7. How much is the Xc ( in polar form ) of a 200-pF capacitance at 40 KHz? Answer : Xc = ΚΩ

Q: B) convert (-2,75 degrees) to rectangular.

A: Given Polar form is  = (-2,75°) Conversion to rectangular form:  

Q: 1. Explain the trade-offs between relays and PLCS for control Applications.

A: Note: We are authorized to answer one question at a time since you have not mentioned which one you ...

Q: Consider a transmission line with Z-=50 N that is terminated by a load with ZL=200+j100 2. The wavel...

A: Given: Consider a transmission line with Zo=50 Ω that is terminated by a load with ZL=200+j100 Ω. Th...

Q: 4. A single-core lead covered cable is to be designed for 66 kV to earth. Its conductor diameter is ...

A: We know that,gmax A=q2πεoεAr; gmax B=q2πεoεBr1;gmax C=q2πεoεCr2gmax AεAr=gmax B εBr1=gmax C εCr2 ......

Q: Q5) Explain about JK-flip flops and Show its characteristic table and equations.

A:

Q: In an npn power transistor, the collector current is 20 mA. If 98% of the electrons 
injected in to ...

A:

Q: Solve for amount of current thru resistor #4 (R4). Select one: a.1.22 A b.0.833 A c.0.68 A d.0....

A: From the circuit, we can observe that R4 and R5 are in series ∴Total resistance R will be sum of R4 ...

Q: Design an insulated DC-DC converter. Give some detailed information about the topology you suggested...

A: DC-DC converter- It is a device or a circuit which tooks a DC supply as input and provide the DC as ...

Q: Identification All answers must be in accordance to NEC of the Philippines 1. What is the minimum ga...

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts fo...

Q: The combined stop-rear lights circuit design is to conform to the following speci- fications: 1. Nee...

A: LED: It is a semiconductor device and blows light when current flows in it.

Q: R1 R7 R5 这C4

A: The detailed solution is provided below.

Q: an input signal ranges from 20–40 A (microamps), with an output signal ranging from .5–1.5 mA (milli...

A:

Q: The 6 bit DAC has a 101101 INPUT and a 10 volt reference voltage. a. Determine the output voltage b....

A: Most of the Electronics equipment works on the digital signal but we have analog input with us. To p...

Q: A 440 V, 3-phase, 50 Hz, 4-pole, Y-connected induction motor has a fu the rotor has an impedance of ...

A:

Q: 57. In the circuit of Fig. 3.93, only the voltage vz is of interest. Simplify the circuit using appr...

A:

Q: 4. L = E = 200 V= R, = 150 0 R2 = 300 N %3D 12

A:

Q: (2) suppose the open-loop amplifier (or simply the OpAmp) in the above feedback amplifier has the fo...

A: The magnitude response is the ratio of the output signal's frequency amplitude to the input signal's...

Q: A 200 ohms resistor is conected to a 1.5V battery a. how much current flows through resistor b. de...

A: Given: 200 ohms resistor is connected to a battery whose voltage is 1.5 volts.   

Q: Use superposition theorem to find Vx in the circuit

A: In this question,  We need to determine the voltage Vx using the super position theorems.  Here 2 in...

Q: (a) Show tha t CA-B)? +IAX Bỉ : (AB) (6) Show that Scanned with CamScanrrer ax : ay xaz az X qx az :...

A: Cross ProductA)ax×ay=azB)ay×az=axC)az×ax=ayDot ProductA)ax.ay=0B)ay.az=0C)az.ax=0A)ax.ax=1B)ay.ay=1C...

Q: COMPONENTS AND CYLINDRICAL PROBLEM # 3 EXPREGS THE VECTOR FIELD D= (x²+y2)"(xax +yay) IN CYLINDRICAL...

A: It is given that: D=x2+y2-1xax+yay

Q: D D2 48 2 10 V- www D4 D3 (i)

A:

Q: Solve for amount of current thru resistor #4 (R4). Select one: a.1.22 A b.0.833 A c.0.68 A d.0.542 A...

A: We need to find out current through the given resistor

Q: Given the controller equation; A = B · (C • (D+E + T)+F•C) The circuit is given below, and equivalen...

A: Demorgans laws: (A+B)' = A' + B'  (AB)' = A' . B'    

Q: Consider the circuit below: Simplify the circuit and write the super position circuits for I1, 12, a...

A: In superposition theorem, we draw multiple circuits such that in each circuit only one independent s...

Q: Find the electric field at point A produced by charges Q1 = -4C and Q2 = 16C Q1 = -4C Q2 = 16C B C.

A:

Q: $1= 30/0° Amperes S, = 220 20° Volts USE MESH ANALYSIS to get: a. 11, 12, 13, b. lo c. V3 and P3 (R3...

A: Note : i) Frequency is not given,  we assume frequency =50 Hz ii) Current I2 is in all three loops a...

Q: 3. Analyze the circuit to calculate V, from the circuit given below. V1= 0.1 V 100k 20k 400k 10k 20k

A: This questions belongs to analog electronics . It is based on the concept of virtual ground in ideal...

Q: In the circuit shown in Fig. 4, switch 1 has been in position (a) and switch two has been closed for...

A: In this question,  We need to determine the voltage Vc(t) for t>0 We are solving this problem usi...

Q: For a control volume in transient operation, the change of the energy inside the control volume duri...

A:

Q: Consider the unity feedback system with K(s+ 4) G(s): s(s +1)(s+2) Find the following: (a) The range...

A:

Q: RC circuit has a reactance of 820 ohm and 10 V AC voltage.   What is the resistance necessary to ach...

A: In this question RC circuit is given with reactance and voltage...We have to find out resistance for...

Q: 14-13 Some common parameters for several types of coarial cable are a characteristic impedance of 50...

A:

Q: 2. A silicon diode is in series with 1K2 resistor and a 5V battery. If the anode is connected to the...

A: In this question,  We. Need to determine the voltage across the cathode terminal w.r.t of the batter...

Q: 4- Design a digital comparator which compare two each with 2-bit using truth table method ?

A:

Q: compound semiconductor intrinsic level is found to be 0.0003ev below the mid gap at 300l what is the...

A: We need to find ratio for electron mass to hole mass .

Q: a) Design a Butterworth band-pass filter using the TL084 amplifier and draw it with the following sp...

A: Filter is a device that process the signal and gives desired output. It can be active or passive and...

Q: Find the equivalent resistance

A:

Q: Discuss how a very large electric field is generated by using an Induction coll

A: Discuss how a very large electric field is generated by using an induction coil.

Q: 3. Using thevenin theorem, find the power loss in the 1ohm resistor. 52 12 10V

A:

Q: Solve for amount of current thru resistor #4 (R4). Select one: a.1.22 A b.0.833 A c.0.68 A d.0.542 A...

A: We need to find out current for given circuit

Q: 3. P,=. E = 100 V= R, = 100 R2 = 500 Rз - 200 0 %3D P2

A: In this question we have to find the power across resistor R2

Q: 3.Draw the logic diagram of a 5-bit parallel binary adder using a combinationof half adders and full...

A: 5-bit parallel binary adder using half adder (HA) and full adders (FA) :  

Q: In a common emitter transistor amplifier, the output resistance is 500 KΩ and the current gain β = 4...

A:

Q: 3. A germanium diode has an ambient temperature of 25°C, what is the barrier potential of a silicon ...

A:

Q: v(t) = u(t – Tu) – u(t – Ta) on the interval [0, T], where Tu = 4 and Ta = T. This function defines ...

A:

Q: Take a graph sheet and divide it into 4 equal parts. Mark origin at the center of the graph sheet. N...

A: According to the question, for the given Si diode, we need to plot the V-I characteristics.

Q: Let A = 4ax + 2ay - az and B = ax + ay + 3az If A and B are parallel, find  and  If A and B are pe...

A:

Q: Design a closed loop speed control system so that a separately excited DC motor can be controlled wi...

A: Motor: It is an electromechanical device that produces output as mechanical torque. The motor can be...

Q: 22. Assuming an ideal diode, sketch vị, vď, and ią for the half-wave rectifier of Fig. 168. The inpu...

A: Since you have posted multiple questions, we will solve the first question for you. If you require t...