6.Which of the following refers to the resistance offered by the material directly proportional to the lenght of the conductor and inversly to its cross sectional area? A.Conductivity B.Elasticity C. Electricity D.Resistivity

6.Which of the following refers to the resistance offered by the material directly proportional to the lenght of the conductor and inversly to its cross sectional area? A.Conductivity B.Elasticity C. Electricity D.Resistivity

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter9: Current And Resistance

Section: Chapter Questions

Problem 54P: The following table show the measurements of a current through and the voltage across a sample of...

See similar textbooks

Related questions

Q: 2. What makes one appliance more efficient than another model of the same appliance? 3. Give an…

A: Given : Two questions to answer: 1) What makes one appliance more efficient than another model of…

Q: 4. Differentiate ohmic and non-ohmic materials in terms of their I-V curves 5. Differentiate emf of…

A: Ohms law states that for a conductor, the potential difference between the ends of conductor is…

Q: State and define household unit of electricity.

A: Household unit of electricity is kWh (kilo Watt -hour) .1kWh is equal to energy utilized at a rate…

Q: 54.Materials whose electrical properties are in between the conductors and insulators.

A: We know that conductor have huge number of free electron.these free electron helps to flow current…

Q: Name two types of conductor insulation designed to be used underground?

A: Underground cables can be used to transmit and distribute electrical power. Atypical underground…

Q: 1 - Which of the following must occur before we can talk about a current? A) (-) loads should move…

A: 4 scenarios are given and we are expected to tell which one of the scenario causes current flow.

Q: Topic: Ohmic and Non-ohmic Materials What is the power in a circuit of a 30-V battery is connected…

A: Given, Potential difference of battery,V=30 V Resistance,R=10 Ω

Q: Historically, replacing dirt roads with paved roads reduced friction on vehicles. Replacing paved…

Q: Explain what is electromagnetic induction, and use it to illustrate the working principle of an…

Q: Light sensors are widely used in energy-efficient lighting control. List the three major types of…

A: Light sensor at the device is that convert light energy into electrical signal. The three different…

Q: 10) A lightning rod electrons from lightning to the ground. Your answer

A: Lightning rods protect homes from lightning that is it prevent buildings from damage that may cause…

Q: 1. What are the things you have to consider on purchasing electrical appliances to assure your…

A: (a) Electrical appliances must bear proper marking in the appliance or operation manual must…

Q: 6. Ohm's Law says: a circuit, proportional, voltage, The current, in, directly, proportional, is,…

A: In this question we have to rearrange the statements given. Please give positive feedback if the…

Q: A is measured in coulombs, B is measured in seconds, C is measured in volts, and D is measured in…

Q: 5.A lab has a new material they must test in order to determine its nature. Which test will…

A: "Since you have asked multiple questions, as per instructions to us, we will solve the first…

Q: 3. If the current flowing in a certain conductor is 40 mA. a. find the total charge in coulomb and…

A: Given I= 40mA = 40×10-3 A And t= 1.8 sec. We know that charge Q= It and Q= ne Where n= no. Of…

Q: An electric heater used to boil small amounts of water consists of a 45-Ω coil that is immersed…

A: Given information: The resistance offered by the heater (R) = 45 Ω The voltage applied across the…

Q: QUESTIONS Two vecton gven by A und O-310 145 -1 00 A) 7 (al 100 A

A: According to our guideline we have to the first question only. please upload other question…

Q: 5.what is referred to as the interaction of charges in motion from one region to another A.Charge…

A: Resistance is the property of a material that opposes the flow of current through it. The flow of…

Q: 5) 100 mV / 2 pV = a) number: (Unit of measure is Volts (V).) b) full name of SI prefix and unit of…

A: given,100 mv2 pv1 mv= 10-3 v1 pv =10-12 v

Q: Define resistivity of a conductor . Is the resistivity of an alloy lower or higher than that of its…

A: Resistivity : Resistivity of the material is defined as the resistance offered to current flow by a…

Q: 1. A device that produces electricity by transforming chemical energy into electrical energy is…

A: (c) Battery It's the correct option. In battery some chemical reaction ( redox reactions) happens…

Q: 1. Select all of the following that correctly describe what a volt meter and ammeter measure. Select…

A: The voltmeter is a device that is used to measure the potential difference and it is always…

Q: Explain how some of the hair strands of the persons are lifted to the air due to lightning.

A: It deals with the forces and field between the charges during the state of rest. Lightning is the…

Q: 3.How much electrical energy in a second is consumed by a bulb that ha a power rating of 50 watts?

A: 3. Given, Power of bulb = 50 W Time , t = 1 sec Energy = ?

Q: 5. A 250-volt electrical heater is used to warm 3Li/hr of water from 19°C to 98°C. Assume heat…

A: Given: The voltage supplied to the heater: VH=250 V The volume of water to be heated: vw=3 Li…

Q: Dr. Frankenstein requires 16659 watts of power to bring life to his monster. His circuit can handle…

Q: A wind farm generates 2,286 kW of electrical power for a nearby community. The transmission wires…

Q: 9 Insulators can by charged only by this method. Induction Conduction

A: There are several methods of charging. 1. conduction 2. induction 3. charging by friction

Q: The magnetic field produced by a solenoid coil of 1,103 turns of superconducting wire in a magnetic…

Q: 6.) Why are metals typically good electrical conductors? a. Metals have excellent insulator…

A: Metals are typically good electrical conductors because they have electrons that can flow easily…

Q: 1. An electric bulb draws a current of 0.25 A for 20 minutes. Calculate the amount of electric…

A: Introduction : In this question we are provided it value of time and current . With these data we…

Q: 12. Give two examples of electrical devices that are based on transistors.

Q: 9. Which of the following least effective conductors? a. copper c. steel b. water d. gold

A: least effective conductor amongst the given is b: water .

Q: 44.) Which type of battery would you normally not buy for your car?

A: a) A dry cell battery is a battery which contains electrolyte that causes chemical reaction to…

Q: 3. Discuss: The amount of current flow (number of electrons) and the kinetic energy of the emitted…

Q: Electrical consumption = 98.4 kWh Based on the above home electrical consumption, if the home will…

Q: _______________1. Is the law that governs the relationship among current, voltage, and resistance in…

A: Answers:- 1. ohm's law is the law that governs the relationship among current, voltage, and…

Q: Explain the principles involved in lighting and thunder (electricity)

Q: 6. 13C + H → + gn 7. 140 Ba je + 56

Q: image

A: According to the Ohm's law V = I R where, V is the voltage, I is the current and R is the…

Q: 6. Which of the following materials - A, B, C, D-are Ohmic? Circle all that apply. а. А b. В С. С d.…

A: Given Graph between voltage and current is shown in the figure. We have to choose the correct option…

Q: Explain heating effect of electric current.

A: As the electric current is passed through a conductor for some times, the conductor becomes hot and…

Concept explainers

Temperature Variance of Resistance

Electrical resistance or simply resistance is the property of a material that opposes the free flow of electrons through it. The total amount of resistance to the flow of charges (or current) is affected by many factors like the length of the conducting material, its cross-sectional area, resistivity, and temperature.

Question

6.Which of the following refers to the resistance offered by the material directly proportional to the lenght of the conductor and inversly to its cross sectional area?

A.Conductivity

B.Elasticity

C. Electricity

D.Resistivity

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

When 100.0 V is applied across a 5-gauge (diameter 4.621 mm) wire that is 10 m long, the magnitude of the current density is 2.0X108A/m2 . What is die resistivity of the wire?
Name two applications for superconductivity listed in this section and explain how superconductivity is used in the application. Can you think of a use for superconductivity that is not listed?
Some makes of older cars have 6.00-V electrical systems. (a) What is the hot resistance of a 30.0-W headlight in such a car? (b) What current flows through it?
The following table show the measurements of a current through and the voltage across a sample of material. Plot the data, and assuming the object is an ohmic device, estimate the resistance.
Explain the properties of myelinated nerves in terms of the insulating properties of myelin.
. All of the electrical outlets in a room are connected in a single parallel circuit (Figure 7.38). The circuit is equipped with a 20-A fuse, and the voltage is 120 V. (a) What is the maximum total power that can be supplied by the outlets without blowing the fuse? (b) How many 1,200-W appliances can be plugged into the sockets without blowing the fuse?
The current through a 12-gauge wire is given as I(t)=(5.00A)sin(260Hzt)). What is the current density at time 15.00 ms?
Electric circuits are sometimes explained using a conceptual model of water flowing through a pipe. In this conceptual model, the voltage source is represented as a pump that pumps water through pipes and the pipes connect components in the circuit. Is a conceptual model of water flowing through a pipe an adequate representation of the circuit? How are electrons and wires similar to water molecules and pipes? How are they different?
A potential difference of 12 V is found to produce a current of 0.40 A in a 3.2-m length of wire with a uniform radius of 0.40 cm. What is (a) the resistance of the wire? (b) The resistivity of the wire?
What is the resistivity of a wire of 5-gauge wire (A=16.8106m2) , 5.00 m length, and 5.10 m resistance?
A 120-V circuit in a house is equipped with a 20-A fuse that will b1ow if the current exceeds 20 A. What is the smallest resistance that can be plugged into the circuit without causing the fuse to blow?
A power transmission line is hung from metal towers with glass insulators having a resistance of 1.00109 O. What current flows through the insulator if the voltage is 200 kV? (Some high-voltage lines are DC.)