75 N.006 The tension in cable AC is 500 N. Determine the tension in cable AB and the angle 0. Match the correct answers. -610 816 1. TABX IN 41.6 2. TABY- +514 3. F- -816 4. e - 5. Not an answer +610 +541 K.

75 N.006 The tension in cable AC is 500 N. Determine the tension in cable AB and the angle 0. Match the correct answers. -610 816 1. TABX IN 41.6 2. TABY- +514 3. F- -816 4. e - 5. Not an answer +610 +541 K.

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter23: Electromagnetic Induction, Ac Circuits, And Electrical Technologies

Section: Chapter Questions

Problem 74PE: (a) What is the characteristic time constant of a 25.0 mH inductor that has a resistance of 4.00 ?...

See similar textbooks

Related questions

Q: らと2 Ry = 10 K2 %3D R3- SIOKR Rs 36X R7 =1KS2 = SK2 %3D

A: SOlution: As given in the circuit: V = 36 V Resistors in series and parallel

Q: a Rab 94, 201 $12 Fig. Q2

Q: Q13: Which is of the following units equivalent to T (Tesla)? (A) N/A.m (B) A.m/N (C) C.m/N.² (D)…

A: Question 13 solution

Q: Two cables are tied together at C and are loaded as shown. Deter- mine the tension (a) in cable AC,…

A: Solution: Given that load W =400 N

Q: c. The maximum allowable tension in cable AC is 600 N and in cable BC is 750 N (fig. 1). Determine:…

A: Consider the free-body diagram of the point C.

Q: 4. The ring of negligible size is subjected to a cylinder of 250 lb, as shown below. If the tension…

Q: 14 Parallel conductive plates are connected to the constant voltage generator as in the figure.…

Q: a)Two 2.0 m long parallel wires, P and Q are separated by a distance of 20 mm, carrying currents of…

A: Length, L = 2 mDistance, d = 0.02 m Let current be denoted by I. I1 = 5.5 AI2 = 2.2 A Note:…

Q: Find tension in AC and W? 60 10 lbs A O w = 20 b,. TAC = 17.32 b, O w = 18 Sb. TAC = 20.1 b O w =…

Q: QUESTION 6 Figure 3 shows a conducting bar PQ that can slide freely over two conducting rails. The…

Q: The average power at resonance (when Vmax=100 V , R=100 ohm) is: a-99.49W b-45.98W c-49.98W…

A: The expression for the maximum power dissipated at resonance will be,

Q: For each of the following, is W-R positive, negative, or zero? A B F ф B d A d B W- is is WA-B A B A

A: The expression of work done is given by, W=Fdcosϕ Here, F is the force, d is the distance traveled,…

Q: Q7a Cables AC and BC are attached to points A and B respectively as shown. These two cables are then…

Q: 9. What maximum current is delivered by an AC source with AV ma x = 24.0 V and f = 60 H z when…

Q: 7. Determine the power consumed (in kW) by the heating coil in the following diagram. heating coil…

Q: 2. De termine the largest W without exceeding a stress of 15 Mpa on tach wires, AR = 100 mm and Anc…

Q: Still in DC Steady State, ℰ=5 volts, R1=73 Ω, R2=87 Ω, and R3=61 Ω, and L=6 Henry. Calculate I1.

Q: A 6.0-µF air capacitor is connected to a 100-V battery. After the capacitor is fully charged, the…

Q: 6. If h goes to the right through Ri, k goes to the right through R2, and a goes to the right…

A: It is given that, I1 goes to the right through R₁, I2 goes to the right through R₂, and I3 goes to…

Q: 1) Two cables tied together at C are loaded as shown. Knowing that W = 190 lb, determine the tension…

Q: 12. A loaded zener regulator is shown in Figure 3-76. Vz = 5.1 V at Iz = 49 mA, IZK = 1 mA, Zz = 72,…

A: Given values, Vz=5.1VIz=49mAIzk=1mAZz=0 ohmsIzm=70mA

Q: 1.31 Resolve the 360-lb force into components along the cables AB and AC. Use a = 55° and ß = 30°.

Q: 13. Why is alternating current transfer more effective than dc current transfer over long distances?…

Q: RI R2 Jhe loops are abh ga I dand Loob 2- R6 ن E2 bcdhb R3 R4 feo 3 - g hdefg g abcefa acdga Rs Joop…

A: Refer the current distribution in branches as assumed next step. By KVL we have .

Q: 1. Determine the value of R, for maximum power transfer. Also, determine the maximum power. 180V( $…

Q: Two cables tied together at C and are loaded as shown. Knowing the angles of the cables as given in…

Q: 4 = 4 A Rq = 6 N ½ = 3A 3 = 1A R2 = 4 N 4 = 2 A R3 = 6N I5 = 3 A V2 RA 16 = 1A R5 = 4N Solve for V1,…

A: By kirchoff loop law in upper loop V1 - (4×6) - (1×6) - (3×4) = 0 V1 = 42 volt By kirchoff loop…

Q: xample 3.5 A go-lb load is suspended from the hook. If the load is supported by two cables and a…

A: Given - The load mass , W = 90 lb spring constant , k = 500 lb/ft Let the force in cable…

Q: 13) which of the following is the maximum amplitude that an action potential will reach? a) action…

A: Given : To choose the maximum amplitude an action potential can reach.

Q: Determine the tension developed in each wire which is needed to support the 40-lb flowerpot.(Figure…

A: Introduction: Various kinds of the motion can be described with the help of Newton's laws of motion.…

Q: B F 75 900 N The tension in cable AC is 500 N. Determine the tension in cable AB and the angle 0.

Q: In whetstone bride experiment, a student use a 60 cm stick to measure the value of Ls, he find that…

A: Given: In an experiment of Wheatstone bridge, stick length→60 cm Ls value→Ls=30 cm Rs value →Rs=100…

Q: Find tension in AC and W ? B 10 lbs w W = 20 b,. TÁC = 17.32 b W = 18 b,. TÁC = 20.1 b, W = 18.95…

Q: 5. In the following circuit, the output Y for all possible inputs A and B is expressed by the truth…

Q: The triangular block shown in Figure 206 is subjected to the loads P= 1600 KN and F= 800 KN, if AB=…

A: First, we find the angle of the block at C. In ∆ABC, Let ∠ACB = θo Now using the tan function, tan θ…

Q: Q 2. In the fra, shown below. Resolve the fore l00lb into faio Components one abng AB and the other…

Q: Find the voltage equation using Kirchhoff's loop rule for loop Lị in the figure below. R2 I3 I2 R1…

A: Here, a circuit is provided. We have to give the voltage equation using Kirchhoff's loop rule for…

Q: 1. An alternating voltage is given by v = 171.5 sin 415t volts. Find: a. The r.m.s. voltage. b. The…

A: Note- Bartleby's guidelines allowing answer only the first three subparts.

Q: The following table lists data for the speed and radius of three examples of uniform motion. Find…

A: a)The centripetal acceleration is,

Q: Q.1) For the crane shown in figure, compute the tensions in cables AC and BC A C 20°. Use sine and…

Q: Q) Rs in the DC Wheatstone Bridge, null type is adjusted to 20Ω at balance. Find Rx, when Ra = 10Ω,…

A: given: Ra = 10 ΩRb = 2.5 ΩRs=20 Ω

Q: 3. Three cables are joined at the junction ring C. Determine the tersions in cables AC and BC caused…

A: Given: The mass of the cylinder is m=30 kg. The weight of the cylinder is calculated as:…

Q: For C1=6, L1=2, R1=14000, R2=45000 & 11=0.006 A in the circuit shown belowUnder steady-state dc…

Q: B (C) 154 mA 75 A 139 mA D 2A 10V www R₁=200 ww R₂=200 R₂=500 R₁=500

Q: The generator of a car idling at 1500 rpm produces 17.4 V What will the output be at a rotation…

A: Given data:- The speed of the generator is N1 = 1500 rpm. The another speed of the generator is N2…

Q: 190 lb, determine the tension (a) in cable AC, (b) in cable BC. -12 in. 30 in- 16 in. 15 150 lb W

A: The net force on an object is given by finding the net force along each axis and then calculating…

Question

Please give handwritten

See the diagram.
B
75°
900 N
The tension in cable AC is 500 N. Determine the tension in cable AB and the angle 0.
Match the correct answers.
-610
816
1. TABX
41.6
2. TABY
IN
+514
3. F=
-816
4. 6 -
5. Not an answer
+610
+541
00

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

(a) What current flows when a 60.0 Hz, 480 V AC source is connected to a 0.250 (F capacitor? (b) What would the current be at 25.0 kHz?
(a) What is the voltage output of a transformer used for rechargeable flashlight batteries, if its primary has 500 turns, its secondary 4 turns, and the input voltage is 120 V? (b) What input current is required to produce a 4.00 A output? (c) What is the power input?
Need some assistance figuring this one out! Force F pulls upward on link A with magnitude 622N , d1 = 3.3m , d2 = 1.7m , d3 = 2.9m , d4 = 4.2m , h = 6.5m 4. What is Express cable AC as a position vector ? (rACx, rACy, rACz) 5. What is the length of cable AC ( |rAC| ) 6. What is cable AC as a unit vector ? ( uACx, uACy, uACz ) 11.What is the tension on cable AC ( TAC)
What is the current phase angle for a parallel RLC circuit when IL = 15.3 A, IC = 0.43 A, and IR = 3.5 A? A. 76.7 degrees B. –4.25 degrees C. 88.8 degrees D. –76.7 degrees
A circuit consists of a 40 Ω resistor and a690 mH inductor connected in series to a 14 Vbattery. What is the value of the current when thecurrent is increasing at the rate of 7 A/s?Answer in units of A
a)Two 2.0 m long parallel wires, P and Q are separated by a distance of 20 mm, carrying currents of 5.5 A and 2.2 A respectively in opposite directions. iii. Determine the magnitude and direction of the force exerted on the wire P. iv. Explain how to determine direction of force on wire P. b)An alternating voltage is given by ? = 340 sin 314?, where V is measured in volts and t in seconds. This voltage is supplied across a pure capacitor of 200 ??. i. Determine the rms voltage.
determine the current amplitude (I0) when the circuit elements are these: ℰ₀ = 126 volts, ω = 1.01 rad/s, R = 36 Ω, L = 14 Henries, C = 0.152 Farads.
In whetstone bride experiment, a student use a 60 cm stick to measure the value of Ls, he find that Ls=30 cm at Rs=100 ohm. Use the information above and the graph below to calculate the value of Rx?
E.) 5. A solenoid has an inductance of 1.58 mH. How many turns of wire does it have if the solenoid is 25 cm long and its radius is 2.5 cm? a. 160,000 b. 350 c. 400 d. 600
An ideal transformer has 600 turns on its primary side and 100 turns on its secondary side. The primary voltage is 1000 V AC a. What will the secondary voltage be with this configuration? b. What is the secondary current if the primary current is 100 A?
What is the true power consumed in a 30 V series RLC circuit if Z = 20 ohms and R = 10 ohms? A. 15.0 watts B. 22.5 watts C. 30.0 watts D. 45.0 watts
Figure CQ20.7 shows a slidewire generator with motional cmf 0 when the wire at A slides across the top and bottom rails at constant velocity v0. (a) When the wire reaches B so that the area enclosed by the circuit is doubled, determine the ratio of the new cmf to the original cmf, /0. (b) If the wire's speed is doubled so that v = 2v0 determine the ratio /0. Figure CQ20.7