9) A simple pendulum of length L is set to oscillate in simple harmonic motion. When its potential energy is one-half its total mechanical energy, U = E/2, then which of the following is true about its velocity: (aly = trmau (?

9) A simple pendulum of length L is set to oscillate in simple harmonic motion. When its potential energy is one-half its total mechanical energy, U = E/2, then which of the following is true about its velocity: (aly = trmau (?

Name: 9) A simple pendulum of length L is set to oscillate in simple harmon
Uploaded: 2024-03-20T06:58:04.000Z
Channel: Bartleby
Description: 9) A simple pendulum of length L is set to oscillate in simple harmonic motion. When its potential energyis one-half its total mechanical energy, U = E/2, then which of the following is true about its velocity:= tvmax/2(b)v = tvmax/4I Ov= tvmaxV2/2(

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter13: Vibrations And Waves

Section: Chapter Questions

Problem 35P: A simple pendulum has a length of 52.0 cm and makes 82.0 complete oscillations in 2.00 min. Find (a)...

See similar textbooks

Similar questions

Show that the time rate of change of mechanical energy for a damped, undriven oscillator is given by dE/dt = bv2 and hence is always negative. To do so, differentiate the expression for the mechanical energy of an oscillator, E=12mv2+12kx2, and use Equation 15.51.
If a simple pendulum oscillates with small amplitude and its length is doubled, what happens to the frequency of its motion? (a) It doubles. (b) It becomes 2 times as large. (c) It becomes half as large. (d) It becomes 1/2 times as large. (e) It remains the same.
A 500-kg object attached to a spring with a force constant of 8.00 N/m vibrates in simple harmonic motion with an amplitude of 10.0 cm. Calculate the maximum value of its (a) speed and (b) acceleration, (c) the speed and (d) the acceleration when the object is 6.00 cm from the equilibrium position, and (e) the time interval required for the object to move from x = 0 to x = 8.00 cm.
If the amplitude of a damped oscillator decreases to 1/e of its initial value after n periods, show that the frequency of the oscillator must be approximately [1 − (8π2n2)−1] times the frequency of the corresponding undamped oscillator.
Show that angular frequency of a physical pendulum phy=mgrCM/I (Eq. 16.33) equals the angular frequency of a simple pendulum smp=g/, (Eq. 16.29) in the case of a particle at the end of a string of length .
The amplitude of a lightly damped oscillator decreases by 3.0% during each cycle. What percentage of the mechanical energy of the oscillator is lost in each cycle?
When a block of mass M, connected to the end of a spring of mass ms = 7.40 g and force constant k, is set into simple harmonic motion, the period of its motion is T=2M+(ms/3)k A two-part experiment is conducted with the use of blocks of various masses suspended vertically from the spring as shown in Figure P15.76. (a) Static extensions of 17.0, 29.3, 35.3, 41.3, 47.1, and 49.3 cm are measured for M values of 20.0, 40.0, 50.0, 60.0, 70.0, and 80.0 g, respectively. Construct a graph of Mg versus x and perform a linear least-squares fit to the data. (b) From the slope of your graph, determine a value for k for this spring. (c) The system is now set into simple harmonic motion, and periods are measured with a stopwatch. With M = 80.0 g, the total time interval required for ten oscillations is measured to be 13.41 s. The experiment is repeated with M values of 70.0, 60.0, 50.0, 40.0, and 20.0 g, with corresponding time intervals for ten oscillations of 12.52, 11.67, 10.67, 9.62, and 7.03 s. Make a table of these masses and times. (d) Compute the experimental value for T from each of these measurements. (e) Plot a graph of T2 versus M and (f) determine a value for k from the slope of the linear least-squares fit through the data points. (g) Compare this value of k with that obtained in part (b). (h) Obtain a value for ms from your graph and compare it with the given value of 7.40 g.
An object of mass m moves in simple harmonic motion with amplitude 12.0 cm on a light spring. Its maximum acceleration is 108 cm/s2. Regard m as a variable. (a) Find the period T of the object. (b) Find its frequency f. (c) Find the maximum speed vmax of the object. (d) Find the total energy E of the objectspring system. (e) Find the force constant k of the spring. (f) Describe the pattern of dependence of each of the quantities T, f, vmax, E, and k on m.
A 1.00-kg glider attached to a spring with a force constant of 25.0 N/m oscillates on a frictionless, horizontal air track. At t = 0, the glider is released from rest at x = 3.00 cm (that is, the spring is compressed by 3.00 cm). Find (a) the period of the gliders motion, (b) the maximum values of its speed and acceleration, and (c) the position, velocity, and acceleration as functions of time.
A 200-g block is attached to a horizontal spring and executes simple harmonic motion with a period of 0.250 s. The total energy of the system is 2.00 J. Find (a) the force constant of the spring and (b) the amplitude of the motion.
A simple pendulum has a length of 52.0 cm and makes 82.0 complete oscillations in 2.00 min. Find (a) the period of the pendulum and (b) the value of g at the location of the pendulum.
Which of the following statements is not true regarding a massspring system that moves with simple harmonic motion in the absence of friction? (a) The total energy of the system remains constant. (b) The energy of the system is continually transformed between kinetic and potential energy. (c) The total energy of the system is proportional to the square of the amplitude. (d) The potential energy stored in the system is greatest when the mass passes through the equilibrium position. (e) The velocity of the oscillating mass has its maximum value when the mass passes through the equilibrium position.