9-5 A vertical plate 30 cm wide and 1.2 m high is maintained at 80°C and exposed to saturated steam at 1 atm. Calculate the heat transfer and the total mass of steam condensed per hour.

Q: What is the material used for the wire BC? Justify your answer

A:

Q: y 5 m 5 m A 5 m 20 kN B.

A:

Q: Find the center of gravity of the following flat, thin, homogeneous, composite objects in the…

A:

Q: 9. The gas density is 0.75 kg per cubic meters and air density is of 1.15 kg per cubic meter. If the…

A: Dear student,                      According to the expert guidelines I am allowed to answer only…

Q: The aluminum alloy designated as 5056-H28 means the following: this is a non-heat-treatable alloy of…

A: Aluminum alloy can be obtained by mixing the different elements with aluminum to obtain the…

Q: For the air duct shown below, if the total pressure of air is 250 kPa and the static pressure is 50…

A:

Q: 23 Find the ditferential equation from the transfer of the function for the Givin following system…

A:

Q: Fig3-1,gear 4 rolls on fixed rack 5 without slipping. Determine ratio /w, fo 4 3 F OD 1 n E

A:

Q: calculate the leakage mass flow rate per unit area from the first ring pack plenum to the cylinder…

A: Given                    Temperature, T = 450 K Coefficient of discharge, C = 0.75…

Q: A steam at 169.06 kPa of 90% quality is used to concentrate tomato juice to puree. The specific…

A: Given that, Pressure of steam, P=169.06 kPa,Quality of steam, x=90 %,Specific heat of tomato juice…

Q: ı dont understand

A:

Q: A steel band 8mm thick is to be pulled on to a cylinder 30cm in diameter. The internal diameter of…

A:

Q: So 180 200 30 Find F and location 200

A:

Q: 4-Sulfur compounds pollute the environment, limit machinery life, damage pipelines, machines, and…

A: This question is based on the concept of properties of fuel in IC engine and its effects on…

Q: 5- An air-standard Diesel cycle has a compression ratio of 19. Air is at 130°F and 14.7 psia at the…

A:

Q: Use modal analysis to calculate the response of the drive train system of Problem 4.44  given by the…

A: Given : To find : Modal analysis

Q: 17-The temperature, pressure, and chemical content of crude oil all influence how viscosity changes.…

A: This question is based on the properties of crude oil and effects of temperature pressure and…

Q: For the given beam with shown loading, determine the reaction at the ro. support. 20 kips/ft B A

A: Given     Load, P = 20 kips/ft  Length, L = 8 ft Find   Reaction at roller support, R2

Q: 3- What are the reason for painting the tank with silver .

A: Silver and white colors are good reflector of heat and prevent the temperature rise of fuel inside…

Q: Hydraulics.   Derive the formula of Upper not down.

A: In this problem, we have to derive the height of liquid in a spherical container which has a…

Q: 9-88 A simple ideal Brayton cycle operates with air with minimum and maximum temperatures of 27°C…

A:

Q: Turbine work in MW b. Heat rejected from the condenser in MW

A: @1Mpa 300 C , h = 3051.6  kJ/Kg K @ 500 KPa Saturated Vapor enthalpy = 2748.1 kJ/KgK

Q: Idler (massless) pulley m 2k I, 2m Fig (A) Fig (B) m4 K k2. kJ2 C,G m3 m 1/2 k/2. k2 m2 m, k2. ka/2…

A: The Degree of freedom is equal to the number of independent variables in the system in order to…

Q: Q1. An SI engine operating at 1200 rpm has a 10.2 cm bore with the spark plug offset by 6 mm from…

A:

Q: What are the importance of Ceramics in Engineering? Give some examples

A: Ceramics : Ceramics are the materials which is inorganic and nonmetallic materials that are…

Q: motor body is 360 mm in diameter (outside) and 240 mm long. Its surface temperature should not…

A: The fin is thin and long enough so that heat loss from the tip is negligible. All the heat is…

Q: A rotating cylinder viscometer is used to measure the viscosity of fluids. The viscometer we are…

A: Answer: The viscosity of the fluid: 3.75 cP ( 0.00375 N•s/m2 )

Q: 2. Show which kind of the double-pipe heat exchanger exchange more heat between the hot and cold…

A:

Q: Increasing the frequency of the supply will: O Decrease the rotor speed at a certain load torque.…

A: INTRODUCTION : Induction motors are used on circuits with different voltages or frequencies than…

Q: Determine the moment of inertia with respect to the x axis for the circular area shown in Fig.…

A:

Q: L Reviev Learning Goal: To determine the angle of twist for a circular shaft that is composed of…

A: Solution - Given data - P =220.0 hp              ω =1800 rpma =7.750 in               b=12.00inc…

Q: The uniform concrete slab has a mass of 2900 kg. The slab is held in the horizontal plane by three…

A: given data :- mass of slab= 2900 kg Force F = 17 kN find the tension in each cable.

Q: Calculate the maximum moment in a 40-foot simply supported beam due to the following axle loads: 24k…

A:

Q: A 10-kg package drops from a chute into a 25-kg cart with a velocity of 3 m/s. Knowing that the cart…

A:

Q: A hockey puck is traveling to the left with a velocity of v, = 12 m/s when it is struck by a hockey…

A:

Q: a) The principal stresses for the given stress tensors. b) The directions of principal stresses. Г18…

A: For solution refer below images.

Q: The shaft shown consists of a 3-in diameter aluminum segment that is rigidly joined to a 2-in…

A: Given   Diameter aluminum, da = 3 in            Diameter steel, ds = 2 in…

Q: Question 2: y Determine the moment of inertia for the area shown in the figure beside about y = 2x…

A:

Q: The state of stress at a point is shown on the element. Determine (a) the principal stress and (b)…

A:

Q: What thrust is obtained from a propeller 3 m in diameter that has the characteristics given in the…

A: Given: Diameter of the propeller (D) = 3 m Propeller rotation speed (n) = 1400 rpm = (1400/60)…

Q: Explain how to increase the coefficient of performance of a single stage vapour compression system.…

A:

Q: For the cantilever beam with shown loading, determine the deflection at the free end. (E = 200 GPa;1…

A:

Q: 9- Crude oils with a large volume of issolved gases are less dense, light in eight, and have high…

A: Yes, it is true.

Q: motion to a roller follower: raise 50 mm with uniform motion for 120 deg, dwell for 30 deg, return…

A:

Q: Find the velocity profile of the fluid if the fluid is Newtonian, incompresible and the pressure…

A: Given : To find : Velocity profile

Q: Air at 30 °C and 110 kPa flows at 20 N/s through a rectangular duct that measure 160 mm x 320 mm.…

A: Given data Air temperature = 30°C = 30 + 273 = 303 K Air pressure = 110 kPa  Flow rate = 20 N/s…

Q: 2-ton trailer truck travels down a road with slope 0.2 with a speed of 20 kph. If the truck driver…

A:

Q: 1-23.Determine the length of side C of the triangle shown in Figure P1-23.

A:

Q: Are these equations valid only for ideal fluids or they are also valid for non-ideal fluids? Explain…

A:

Q: The system is made up of the 1-m, 5.4-kg uniform rod AB and the two uniform disks (each of 0.20 m…

A:

Fire safety

Fire safety is a new domain emerged in the early 90s to enable the design of buildings, structures, and infrastructure against destruction through fire. It also includes the provisions of building codes. This field is mostly associated with the design and efficient planning of a building, to reduce the destruction caused by fire. The branch of engineering that deals with it for the safety of the buildings from destruction of fire, is known as fire safety engineering.