Which of the following is NOT TRUE about the Newton's Law of Cooling? O It describes the rate at which an exposed body changes temperature through radiation. O The temperature of the surroundings must remain constant during the cooling of the body. O It states that the rate of loss of heat from a body is directly proportional to the difference in the temperatures of the body and its surroundings O It is limited to cases where the difference in temperature between the body and the surroundings is small.

Which of the following is NOT TRUE about the Newton's Law of Cooling? O It describes the rate at which an exposed body changes temperature through radiation. O The temperature of the surroundings must remain constant during the cooling of the body. O It states that the rate of loss of heat from a body is directly proportional to the difference in the temperatures of the body and its surroundings O It is limited to cases where the difference in temperature between the body and the surroundings is small.

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter14: Heat And Heat Transfer Methods

Section: Chapter Questions

Problem 17PE: (a) How much heat transfer is necessary to raise the temperature of a 0.200kg piece of ice from...

See similar textbooks

Similar questions

(a) What is the change in internal energy for the process represented by the closed path shown below? (b) How much heat is exchanged? (c) If the path is traversed in the opposite direction, how much heat is exchanged?
In 1986, a gargantuan iceberg broke away from the Ross Ice Shelf in Antarctica. It was approximately a rectangle 160 km long, 40.0 km wide, and 250 m thick. (a) What is the mass of this iceberg, given that the density of ice is 917kg/m3 ? (b) How much heat transfer (in joules) is needed to melt it? (c) How many years would it take sunlight alone to melt ice this thick, if the ice absorbs an average of 100W/m2, 12.00 h per day?
(a) A cyclical heat engine, operating between temperatures of 450C and 150C produces 4.00 MJ of work on a heat transfer of 5.00 MJ into the engine. How much heat transfer occurs to the environment? (b) What is unreasonable about the engine? (c) Which premise is unreasonable?
(a) Calculate the rate of heat transfer by radiation from a car radiator at 110C into a 50.0C environment, if the radiator has an emissivity of 0.750 and a 1.20m2 surface area. (b) Is this a significant fraction of the heat transfer by an automobile engine? To answer this, assume a horsepower of 200 hp (1.5 kW) and the efficiency of automobile engines as 25%.
(a) It is difficult to extinguish a fire on a crude oil tanker, because each liter of crude oil releases 2.80107 J of energy when burned. To illustrate this difficulty, calculate the number of liters of water that must be expended to absorb the energy released by burning 1.00 L of crude oil, if the water's temperature rises from 20.0 C to 100 C, it boils, and the resulting steam's temperature rises to 300 C at constant pressure. (b) Discuss additional complications caused by the fact that crude oil is less dense than water.
Practical steam engines utilize 450C steam, which is later exhausted at 270C. (a) What is the maximum eficiency that such a heat engine can have? (b) Since 270C steam is still quite hot, at second steam engine is sometimes operated using the exhaust of the first. What is the maximum eficiency of the second engine if its exhaust has a temperature of 150C ? (c) What is the overall eficiency of the two engines? (d) Show that this is the same eficiency as a single Carnot engine operating between 450C and 150C. Explicitly show how you follow the steps in the Problem-Solving Strategies for Thermodynamics.
From Table 21.1, the specific heat of milk is 3.93 103 J/ (kg K). and the specific heat of water is 4.19 103 J/(kg K). Suppose you wish to make a large mug (0.500 L) of hot chocolate. Each liquid is initially at 5.00C. and you need to raise their temperature to 80.0C. The density of milk is about 1.03 103 kg/m3, and the density of water is 1.00 103 kg/m3. a. How much heat must be transferred in each case? b. If you use a small electric hot plate that puts out 455 W, how long would it take to heat each liquid?
(a) What is the work output of a cyclical heat engine having a 22.0% eficiency and 6.00109J of heat transfer into the engine? (b) How much heat transfer occurs to the environment?
In an insulated vessel, 250 g of ice at 0C is added to 600 g of water at 18.0C. (a) What is the final temperature of the system? (b) How much ice remains when the system reaches equilibrium?
(a) What is the eficiency of a cyclical heat engine in which 75.0 kJ of heat transfer occurs to the environment for every 95.0 kJ of heat transfer into the engine? (b) How much work does it produce for 100 kJ of heat transfer into the engine?
(a) Calculate the rate of heat conduction through a double-paned window that has a 150-m2 area and is made of two panes of 0.800 cm-thick glass separated by a 1.00 cm air gap. The inside surface temperature is 15.0 C, while that on the outside is 10.0 OC. (Hint: There are identical temperature drops across the two glass panes. First find these and then the temperature drop across the air gap. This problem ignores the increased heat transfer in the air gap due to convection.) (b) Calculate the rate of heat conduction through a 1.60-cm-thick window of the same area and with the same temperatures. Compare your answer with that for part (a).
(a) What is the rate of heat conduction through the 3.00-cm-thick fur of a large animal having a I .40-m surface area? Assume that the animal's skin temperature is 32.0 , that the air temperature is 5.00 , and that has the same thermal conductivity as air. (b) What food intake will the animal need in one day to replace this heat transfer?