9-27. The linkage is made of two pin-connected A-36 steelmembers, each having a cross-sectional area of 1000 mm'. Ifa vertical force of P- 250 kN is applied to point A,determine its vertical displacement at A.FO4S --45 m-|

Given Data Cross-sectional area =1000mm2=1000×10-6m=10-3m Vertical force,P=250KN Young modulus of…

Answered: 9-27. The linkage is made of two…

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.71P

See similar textbooks

Similar questions

If the 20-mm-diameter rod is made of A-36 steel and the stiffness of the spring is k = 50 MN>m, determine the displacement of end A when the 60-kN force is applied.
8-12
The assembly consists of three titanium (Ti-6A1-4V) rods and a rigid bar AC. The image shows the cross-sectional area of the assembly .If a force P= 66 kNkN is applied to the ring F, what isthe angle of tilt of bar AC measured counterclockwise from the negative y axis.
A force of 10 kN is applied to the hook. If the CB cable is made of steel (E= 200 GPa) and has a diameter of 8.5 mm, determine its displacement. Consider the distance CB shown below as the initial length.
Solve Prob. 7.29 if =0.
Please determine the change in diameter of the bar ass well as the change in lenght of the bar, if the bar is subjected to axial force of 160 KN
Segments AB and CD of the assembly are solid circular rods, and segment BC is a tube. If the assembly is made of 6061-T6 aluminum, determine the displacement of end D with respect to end A. Take b = 400 mm
Segments AB and CD of the assembly are solid circular rods, and segment BC is a tube. If the assembly is made of 6061-T6 aluminum, determine the displacement of end D with respect to end A.
The cylinder has a mass of 30 kg and is mounted on an axle that is supported by bearings at A and B. If the axle is turning at 40 rad/s (direction see figure) determine the vertical components of force acting at the bearings at this instant
The rigid bar is supported by the two short white spruce wooden posts and a spring. If each of the posts has an unloaded length of 1 m and a cross-sectional area of 600 mm2, and the spring has a stiffness of k = 2 MN >m and an unstretched length of 1.02 m, determine the vertical displacement of A and B after the load is applied to the bar.
The two shafts are made of A-36 steel. Each has a diameter of 25 mm and they are connected using the gears fixed to their ends. Their other ends are attached to fixed supports at A and B. They are also supported by journalbearings at C and D, which allow free rotation of the shafts along their axes. If a torque of 500 N # m is applied to the gear at E, determine the rotation of this gear.
The A-36 steel bar consists of two segments, one ofcircular cross section of radius r, and one of square crosssection. If the bar is subjected to the axial loading of P,determine the dimensions a of the square segment so thatthe strain energy within the square segment is the same asin the circular segment.

SEE MORE QUESTIONS

Recommended textbooks for you

International Edition---engineering Mechanics: St…

Mechanical Engineering

ISBN:

9781305501607

Author:

Andrew Pytel And Jaan Kiusalaas

Publisher:

CENGAGE L