7. What is the unit of power absorbed in a fluid? a) Ampere b) Volt/m c) kgm²s³ d) kg/m

Q: 150 mm d 200 mm d 1.25 m Hg Problem 4.96 Pieblem 4.95 4.96. One hundred and twenty litres per second…

A:

Q: Determine the head loss per km length of a steel pipe galvanized, with a 45cm diameter circular…

A: We have to determine the value of head loss per km of the length of steel galvanized pipe.

Q: A tank is shaped like a vertical cylinder; it initially contains water to a depth of 9 ft, and a…

A:

Q: Water flows from a hose bib at a rate of 15.8 gallons per minute. What is the rate in liters per…

A: Given data: Flow rate = 15.8 gallons per minute = 15.8 gallonsminute As we know, 1 gallon = 3.785412…

Q: An engineer uses a solar-powered submersible pump to supply 20°C ground water to an above-ground…

A: d = 2cm = 0.02m = 20mm A = 3.1416 x 0.022/4 = 0.00031416m2

Q: A venturi meter with throat diameter of 37.5 mm and coefficient of discharge of 0.957 is connected…

A:

Q: A 70-mm-diameter suction pipe leading to a pump, as shown below, carries a discharge of 0.05 of oil…

A:

Q: 3. The horizontal pump in the Figure discharges 18°C water at 35 m/h. Neglecting losses, what power…

A: Given that: Pressure at point 1, P1=160 kPaPressure at point 2, P2=480 kPaDiameter at point 1,…

Q: Given data : Depth of flow=2 m Velocity of flow=3 m/s g=10 m/s2 Find specific energy

A:

Q: Water flows from a large reservoir at the rate of 1.20 ft/s through a pipe system as shown in Tigure…

A: To calculate the amount of energy loss (HL)-

Q: A venturi meter of 15 cm inlet diameter and 10 cm throat is laid horizontally in a pipe to measure…

A: inlet diameter = 15 cm throat= 10 cm  The reading of a mercury manometer = 20 cm oil specific…

Q: 9. Find the specific energy of flowing water through a rectangular channel of width 5 m when the…

A:

Q: Q2: Air stream at 27°C moving at 0.3 m/s across 100 W incandescent bulb, glowing at 127 °C. If the…

A:

Q: Q2. A venturi meter of 15 cm inlet diameter and 10 cm throat is laid horizontally in a pip to…

A: Diameter of inlet (d1) = 15cm = 0.15 m Area of inlet (A1) = Π(d1)2/4 = Π*(0.15)2/4 = 0.01766 or…

Q: In the figure, determine the distribution factor of member DC in percent. (express your answer this…

A: Given  Beam ABCD  C= roller support  D= free end

Q: For the 11 cm diameter suction pipe leading to a pump in the figure, the pressure at point A in the…

A: Given data: Suction pipe diameter=11 cm =0.11 m Pressure at point A in the suction pipe is a vacuum…

Q: 5. The horizontal pump in the Figure discharges 30°C water at 40 m'/h. Neglecting losses, what power…

A:

Q: plot the relationship between the total energy line and hydraulic gradient line Vs distance from the…

A:

Q: ) For the system in figure, the atmospheric pressure is 101.33 kPa and the absolute pressure at the…

A:

Q: 150 mm d 200 mm d 1.25 m Hg Problem 4.96 Problem 4.95 4.96. One hundred and twenty litres per second…

A: Given Discharge, Q = 120 L/s All the data is shown in the figure. Density of jet fuel JP-4 is…

Q: Q1. A rectangular water tank of length 10m and width 6m has a free surface 15m above a 300mm…

A: Given data  Cross sectional area  Length Diameter  Coefficient of discharge

Q: Question 2 b) Water flows from a large reservoir through a pipe system which consists of 200 mm…

A:

Q: 10. How can we write energy using the MLT system? a) [M][L]?[T]? b) [M]°[L]?[T]1 c) [M][L]³[T]° d)…

A: Energy= Force × Displacement E= ( MLT^-2) × ( L) E= (M L^2T^-2 )

Q: 2. In the figure shown, a liquid is pumped from reservoir A to tank B by a 12 hp pump having an…

A:

Q: The pump in the figure shown discharges water at 34.00 L/s. Neglecting losses and elevation changes,…

A: Applying Bernoulli's principle at the section 2 just at the inlet of pump and outlet of pump.  Power…

Q: Water flows through a Venturi meter at a rate of 2.12 cfs. Calculate for the change in pressure head…

A:

Q: A pump is drawing water from reservoir A to the system shown. If the velocity at point D is 2 m/s,…

A:

Q: Determine the mass of a person climbing a tree 5 meters high in 9 seconds with power of 450 joule.

A: Step 1

Q: A nozzle of inner radius 1.06 mm is connected to a hose of inner radius 9.05 mm. The nozzle shoots…

A:

Q: 50-mm inside diameter Flow 600 mm 100-mm inside diameter Water 200 What volume flow rate in gallons…

A: step 1-

Q: (67) The water tank shown is filled by pumping water from the well where the water level is located…

A:

Q: The diameter and depth of cylindrical tank are 9m and 4m respectively. This tank contains brimful of…

A: As the temperature is increased the liquid will expand(decrease in unit weight). However the weight…

Q: 5. The horizontal pump in the Figure discharges 10°C water at 35 m/h. Neglecting losses, what power…

A: Given data: Discharge,Q=35 m^3/hr Inlet Pressure,Pin=210KPa Outlet Pressure,Pout=440KPa Inlet…

Q: Given a system as shown in the following figure. Calculate the water level difference between two…

A: Given, Pipe length (L) = 15 m Diameter (D) = 30mm or 0.03m Volume flow rate (V˙) = 1 m3/h or…

Q: Example Problem in Pipe System: Water flows from a large reservoir at the rate of 1.20 ft3/s through…

A:

Q: Oil is flowing upward through a Venturi meter as shown. Assuming discharge coefficient of 0.984,…

A:

Q: A fan delivers 4m^3 of air per second at 20 degrees celsius and 1.2 bar. Assuming molecular weight…

A: Given: The volume of air is 4 m3. The temperature is 20oC. The pressure is 1.2 bar. The molecular…

Q: Typical heating values of natural gas from various parts of the U.S. are shown in the accompanying…

A: To find:- the average, variance, and standard deviation

Q: 4. The horizontal pump in the Figure discharges 13°C water at 26 m/h. Neglecting losses, what power…

A: Given that: Pressure at point 1, P1=100 kPaPressure at point 2, P2=300 kPaDiameter at section 1, d1…

Q: fluid is flowing in a 6-in diameter pipe at a pressure of 3.63 in2 with a velocity of 9.67 E. As…

A:

Q: 2. Given the figure below, solve for flow rate in the venturi meter. (C = 0.984) 2 (Ø - 250mm) oil…

A:

Q: Figure shows a lawn sprinkler with unequal arms. The jets issuing out of 40 cm the sprinkler arm of…

A:

Q: Question 12 Four light bulbs, rated at 100 W, 75 W, 50 W and 25 W each, are in parallel. What is the…

A: step 1-

Q: A nozzle of inner radius 1.04 mm is connected to a hose of inner radius 8.83 mm. The nozzle shoots…

A:

Q: 11. The velocity through a pipe of diameter 0.5 meters is 7.5 meters/sec. Total head (including…

A: given- dia of pipe d=0.5 mvelocity v=7.5 m/shead difference h=4.5 m

Q: Water flows within the rectangular channel shown with a flow of 8 m3/s. Given that the specific…

A: We are allowed to attempt only 3 sub-parts. Since the specific sub-parts are not mentioned, we are…

Q: A centrifugal pump is driven by a motor. The performance of the pump reveals the following…

A: Given:- Power input to the pump by the motor (kW):0.5, 0.7, 0.9, 1.0, 1.2Power input to the fluid by…

Q: Replacing incandescent lights with energy-efficient fluorescent lights can reduce the lighting…

A: Given data:

Asphalt Binders and Mixtures

Asphalt binders are subsidiary products procured during the refining process of petroleum while manufacturing gasoline, diesel, and similar petroleum products. Asphalt binders are obtained from the residue that remains after the distillation of petroleum, this residue is further subjected to steam distillation and oxidation to remove the traces of gas oil present in the residue. Certain additives or modifiers are also added to asphalt binders to alter them to suit different applications.