Answered: 6. Write an assembly language program…

6. Write an assembly language program to find the 7-segment LED code for a 2-digit BCD data, by using look up table. The BCD data is stored in 4200H. Store the 7-segment code in 4201H and 4202H.

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter22: Sequence Control

Section: Chapter Questions

Problem 6SQ: Draw a symbol for a solid-state logic element AND.

See similar textbooks

Related questions

Q: 3 () For the following first column in a Routh's stability table, what is true about this column? O…

A: Given Routh's stability first column. S5 4 S4 2 S3 3 S2 0 S1 1 S0 6 Options…

Q: An emf whose equation is e = 50 + 220 sin(377t) + 75sin (1131t + 45°) is impressed in an impedance…

Q: The floor area of a room is 10 m x 10 m. The desired illumination level is 150 lux. Assume the…

Q: What is the maximum transmission efficiency of an AM signal?

A: The correct option along with the explanation has been provided in the following section.

Q: What is the Fourier transform of 5?

Q: 13. A mass of 1 kg. was released from a 1,000 meter height. What is its Potential Energy at the…

Q: 19. A factory draws an apparent power of 300 kVA at a lagging power factor of 0.65. The active power…

A: Given: A factory draws an apparent power, S=300 kVA Lagging power factor, cosϕ=0.65

Q: The 2's complement of hexadecimal 29 is hexadecimal 93 hexadecimal 92 Ohexadecimal D6 Ohexadecimal…

A: Given, Hexadecimal number ⇒2916

Q: Analog signal may be converted into digital signal by a. Sampling b. Amplitude modulation c.…

A: The correct option along with the explanation has been provided in the following section.

Q: Find the Z parameters of the network shown in Fig. 3.

Q: What is the difference between standard FSK and MSK? What is the advantage of MSK?

A: Solution !! Minimum Shift Keying (MSK): The minimum frequency space that allows 2 fsks representing…

Q: Consider the feedback control system Select one: O O R(s). a. a, 3.26 rad/sec b. wy=5.49 rad/sec C.,…

A: Given parameter: The system has unity feedback, because of the direct branching from output and…

Q: 1. True or false: In direct current (DC), the electric charge (current) only flows in one direction.…

A: DC current : DC current also known as direct current this current flows only in one direction since…

Q: A small signal equivalent circuit of single common-emitter amplifier is shown in Figure Q1.b with…

Q: Frequency modulated signal with single-tone modulation has a frequency deviation of 15 kHz and…

A: To solve the given problem, we will use Carson's ruleAccording to the Carson's rule 98% of the…

Q: Analog signal may be converted into digital signal by

A: The correct option along with the explanation is provided in the following section.

Q: Que 4.20. Find the Y-parameter model. A the Y-parameter I 13 YA of the following -circuit and draw…

Q: Find the time-domain of the following sources: V = 200<0° V and I = 10<45° A

Q: Consider the feedback control system Select one: O R(s). a. c, = 3.26 rad/sec b. wy = 5.49 rad/sec…

Q: Find the capacitance (in units of pF) of a parallel plate capacitor that is made of two parallel…

Q: The OUTPUT logic, as you know, depends on the current state. Q1 Q2 0 0 CD O t 6 1 ( oe 0 [ 8 Qo 0 1…

A: Given: Truth table for the problem. We have to determine the logic expressions for various variables…

Q: image

A: Given:

Q: Problem 1. A parallel-wire air-spaced transmis- sion line operating at 1910 Hz has a phase shift of…

A: Given a parallel wire air spaced transmission line operating at, Frequency, f = 1910 Hz Phase shift,…

Q: A lossless transmission line having 50 Ω characteristic impedance and length λ/4 is short-circuited…

A: We know that the input impedance for a loss less transmission line for a quater wave λ4 is given…

Q: A 50μF capacitor initially charged to 125V is discharged across a series combination of a 1k0…

A: A 50 μF capacitor initially charged to 125 V. Resistor R= 1K-ohm Capacitor210 micro farad Find…

Q: The equivalent resistance of the resistive network shown below is 50 a www o 109 50 bo www O a. 2002…

A: Given circuit,

Q: Two different second order systems have the characteristic equation roots shown below. Which…

A: For the two second order system having characteristic equation roots shown in the diagram.

Q: A factory that is fed by a three-phase generator connected in Δ with Vac equal to 240 V with an…

Q: What is the maximum transmission efficiency of an AM signal?

A: The solution is provided in the following section.

Q: Determine the current I in the given circuit, using the superposition theorem. 10 10 ν 19 3 Ω www…

A: The given circuit is shown below. Find the current I.

Q: Q\ What is the VSB modulation? and why it used? and how it can be generated?

Q: The Widlar current mirror circuit shown in Fig. Q2.b is required to provide Io = 5 µA and Iref = 1…

Q: A 3-phase, 4-wire system supplies an unbalanced load. The positive and the negative sequence…

Q: The design criterion for a typical scanning tunneling microscope (STM) specifies that it must be…

A: The transmission coefficient is given as: tc=e-2CLC=10 nm-1L=Length The transmission coefficient at…

Q: Add 398Bcd to 269BCD Showing carries and digit corrections

A: The BCD representation of the number 398 is, 3: 00119: 10018:1000398BCD=0011 1001 1000 The BCD…

Q: A series RLC circuit has a resistance of 60 ohms, a capacitance of 10-2 Farads, an inductance of 5…

A: Given: Series RLC circuit with R=60 Ω,L= 5 H and C=10-2 FaradsVoltage source V=20sin5t

Q: 7. Given the following transfer function: 6s²+66s+60 100s²+20s+1 H(s) = With an input of x(t) =…

Q: The sinusoidal ac source in the figure has an rms 20 value of V. Considering all possible values of…

A: Solution is explained down !!

Q: If an AC signal has a peak voltage of 55V, what is the average value voltage?

A: Given thatPeak voltage of AC signal (Vm)=55VWe have to find the average voltage.

Q: In a microcontroller program, a subroutine starts at address 016F and ends with a 'return'…

A: Below find the solution !!

Q: -qV 4. Find the current through the resistor and an output voltage si 9V A Ge B Vo 35kr

Q: 1.) For the following polynomial, for 1+ G(s)H(s) = 0 and using Routh's method for stability, find…

Q: Briefly explain what you mean by discrete system and continuous system.

Q: Hic function (x) of

A: Given:

Q: of electrons from the plate is caused by the acceleration of electrons by the screen grid. This…

A: Answer: Secondary Emission

Q: Que 4.20. Find the Y-parameter model. A the Y-parameter I 13 YA of the following -circuit and draw…

Q: A Write the Boolean expression of the following Logic diagram. BC D= C' 11

A: Given data, Logic diagram

Q: A three-phase induction motor is taking 40 kW, the slip being 4%, stator losses amount to 800 watts,…

Q: Determine vo and i in the circuit shown in Fig. 2.23(a)

A: From the given circuit We have to find the value of v° and iApplying KVL in the loop of the given…

Q: 2. Given: A certain liquid weighs 7.95 kN/m³ Required: a) Specific volume (m³/kg) b) Specific…

A: 2) It is given that: m=7.95 kNm3=7950 Nm3

Question

6. Write an assembly language program to find the 7-segment LED code for a
2-digit BCD data, by using look up table. The BCD data is stored in 4200H.
Store the 7-segment code in 4201H and 4202H.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Logic effort and parasitic delay
1. Assuming the full adder drives a load L=1.5, determine the critical path and its corresponding delay.2. Using this full adder to create an 8-bit ripple carry adder, what is the critical path delay of this 8-bit adder? (Assume unconnected ports are driving L=1.5 load)
3) How many full-adders would be required to construct a 32-bit ripple carry adder correctly?
Using sum of products and boolean algebra, simplify using karnaught maps and draw the simplified circuits
Give the Answers of following questions, 1: without reducing implement the following Boolean expression using basic gatesY Y= (A' B)'+A+BC 2: Reduce the following Boolean expression using Boolean algebra. Y = (A+BC)' (AB'+ (ABC)') 3: Explain the construction and working of the Depletion MOSFET, with characteristics curve.
Design four way traffic lgiht signal using gray code and using logic vehicle on side long timer and short timer also by using d flip flop
3) How many full-adders would be required to construct a 32-bit ripple carry adder?
. Design a combinational circuit to convert a 4-bit binary number to gray code using(a) standard logic gates,(b) decoder,(c) 8-to-1 multiplexer,(d) 4-to-1 multiplexer.
Write a VHDL program to implement a 2-bit adder. The Boolean functions for the 1-bit full adder are given in the diagram:
Q (A, B, C) = A' .B'. C +A' .B. C + A.B.C' + A.B.C Obtain the simplified function with the Karnaugh Map method in terms of minterms and maxters separately. Set the output functions separately with logic gates with AND NOT for minterms and OR for maxima.
Q (A, B, C) = A̅ .B̅. C +A̅ .B. C + A .B. C̅ + A.B.C. Obtain the simplified function with the Karnaugh Map method in terms of minterms and maxters separately. Set the output functions separately with logic gates with AND NOT for minterms and OR for maxima.
Grey converters are often used in industrial circuits where the normal sequence of binary numbers may produce ambiguity during transition. This is elliminated with the Grey code, as only one bit changes, during a normal transition of sequential numbers. Show the logic required to convert a 10-bit binary number to Gray code and use that logic to convert the following to Gray code: a) 1010101010 b) 1111100000 c) 0000001110 d) 1111111111