7. According to film theory, mass transfer coefficient (K) is inversely proportional to the film thickness ôn and directly proportional to.. ..?
Q: Agas at 0°C and avelocity of 2.5 m/s, flows over a 1.2 m long, 2 m wide plate that is maintained at…
A: Gas temperature, Tg=0oC Velocity of gas, V=2.5 m/s Length of the plate, L=1.2m Width of plate, w=2m…
Q: 6. A vertical plate 450 mm high and maintained at 30°C is exposed to staturated steam at atmospheric…
A:
Q: (a) A liquid with known properties (i.e. density, viscosity, etc. ) is contained in the space Ra 0…
A: Nondimensional temperature dispersions for transient outspread hotness conduction through empty…
Q: EES |of 1 mm is used for measuring the temperature of a hydrogen gas stream. The properties of the…
A: According to our guidelines, we cannot provide solution using any software. But we can provide you…
Q: The water vapor pressure of ambient air is 19 mmHg, and the wind speed is 1.7 m/s. Calculate the…
A: The water vapour pressure of ambient air is Pa=19 mmHgWind speed Va=1.7 m/secVapour pressure at…
Q: A centrifuge bowl is to separate two immiscible liquids, one with SG 1.1 and the other with SG 0.9.…
A:
Q: QUESTION 5 Consider the fully developed flow of light oil at 25°C (p = 910 kg/m³, μ = 0.048 Pa)…
A:
Q: in convection heat transfer, what happen to the heat transfer coefficient if the viscosity of the…
A: Convection is the circular motion that occurs when warmer air or liquid rises, while colder air or…
Q: centrifuge bowl is to separate two immiscible liquids, one with SG 1.1 and the other with SG 0.9.…
A:
Q: A two-compartment vessel contains a fluid in each section. For the first compartment the fluid…
A:
Q: Net radiation at the Laguna Lake is 185 W/m2 at noon on February 14th. Air temperature is 29.5°C,…
A:
Q: Water is to be boiled at atmospheric pressure in a polished copper pan by means of an electric…
A: As per the calculation the nearest option is b, so option b is correct.
Q: A vertical plate 350mm high and 240mmwide, at 40°C, is exposed to saturated steam at 1 atm.…
A: Given, Height of the vertical plate, h=350 mm=0.35 m Width of the vertical plate, b=240 mm=0.24 m…
Q: A mixture of water (density=1000 kg/m3) and vapor flowing with a mass rate = 7 kg/sec in a pipe of…
A:
Q: Q 1. Define and briefly elaborate terms listed below, support your elaboration with mathematical…
A: The concentration boundary layer generated when there is a difference in concentration of a…
Q: Dry ice evaporates directly in room temperature, This phenomenon is referred to as O Deposition O…
A: given; Q.3 dry ice evaporates in room temperature this phenomenon is referred to as - Q.4 when a…
Q: Define and briefly elaborate the terms listed below, support your elaboration with mathematical…
A: Concentration boundary layer By convention, the thickness of the boundary layer is defined as the…
Q: Derive the mass conservation equation in cylindrical coordiınates [eq. by applying the general…
A:
Q: Calculate the evaporation rate from an open water source, if the net radiation is 300 W/m² and the…
A: Write the given data with suitable variables: E=300 W/m2ρ=996 kg/m3T=30°C
Q: Saturated steam at 100 °C in condensing over 1-cm diameter vertical metal rod which maintained at 93…
A: Given data:
Q: (c) The diameter of the piston and qutletof the paint sprayer in Fig. 1 is 6 cm and 0.5 cm,…
A:
Q: Determine the settling velocity of a unit-density spherical particle of 0.3 micron (µm) diameter at…
A:
Q: Q1: Ammonia is absorbed in water from a mixture with air using a column operating at atmospheric…
A:
Q: A spherical tank 8.5 m in diameter contains methane (CH4) at 450 kPa and 35oC and 10 kg had been…
A:
Q: State and explain Fick's Law of mass transfer by molecular diffusion. Show that Fick's law of…
A:
Q: Concentration boundary layer, Viscous boundary layer and Thermal Boundary Layer. Diffusion…
A:
Q: The mass diffusion rate dm/dt across a boundary between two different metals is a function of the…
A: Solution:
Q: 8. A coal fired steam boiler uses 3000 kg of coal per hour. Air required for combustion is 15.5 kg…
A: Dear student, According to the expert guidelines I am allowed to answer only…
Q: Isabelle pour 158cm^3 of glycerin, at a temperature of -12 °C, into a graduated cylinder initially…
A: Volume of pour v=158 cm3For glycerin m=.0873 kgT1=-12 ° CT2=TfCglycerin=3140 jkgkFor…
Q: EXAMPLE 5 In an oil refinery, a storage tank contains 2000 gal of gasoline that ini- tially has 100…
A: Given Data: Total amount gasoline =2000 gal Amount of additive dissolved in gasoline initially…
Q: When water boils in a pot with a loose lid, the increased pressure forces the lid upward, releasing…
A: In this , we can assume the pot is cubical whose side length is 10 cm
Q: iA being transferred across air film at & total 'pressure of 11 bar: The partial at one boundang of…
A:
Q: Consider pressurized water, engine oil (unused), and Nak (22%/78%) flowing in a 20-mm-diameter tube.…
A:
Q: A 2-ft diameter column packed with l-teu ceramic Raschig rings was operated with air and water and…
A: To find: The flow rate of liquid to the column in gallons per minute. Given: The diameter is column…
Q: The global average sensible heat flux is 17 W/m2. Use the following information to estimate the…
A: GivenSHF=17 W/m2Q=520×1012 m3/yrLHV=2.5×103 kJ/kg=2.5×106 J/kg R=6400km
Q: It is desired to reduce the 2% CO, in 23 Ib/sec of a natural gas stream using absorption in aqueous…
A:
Q: In a reservoir system with a very large accumulation volume for the ideal fluid (water), a) Since…
A:
Q: In an absorption tower, ammonia is absorbed from air at atmospheric pressure by acetic acid. The…
A: Solution hduPBmPμρD0.56=jd and: Substituting the given data gives:
Q: Problem 1: Helium gas is seperated from other components of a gas mixture by its selective diffusion…
A: P1: Given: The helium pressure at the inner surface, Pi = 1.5 bar The helium pressure at the outer…
Q: For Cairo Egypt in January the average net radiation 40 W/m2, temperature is 14°C. relative humidity…
A:
Q: 21.3-3. Mass-Transfer Coefficient for Various Geometries. It is desired to estimate the…
A:
Q: aseous hydrogen weakens the mechanical strength of cast iron. this phenomenon often occurs in cast…
A: CAs=2.2×10-7 mol H atoms/g FeCA=1.76×10-7mol H atoms/g Fe To- Find:- t=?
Q: A mixture of water (density=1000 kg/m3) and vapor flowing with a mass rate = 7 kg/sec in a pipe of…
A: The mass flow rate of vapour present in the system can be determined as shown below.
Q: Q6) A substance has a latent heat of vaporization of 10° J/kg and a boiling point of 500 K at…
A:
Q: When oil and gas flow in vertical pipes, and the flow regimes is bubble flow then the continuous…
A:
Q: Briefly discuss the three fundamental mechanisms of heat transfer and two fundamentaln mechanisms of…
A: Whenever there is a temperature difference between the two bodies there is heat transfer takes…
Q: In a falling-film evaporator, Air at 40℃ and 50 kPa flows through a wetted-wall column with 100 mm…
A: Given data : Findu = 10 mm a) mass transfer coefficientv = 5…
Q: Subject: Thermodynamics The actual velocity of gas entering in a chimney is 8m/sec. The gas…
A: Given data: m˙=50000 kg/hv=8 m/sT=25°C=298 KP=98 kPa Need to determine the chimney diameter if mass…
short answers:
Trending now
This is a popular solution!
Step by step
Solved in 2 steps with 1 images
- Develop a mathematical expression for the effective mass transfer rate achieved by an implanted drug delivery device that consists of a spherical core of radius R0 containing the drug, surrounded by a gel barrier of uniform thickness (R1-R0), i.e., the radius of the device (reservoir + barrier) is R1. When implanted, a scar tissue layer of thickness (R2-R1) forms around the device. State and justify any assumptions you might make. For a spherical shell, the flux and mass transfer rate are given by the following expressions (see notes “Steady State Molecular Diffusion: Geometry Effects”Define and briefly elaborate the terms listed below, support your elaboration with mathematical equations and illustrations where necessary 1. Concentration boundary layer, Viscous boundary layer and Thermal Boundary Layer 2. Diffusion equation. Laplace's equation and Poisson's Equation for rectangular coordinates. 3. Analogy between heat and mass transfer.1. a) Derive the general mass transfer equation in Cartesian coordinates. b) The molecular weights of two components A and B of a gas mixture are 24 and 28 respectively. The molecular weight of gas mixture is found to be 30. If the mass concentration of the mixture is 1.2 kgm3, determine i) Molar fractions, ii) mass fractions, iii) Total pressure if the temperature of the mixture is 290K.
- For Cairo Egypt in January the average net radiation 40 W/m2, temperature is 14°C. relative humidity is 65%, and wind speed is 2.0 m/s measured @ a height of 2.0 m. Compute the evaporation rate by 1. Priestley-Taylor Method Zo=0.03a)derive the general mass transfer equation in Cartesian coordinates. b) The molecular weight of two components And B of a gas mixture are 24 and 28 respectively. The molecular weight of gas mixture is found to be 30. If the mass concentration of the mixer is 1.2 kgm3, determine I) Molar fraction II)mass fraction, III) total pressure if the temperature of the mixture is 290K.Diffusion flux is directly proportional to the concentration gradient, according to Fick’s first law. Concentration gradient is________: A ) Rate of change of concentration with respect to distance B ) Rate of change of concentration with respect to time C ) Difference in concentrations at the source and sink D ) Ratio of concentrations
- Saponification is a process wherein soap is added to a certain type of oil to produce grease. One such grease is said to have 75.7 % by volume oil and 24.3% by volume soap, wherein the oil and soap have densities 760 kgm/m3 and 6,250 kgm/m3, respectively. This kind of grease is sold by packs shaped like a sphere with a diameter of 20 cm for convenience. Calculate: a) the mass of oil per pack (kgm), b) the mass of soap per pack (kgm), c) the weight of each pack (kgf), d) the specific weight of grease (N/m3), e) will the grease float if it is placed in water whose density is 1000 kgm/m3? Explain.Define and briefly elaborate terms listed below, support your elaboration with mathematical equations and illustrations where necessary: Concentration boundary layer, Viscous boundary layer and Thermal Boundary Layer. Diffusion equation, Laplace’s equation and Poisson’s Equation for rectangular coordinates. Analogy between heat and mass transfer. Prandtl, Schmidt, Lewis, Nusselt, and Sherwood number. Mole fraction of species and mass fraction of species. Critical radius of insulation related to heat transfer in pipes.The ratio of mass transfer by convection/advection to that of diffusion in the same direction is called the ________________ number.
- Calculate the time taken for a 7 um radius cloud droplet to grow via condensation into a 3500 um rain droplet. Assume a super-saturation of 1.55%, a water vapour density of 3 g m-3, and a water vapour diffusion coefficient in dry air of D=24 x10-6 m2 S -1 PLEASE SHOW CALCULATIONDetermine the settling velocity of a unit-density spherical particle of 0.3 micron (µm) diameter at STP. Given: Cunningham or slip correction factor Cc for a 0.3 µm particle is 1.567 at STP. Determine the Brownian diffusion (root mean square displacement per second) of a unit-density particle of 0.3 µm diameter. Assume STP. Given: Diffusion coefficient of a unit-density spherical particle of 0.3 µm diameter is 1.23 x 10-6 cm2/s at STPRelationship between fluid flow and convection heat transfer