determine the force…

A: Given data as per question weight of climber A =75 kg tanθ1=24θ1=26.560tanθ2=22θ2=450

Q: The block shown in the figure below is acted on by its weight, W = 1300 Lbs, a horizontal force H =…

A:

Q: When a car is parked in a parking space, the value of resultant force acting on the car is equal to…

A: This question is from classical mechanics.

Q: Abbot and Costello are transporting a 0.125m3 cubic block along a ramp inclined at 20°. They tied…

A: Given: Volume of cube is 0.125 m3. Mass of the pole arm is 2 kg.  Length of the pole arm is 3 m.…

Q: Q.4) A hand trolley is used to move a crate weighing 150 lb down the ramp as shown below. The center…

A: Given:  Weight of the crate = 150 lb  Required:  Total resultant force on both wheels at A and…

Q: 4. Assuming you know the geometry of the ropes, you cannot determine the forces in the cables in…

A: Given: There are three systems of cable mass system. In A and B system has three cables so lamis…

Q: The horizontal reaction at support O will be at the 100 lb 1 ft 50 lb 3 ft 3 ft 3. 4 150 lb O non of…

A: Option 4th is correct. (In the positive direction)

Q: F, F2 and F are aplied to a cable system F E A (ABCDE). m a) Find the forces in the cables AB, BC,…

A:

Q: B F: kN a kN 0,6 m D. -0.3 m-0.3 m-

A: Given data:-F1=20kN, F2=40kNSince, system is hinged at point C. Therefore, net moment about point C…

Q: ft. B `4 ft 8 ft 3 ft A Figure 03.12(a)

A:

Q: Determine the magnitude of the forces. In the given figure, V1 = 300 N, V2 = 1.6 m, and V3 = 11 m.…

A:

Q: QUESTION 7 While sitting in a chair, a person exerts the forces in the diagram of Figure 7.…

A:

Q: Consider three forces P1, P2, and P3 where P1 = 15 lb, P2 = 40 Ib, and P3 = 41 Ib. Determine the x…

A:

Q: Required information NOTE: This is a multi-part question. Once an answer is submitted, you will be…

A: For the collar to be in equilibrium, the vertical component of the net force on the collar must be…

Q: 2. A stubborn dog, refusing to move, is dragged east by his owner along level ground. An eastward…

A: Given data: The mass of the dog is m=13 kg The force on the dog is F=43 N

Q: Determine the magnitude of the forces. In the given figure, V = 300 N, V2 = 1.6 m, and V3 = 11 m.…

A:

Q: Find the force in the member EC of the trus ölkn in the figure D2 AN 4 kN 2 kN 10 m 10 m (A) 8 KN…

A:

Q: 2- Find the applied force by the hydraulic cylinder in the truck shown graphically using KS: 1cm=1m,…

A: Given Weight = 25 kN To find Force required to lift the weight

Q: g) is sitting on the seat of a swing at the playground. The seat is supported by two cables, one on…

A: Given: m=75 Kg L=5m d=1 mm

Q: F1 of 3 ft F2 E 3 ft A If F1=235 Ib and F2=380 lb Determine the force in each member and identify…

A:

Q: a) Calculate the forces in cables AC and AB needed to hold the 20-kg ball D in equilibrium as shown…

A:

Q: If a 200 N force F1 is applied to the piston with the 4 cm diameter, what is the magnitude of the…

A: Given                Force, F1 = 200 N     Specific gravity = 0.85

Q: Three boxes, A, B, and C, are placed on a frictionless surface as shown in the diagram below. B A If…

A:

Q: y P2 B P1

A: Drawing the free body diagram of the given truss as shown below – At A the support is fixed and at…