**63.When perspiration on the human body absorbs heat, some ofthe perspiration turns into water vapor. The latent heat of va-porization at body temperature (37 °C) is 2.42 × 10° J/kg. The heatabsorbed is approximately equal to the average energy E given to a sin-gle water molecule (H,O) times the number of water molecules that arevaporized. What is Ē?

Given data: The latent heat of vaporization at body temperature is L=2.42x106 J/kg. The…

Answered: **63. When perspiration on the human…

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter2: The Kinetic Theory Of Gases

Section: Chapter Questions

Problem 58P: (a) How much heat must be added to raise the temperature of 1.5 mol of air 25.0 to 33.0 at...

See similar textbooks

Similar questions

Consider the latent heat of fusion and the latent heat of vaporization for H2O, 3.33 105 J/kg and 2.256 106 J/kg, respectively. How much heat is needed to a. melt 2.00 kg of ice and b. vaporize 2.00 kg of water? Assume the temperatures of the ice and steam are at the melting point and vaporization point, respectively. (a). UsingEq21.9, Q = mLF = (2.00 kg) (3.33l05 J/kg) = 6.66105 J (b).UsingEq21.10. Q = mLV = (2.00kg) (2.256106 J/kg) = 14.51106 J
On his honeymoon, James Joule traveled from England to Switzerland. He attempted to verify his idea of the inter-convertibility of mechanical energy and internal energy by measuring the increase in temperature of water that fell in a waterfall. For the waterfall near Chamonix in the French Alps, which has a 120-m drop, what maximum temperature rise could Joule expect? He did not succeed in measuring it, partly because evaporation cooled the falling water and also because his thermometer was not sufficiently sensitive.
In 1993, the U.S. government instituted a requirement that all room air conditioners sold in the United States must have an energy efficiency ratio (EER) of 10 or higher. The EER is defined as the ratio of the cooling capacity of the air conditioner, measured in British thermal units per hour, or Btu/h, to its electrical power requirement in watts. (a) Convert the EER of 10.0 to dimensionless form, using the conversion 1 Btu = 1 055 J. (b) What is the appropriate name for this dimensionless quantity? (c) In the 1970s, it was common to find room air conditioners with EERs of 5 or lower. State how the operating costs compare for 10 000-Btu/h air conditioners with EERs of 5.00 and 10.0. Assume each air conditioner operates for 1 500 h during the summer in a city where electricity costs 17.0 per kWh.
In cold climates, including the northern United States, a house can be built with very large windows facing south to take advantage of solar heating. Sunlight shining in during the daytime is absorbed by the floor, interior walls, and objects in the room, raising their temperature to 38.0C. If the house is well insulated, you may model it as losing energy by heat steadily at the rate 6 000 W on a day in April when the average exterior temperature is 4C and when the conventional heating system is not used at all. During the period between 5:00 p.m. and 7:00 a.m., the temperature of the house drops and a sufficiently large "thermal mass" is required to keep it from dropping too far. The thermal mass can be a large quantity of stone (with specific heat 850 J/kg C) in the floor and the interior walls exposed to sunlight. What mass of stone is required if the temperature is not to drop below 18.0C overnight?
Beryllium has roughly one-half the specific heat of water (H2O). Rank the quantities of energy input required to produce the following changes from the largest to the smallest. In your ranking, note any cases of equality, (a) raising the temperature of 1 kg of H2O from 20C to 26C (b) raising the temperature of 2 kg of H2O from 20C to 23C (c) raising the temperature of 2 kg of H2O from 1C to 4C (d) raising the temperature of 2 kg of beryllium from 1C to 2C (e) raising the temperature of 2 kg of H2O from -1C to 2C
(a) How much heat must be added to raise the temperature of 1.5 mol of air 25.0 to 33.0 at constant volume? Assume air is completely diatomic. (b) Repeat the problem for the same number of moles of xenon, Xe.
Why is a person able to remove a piece of dry aluminum foil from a hot oven with bare fingers, whereas a burn results if there is moisture on the foil?
Equal masses of substance A at 10.0C and substance B at 90.0C are placed in a well-insulated container of negligible mass and allowed to come to equilibrium. If the equilibrium temperature is 75.0Q which substance has the larger specific heat? (a) substance A (b) substance B (c) The specific heats are identical. (d) The answer depends on the exact initial temperatures. (e) More information is required.
A certain ideal gas has a molar specific heat of Cv = 72R. A 2.00-mol sample of the gas always starts at pressure 1.00 105 Pa and temperature 300 K. For each of the following processes, determine (a) the final pressure, (b) the final volume, (c) the final temperature, (d) the change in internal energy of the gas, (e) the energy added to the gas by heat, and (f) the work done on the gas. (i) The gas is heated at constant pressure to 400 K. (ii) The gas is heated at constant volume to 400 K. (iii) The gas is compressed at constant temperature to 1.20 105 Pa. (iv) The gas is compressed adiabatically to 1.20 105 Pa.
(a) It is difficult to extinguish a fire on a crude oil tanker, because each liter of crude oil releases 2.80107J of energy when burned. To illustrate this difficulty, calculate the number of liters of water that must be expended to absorb the energy released by burning 1.00 L of crude oil, it the water has its temperature raised from 20.0C to 100C, it boils, and the resulting steam is raised to 300C. (b) Discuss additional complications caused by the fact that crude oil has a smaller density than water.

Recommended textbooks for you

University Physics Volume 2

Physics

ISBN:

9781938168161

Author:

OpenStax

Publisher:

OpenStax

Principles of Physics: A Calculus-Based Text

Physics

ISBN:

9781133104261

Author:

Raymond A. Serway, John W. Jewett

Publisher:

Cengage Learning

Physics for Scientists and Engineers, Technology …

Physics

ISBN:

9781305116399

Author:

Raymond A. Serway, John W. Jewett

Publisher:

Cengage Learning

University Physics Volume 2

Physics

ISBN:

9781938168161

Author:

OpenStax

Publisher:

OpenStax

Principles of Physics: A Calculus-Based Text

Physics

ISBN:

9781133104261

Author:

Raymond A. Serway, John W. Jewett

Publisher:

Cengage Learning

Physics for Scientists and Engineers, Technology …

Physics

ISBN:

9781305116399

Author:

Raymond A. Serway, John W. Jewett

Publisher:

Cengage Learning

Physics for Scientists and Engineers: Foundations…

Physics

ISBN:

9781133939146

Author:

Katz, Debora M.

Publisher:

Cengage Learning

College Physics

Physics

ISBN:

9781938168000

Author:

Paul Peter Urone, Roger Hinrichs

Publisher:

OpenStax College

College Physics

Physics

ISBN:

9781285737027

Author:

Raymond A. Serway, Chris Vuille

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS