Answered: 7. What capacitance has a reactance of…

Engineering

Electrical Engineering

7. What capacitance has a reactance of 802 when a 500HZ source is connected?

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.13P

See similar textbooks

Related questions

Q: Q4: Determine the minimum transmission bandwidth required to transmit the following two signals: fi(...

A: It is given that: f1t=10 cos150πt+15 cos200πtf2t=10 cos100πt cos200πt

Q: Find the equivalent resistance between A and B. 11 ohm 10 ohm 10 ohm 32 ohm 29 ohm 30 ohm O 31 ohm

Q: RI Ci a VSm ISm ZVSph L1 ZISph b In the circuit, the voltage source amplitude and phase are 40 V and...

A: In this question, We need to determine the Thevenin equivalent circuit across the terminal a and b....

Q: In cylindrical coordinate system, p = 2, ø = defines a; Select one: O Vector Surface Point Line O No...

Q: The current through a 7-mH inductor is 10e-2 A. What is the voltage at t=2.5 s?

Q: In Fixed-bias configuration, the DC voltage across the Gate terminal is equal to ____. a.Vp b.Vgs c....

A: In Fixed-bias configuration, the DC voltage across the Gate terminal is equal to...

Q: Find the gain V. 20 k2 ww 10 k2 Vs 10 k2 ww (+)

A: In this question, The op amplifier is given. Find the ratio of output voltage to input voltage? V...

Q: Describe the voltage across and the current through the inductor combination in both charging and di...

A: Two circuits are given with two switches. We need to describe the voltage across the capacitor combi...

Q: Give the reason why a dielectric material increases capacitance compared with what it would be with ...

Q: A function e(t) is sampled and its z-transform is as follows: z - b E(z) z2 – cz² + d Find the z-tra...

A: We need to find out z Transform of given signal

Q: A transistor whose forward current transfer ratio (Beta) is 100. What will be the value of the base ...

Q: A 460-V 60-Hz four-pole Y-connected induction motor is rated at 25 hp. The equivalent circuit parame...

A: In this question, 460V, 60Hz 3 phase induction motor, Equivalent parameters are given. The line c...

Q: A 220V(rms), 50HZ sinusoidal source is connected to the primary side of an ideal transformer with 10...

Q: Determine each system if Static or Dynamic (5 points), Linear or Non-Linear (5 points), Time Variant...

Q: Electrical Engineering Example • Calculate the total reserve requirement assuming the peak demand of...

Q: G Calculate the values of V,, Ve and Vic for the circuit shown in Figure 14.46a. IT IT H 008 Rs 18 N...

Q: In common source configuration the input resistance of a JFET will be approximately____. a.500 Ohm b...

Q: Determine if the systems given below are Static or Dynamic, Causal or non-causal, Linear or non-line...

A: We need to analyse the given system .

Q: Problem [7] Find v, and i, 10 k2 1V 100 k2 vo 90 k2 10 k2 50 k2 (+)

A: The solution is given below.

Q: 10 Ω 3Ω 6Ω lo 12 V + 6Ω + 8 V

Q: A 6 H inductor and a 30Ω resistor are connected in series with a voltage source of 10??? 20?. Use La...

A: It is given that: A 6 H inductor and a 30Ω resistor are connected in series with avoltage source of ...

Q: In common source configuration the input resistance of a JFET will be approximately___ а. З Меда Ohm...

A: A common source JFET amplifier offers high input resistance and low noise at output signal. This hi...

Q: What is the difference between active power, reactive power and apparent power?

A: The solution is given below

Q: VDD = 16V, RG = 1M-ohm, RD = 1500 ohm, RS = 750 ohm, IDSS = 10mA, VP=-4V a. Determine the drain cur...

A: In this question, The given parameters VDD = 16V, RG = 1M-ohm, RD = 1500 ohm, RS = 750 ohm, IDSS = ...

Q: %) For a given logic function Lo A B +C Z = (A + B) + Implement it with only one CMOS compound gate.

A: The solution is given below

Q: (18, 9, 9, 18) and a = (4, –4, 2, -2). Find the vector Let u = Ed component of u along a and the vec...

Q: (23. Determine the magnitude and phase angle of the source voltage in Figure 14.48a. 22. Determine t...

Q: A carrier IS simultaneously modulated by two different audio sine waves. If the modulation index due...

A: We need to find out modulation index .

Q: Given J(a,b,c,d) = Σm(0,1,2,3,7,8,10) + Σd(5,6,11,15) 1. Determine the minimal Sum of Products (SO...

Q: Compute the total gain of the system. /A1 = 15 dB A2 = - 20 dB A3 = 35 dB %D

Q: 1) Consider the inductor core shown above. Draw a magnetic equivalent circuit for the device when 11...

Q: Design a rectifier fed from 220-V line through a step-down transformer. The load requires an averag...

A: Rectifier: The rectifier is used to provide the DC output and takes AC supply.

Q: The switch in the circuit has been in position x for a long time. Att= 0, the switch moves instantan...

Q: t=0 12Y 3F Yo 42

Q: A total charge of 15 nanocoulombs is distributed evenly on a ring of radius 75 centimeters. Find the...

Q: 3. Calculate the current through the Zener diode for the given values of load resistance in this cir...

Q: ki, I R

Q: INSTRUCTION: Determine the internal resistance (and its uncertainty) of the battery, also plot a gra...

A: A table with the results of voltage and currents for four circuits is given in the question. We need...

Q: At every point in the space ax × ay = -az Select one: O Correct O It depends on the location O None ...

Q: A balanced 3-phase load comprised of a 1002 resistor in series with a 1H inductor is connected to a ...

Q: In a fix bias NPN transistor amplifier, Vcc = 12 V, collector resistor is 5 kOhms. What will be the ...

Q: Q27 For a current of r. m. s value 5 A, and frequency 2 kHz, write down the standard expression. Hen...

Q: The voltage of a 100-KW, 250-volt shunt generator rises to 260 volts when the load is removed. What ...

Q: In a delta connected load, the line current and phase current is equal. True or false

Q: Two switches operate simultaneously. Priortot= 0 each switch has been in its indicated position for ...

A: In this question we use inductor property 1. In steady state inductor act as short circuit for DC so...

Q: A total charge of 30 microcoulombs is equally distributed throughout the volume of a insulating sphe...

Q: -0.125 0.435 0, (s) X,(s) (s) -2 -1.23 -0.226 -0.0169

Q: What is the cut off frequency of a RC low pass filter of the first order.

Q: In N-channel JFET the Id is controlled by_______. a.Idss b.Vgs c.Vds d.Ig

Q: In an AM signal, the peak amplitude is three times the unmodulated carrier level. The percent modula...

A: Brief description : Amplitude Modulation system is one of the modulation system where amplitude of t...

Concept explainers

Compensation Techniques

The compensation techniques are the methods that are employed in the electrical control systems to enhance the performance of the system. The performance are generally affected by the factors like lag in the compensating devices, slow response of the system of the components like sensors used in the control system. The basic compensation technique involves lag compensation, lead compensation or the combination of the both.

Question

7. What capacitance has a reactance of 802 when a 500HZ source is connected?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Compensation Techniques in Transmission Line

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is the minimum AC voltage rating of each capacitor in Question 11?
If a capacitor produces 15 ampere on a 240-volt supply, which of the following is its microfarad rating? 166 microfarad 15 microfarad 200 microfarad 3450 microfarad
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
You are an electrician working in an industrial plant. A 30-hp three-phase induction motor has a current draw of 36 amperes at full load. The motor is connected to a 480-volt line. A three-phase wattmeter indicates a true power of 22 kW. Determine the power factor of the motor and the amount of capacitance needed to correct the power factor to 95. Also determine the minimum voltage rating of the capacitors. The capacitors are to be connected in wye.
Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.
Convert the following instantaneous currents to phasors, using cos(t) as the reference. Give your answers in both rectangular and polar form. (a) i(t)=5002cos(t30) (b) i(t)=4sin(t+30) (c) i(t)=5cos(t15)+42sin(t+30)
Capacitive Circuits Fill in all the missing values. Refer to the formulas that follow. XC=12fCC=12fXCf=12CXc Capacitance XC Frequency 38 F 60 Hz 78.8 400 Hz 250 pF 4.5 k 234 F 10 kHZ 240 50 Hz 10 F 36.8 560 nF 2 MHz 15 k 60 Hz 75 nF 560 470 pF 200 kHz 6.8 k 400 Hz 34 F 450
The circuit is connected to a 60-Hz line. The apparent power in the circuit is 29.985 VA, and the power factor is 62.5%. The resistor has a voltage drop of 14.993 V, the inductor has an inductive reactance of 60 , and the capacitor has a capacitive reactance of 45 . ETITZVA29.985PF62.5%ER14.993VIRRPELILXL60VARsLLECICXC45VARsCC
Three capacitors having values of 2.2 F, 280 F, and 470 pF are connected in parallel. What is the total capacitance?
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
Two capacitors having values of 80 F and 60 F are connected in series. What is the total capacitance?