6. Using the data in the table below, calculate the reactor volumes V₁ and V₂ for the plug-flow sequence shown in the following Figure when the intermediate

Q: Solid waste D The production of glass creates minimal waste. Waste is limited to packaging waste.…

A: The text describes the waste generated in the production process of glass in the glass industry. It…

Q: one hundred fifty kmol of an aqueous phosphoric acid solution contains 10 mole% h3po4. the solution…

A: Amount of solution in tank = 150 kmolAmount of phosphoric acid in solution = 10 mole % x 150 = 0.1…

Q: Homework 3 - Chapter 5 - Thermochemistry Consider the reactions below: A2+2 C₂2 AC₂ A2+3 B22 AB3 2…

A: Given: The given sets of equations are: A2+2C2→2AC2        ∆H = -150 kJ/mol         (1)A2+3B2→2AB3…

Q: R16.12 For a system in which the gas-phase reaction N₂ + 3H₂ → 2NH3 is occurring, the slope of a…

A: Rate of reaction is proportional to change of moles of any species "i" with respect to time

Q: The exact expression for the local Nusselt number for laminar flow along a flat plate is given by:…

A:

Q: The following irreversible reaction takes place in a batch reactor? → B Determine how long it takes…

A: n=2kCAo=0.2 min-1xA =0.5

Q: 2. Ethanol (C₂H5OH) melts at -114°C and boils at 78 °C. The enthalpy of fusion of ethanol is 5.02…

A: Initially, ethanol is at 35℃ it will first go to 78℃ then it will vaporize. hence we will calculate…

Q: The raw water source to this new plant has a daily incoming natural alkalinity of 150 mg/L present…

A: Given reaction is- Al2(SO4)3 + 6H2O + 6HCO3- → 2Al(OH)3(S) + 6H2CO3 + 3SO42- Natural alkalinity of…

Q: n a multi air gap membrane distillation, how to get the brine of each stage?

A: The brine of each stage in a multi-stage air gap membrane distillation (AGMD) system can be acquired…

Q: A test feed containing 200 kg of solid is separated by a hydrocyclone and the particle size…

A: Total mass of the feed = 200 Kg Mass of the solid collected from the underflow = 166.5 Kg Data of…

Q: If 7 m³ of air at 50 °C and approximately atmospheric pressure is preheated for a combustion process…

A: Initial temperature T0 = 500 C =323.15 K Final temperature T = 9150C =1188.15 K Volume V = 7 m3…

Q: Q1 1- Salt by wt (%), naphthenes By Vol (%)for Brent blend -2014 crude oil are .°F 2- 20 % vol of…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: The rate constant for the reaction NO₂(g) + O3(g) → NO3(g) + O₂(g) was determined over a temperature…

A: Given reaction is-Now, from the given unit of rate constant, k=M-1s-1 the order of the reaction is…

Q: = 22.21 For the elementary reaction CH₂Br + Cl¯ → CH₂Cl + Br in acetone, one finds A = 2 × 10⁹ dm³…

A:

Q: Show me the calculation for deltaH(1a).  I am unclear how the volume of acetone was calculated.

A: A mixture of acetone-air mixture is cooled in a condenser.

Q: Q3 A dryer must take up 400 lbm/hr of H2O. Entering fresh air at barometric pressure, 70 °F and 50%…

A: Volume of R per volume of P at given conditions is to be calculated.

Q: 8. What type(s) of corrosion occur when metal is subjected to a high- velocity fluid flow with…

A: A) this option is not correct because it is the most general type of corrosion and is caused…

Q: The flow rate of water flowing in a 3 m wide channel is to be measured with a sharp crested…

A: As fluid flows when there is a pressure difference.So it is very important to know the surface on…

Q: you want to be a chemical engineer If you had no barriers and could do anything you wanted, what…

A: I can provide you with a general idea of what long-term academic and career goals someone…

Q: The design fluid (typically water and antifreeze) flow rate through a solar hotwater heater system…

A: The flow rate of the fluid = 0.025 gpmft2or gallonsmin.ft2 Dimension of each solar panel = 4ft×8ft…

Q: mework 3 - Chapter 5 - Thermochemistry Using the enthalpies of formation and balanced equation given…

A: The reaction given is as follows: 3A(g) + 2B(g) → 3C(g) + 1D(g) ∆Hfo(A(g)) = -458 kJ/mol∆Hfo(B(g)) =…

Q: Consider a two-layer model of an artery. The layers are of thickness Ro - R₁ and R₁ – R₁. The inner…

A: The two layer model theory can be solved by cylindrical coordinates with radius being R1-Ri and…

Q: A polynomial fit to measurements of the total volume of a binary mixture of A and B is, ν = 778.55 −…

A:

Q: يا أصدقائي، كل يوم ا يزيدنا إنجازاً. كلما زادت الضغوط والمسؤوليات ارتفعت وتيرة الطموحات والانتصارات.…

A: this is an urdu literature that needs to be translated

Q: A) In the heat exchanger below, it is desired to control the outlet temperature T of the process…

A:

Q: How to Calculate the value of activity coefficients by using excel sheet:

A: the formula gor excess gibb's free energy is called as margules 2 suffix model.  GERT= x1x2(Ax1+Bx2)…

Q: Nickel experiences corrosion in an acid solution according to the reaction Ni + 2H+ →→ Ni²+ + H₂ The…

A:

Q: In a process in which benzene is used as a solvent, benzene is evaporated into dry nitrogen. At 297…

A: The relative humidity, RH = 60 The initial temperature, T1 = 297 K The pressure, P = 101.3 kN/m2…

Q: 22-56 A 1-shell-pass and 8-tube-passes heat exchanger is used to heat glycerin (cp= 2.5 kJ/kg-°C)…

A: Given: A 1-8 shell and tube heat exchanger is used to heat glycerine,Cp for glycerine Cpg = 2500…

Q: 2. An oil of SG of 0.8 is flowing through a venturimeter having inlet diameter of 20 cm and throat…

A: given = SG = 0.8 d1 = 20 cm = 0.2 m d2 = 10 cm = 0.1 m x = 25 cm of Hg = 0.25 m of Hg

Q: 4. Using the isothermal transformation diagram for an iron-carbon alloy of eutectoid composition,…

A:

Q: Q3: A pump is pumping 50 gal / min of water from a pressure of 30 psia to a pressure of 100 psia.…

A: Solution Given that Flow rate Q = 50 gal/min = 50 gal / min * 0.0038 m3/gal = 0.19 m3/min  Q = 0.19…

Q: For the product solution, H₁ = 2.178 kJ/mol r= (44,400 mol H₂O)/(5480 mol HCI) = 8.10 HCl(g. 25°C)…

A: We have to find change in enthalpy of HCl when r = 8.1 From given table for HCl at r = 5, ∆H =…

Q: A mixture of 1 kmol of hydrogen (H₂) and n kmol of oxygen (O₂), initially at 25°C and 1 atm, burns…

A:

Q: if the cooled seawater enters the air gap membrane distillation, is there a loss in hot steam that…

A:

Q: The elementary reversible isomerization of A to B was carried out in a packed-bed reactor. The…

A: A to B carried out in a packed bed reactor.

Q: Q2: Acetone is to be recovered from a 5 per cent acetone (CH,COCH,)-air mixture by scrubbing with…

A: Step 1 Given that- Acetone has to be recovered from 5% acetone-air mixture. Liquid flow rate, L=0.85…

Q: Question 3: Ethane at 25 °C and 1.1 atm (abs) flowing at a rate of 100 mol/s is burned with 20%…

A: Ethane gas is burned with oxygen.

Q: Q3:Air flows over the flat plate at velocity 3 m/s and ambint temperature 15 C.The plate is…

A: Since you have posted multiple questions, we will provide the solutiononly to the first question as…

Q: 27.4 One step of the manufacturing of silicon solar cells is the molecular diffusion (doping) of…

A: For the calculation of the concentration of the P atoms at the depth of 0.467μm after 40 min, We…

Q: Q3:Air flows over the flat plate at velocity 3 m/s and ambint temperature 15 C.The plate is…

A: “Since you have posted multiple questions, we will provide the solutiononly to the first question as…

Q: stream of ammonia is cooled from 100oC to 20oC at a rate of 180 kg/hr in the tube side of a…

A:

Q: 100 kg/s of a crude oil is heated from 24°C to 40°C through the tube side of a multitube heat…

A:

Q: Q2 A steel cylinder contains ethylene (C₂H4) at 200 psig. The cylinder and gas mass is 372 lbm. The…

A: Initial Conditions of the Cylinder: Initial Pressure of the ethylene in the cylinder = 200 psig…

Q: Convert the following 60.0 mi/hr to ft/s b) 15 lb/in² to kg/m² c) 6.20 cm/hr² to nm/s² 2 2

A: Given conversion to be obtained as-(a)The conversion unit for miles/h to feet/s are as follows-1…

Q: What does the activity coefficient tell us about the nature of the interactions present between the…

A: In thermodynamics, the two entities, the activity coefficient, and the fugacity coefficients, are…

Q: A LLE system follows one-parameter (i.e., two-suffix) Margules equation. Determine the equilibrium…

A: LLE  system is known as Liquid Liquid Extraction system. The system follows one parameter Margules…

Q: a. What are the Schmidt numbers for CO and O₂ mass transfer? What species (CO, O2, CO₂) is…

A: Composition of the gas stream is as shown below, Mole percent of CO = 0.1% Mole percent of O2 = 2.0%…

Q: It is proposed to reduce the concentration of acetaldehyde in aqueous solution from 50 per cent to 5…

A: Given,Feed flow rate = Solvent flow rate = 0.025 kg/sComposition of Acetaldehyde in feed =…

Q: it's only one answer. each choice is to fill in both blanks. Not sure if b is the optimal choice…

A: In bod we need oxygen consumption and as chlorine inhibits the oxygen consumption